Position measurements for the isotope production facility and the switchyard kicker upgrade projects

The Los Alamos Neutron Science Center (LANSCE) is installing two beam lines to both improve operational tuning and provide new capabilities within the facility. The Isotope Production Facility (IPF) will provide isotopes for medical purposes by using the H' beam spur at 100 MeV and the Switchyard Kicker Upgrade (SYK) will allow the LANSCE 800-MeV H beam to be rapidly switched between various beam lines within the facility. The beam position measurements for both of these beam lines uses a standard micro-stripline beam position monitor (BPM) with both a 50-mm and 75-mm radius. The cable plant is unique in that it unambiguously provides a method of verifying the operation of the complete position measurement. The processing electronics module uses a log ratio technique with error corrections such that it has a dynamic range of -12 dBm to -85 dBm with errors less than 0.15 dB within this range. This paper will describe the primary components of these measurement systems and provide initial data of their operation

ANALOG FRONT-END ELECTRONICS FOR BEAM POSITION MEASUREMENT ON THE BEAM HALO MEASUREMENT

Enhancements have been made to the log-ratio analog front-end electronics based on the Analog Devices 8307 logarithmic amplifier as used on the LEDA accelerator. The dynamic range of greater than 85 dB, has been extended to nearly the full capability of the AD8307 from the previous design of approximately 65 dB through the addition of a 350 MHz band-pass filter, careful use of ground and power plane placement, signal routing, and power supply bypassing. Additionally, selection of high-isolation RF switches (55dB) has been an integral part of a new calibration technique, which is fully described in another paper submitted to this conference. Provision has also been made for insertion of a first-stage low-noise amplifier for using the circuit under low-signal conditions

EXPERIENCE WITH THE LOW ENERGY DEMONSTRATION ACCELERATOR (LEDA) HALO EXPERIMENT BEAM INSTRUMENTATION

A 52 quadrupole-magnet FODO lattice has been assembled and operated at the Los Alamos National Laboratory. The purpose of this lattice is to provide a platform to measure the resulting beam halo as the first few magnets of the lattice produce various mismatch conditions. These data are then compared with particle simulation so that halo formation mechanisms may be better understood. The lattice is appended to the LEDA 6.7-MeV radio frequency quadrupole (RFQ) and is followed by a short high-energy beam transport (HEBT) that safely dumps the beam into a 670-kW beam stop