87,555 research outputs found
Detection of a single-charge defect in a metal-oxide-semiconductor structure using vertically coupled Al and Si single-electron transistors
An Al-AlO_x-Al single-electron transistor (SET) acting as the gate of a
narrow (~ 100 nm) metal-oxide-semiconductor field-effect transistor (MOSFET)
can induce a vertically aligned Si SET at the Si/SiO_2 interface near the
MOSFET channel conductance threshold. By using such a vertically coupled Al and
Si SET system, we have detected a single-charge defect which is tunnel-coupled
to the Si SET. By solving a simple electrostatic model, the fractions of each
coupling capacitance associated with the defect are extracted. The results
reveal that the defect is not a large puddle or metal island, but its size is
rather small, corresponding to a sphere with a radius less than 1 nm. The small
size of the defect suggests it is most likely a single-charge trap at the
Si/SiO_2 interface. Based on the ratios of the coupling capacitances, the
interface trap is estimated to be about 20 nm away from the Si SET.Comment: 5 pages and 5 figure
Coulomb blockade in a Si channel gated by an Al single-electron transistor
We incorporate an Al-AlO_x-Al single-electron transistor as the gate of a
narrow (~100 nm) metal-oxide-semiconductor field-effect transistor (MOSFET).
Near the MOSFET channel conductance threshold, we observe oscillations in the
conductance associated with Coulomb blockade in the channel, revealing the
formation of a Si single-electron transistor. Abrupt steps present in sweeps of
the Al transistor conductance versus gate voltage are correlated with
single-electron charging events in the Si transistor, and vice versa. Analysis
of these correlations using a simple electrostatic model demonstrates that the
two single-electron transistor islands are closely aligned, with an
inter-island capacitance approximately equal to 1/3 of the total capacitance of
the Si transistor island, indicating that the Si transistor is strongly coupled
to the Al transistor.Comment: 3 pages, 4 figures, 1 table; typos corrected, minor clarifications
added; published in AP
Recommended from our members
Preparation and Properties of In-Situ Devices Using the SALD and SALDVI Techniques
One of the many advantages of Selective Area Laser Deposition (SALD) and Selective
Area Laser Deposition Vapor Infiltration (SALDVI) is that they can be used to embed in-situ
micro-sensors within macro-components. A single-point SiC/C thermocouple sensor embedded
within a SiC macro-component and electrically insulated with silicon nitride layers has been
demonstrated. In many applications, multi-point sensors within a single component are needed,
e.g., in monitoring the temperature gradient and distribution at different positions. In this paper,
multi-point thermocouple devices are demonstrated. The macro-component is a SiC bulk shape
made by infiltrating vapor deposited silicon carbide into a silicon carbide powder bed using the
SALDVI technique. Multiple SiC/C thermocouples are embedded in-situ in the SiC bulk shape
using the SALD technique. The transient and steady state responses ofthe embedded
thermocouples are compared to reference thermocouples probing the surfaces of the bulk shape.Mechanical Engineerin
Distribution of extremes in the fluctuations of two-dimensional equilibrium interfaces
We investigate the statistics of the maximal fluctuation of two-dimensional
Gaussian interfaces. Its relation to the entropic repulsion between rigid walls
and a confined interface is used to derive the average maximal fluctuation and the asymptotic behavior of the whole
distribution for finite with and the interface size and
tension, respectively. The standardized form of does not depend on
or , but shows a good agreement with Gumbel's first asymptote distribution
with a particular non-integer parameter. The effects of the correlations among
individual fluctuations on the extreme value statistics are discussed in our
findings.Comment: 4 pages, 4 figures, final version in PR
Binomial coefficients, Catalan numbers and Lucas quotients
Let be an odd prime and let be integers with and . In this paper we determine
mod for ; for example,
where is the Jacobi symbol, and is the Lucas
sequence given by , and for
. As an application, we determine modulo for any integer , where denotes the
Catalan number . We also pose some related conjectures.Comment: 24 pages. Correct few typo
Sizes and Kinematics of Extended Narrow-Line Regions in Luminous Obscured AGN Selected by Broadband Images
To study the impact of active galactic nuclei (AGN) feedback on the galactic
ISM, we present Magellan long-slit spectroscopy of 12 luminous nearby type 2
AGN (L_bol~10^{45.0-46.5} erg/s, z~0.1). These objects are selected from a
parent sample of spectroscopically identified AGN to have high
[OIII]{\lambda}5007 and WISE mid-IR luminosities and extended emission in the
SDSS r-band images, suggesting the presence of extended [OIII]{\lambda}5007
emission. We find spatially resolved [OIII] emission (2-35 kpc from the
nucleus) in 8 out of 12 of these objects. Combined with samples of higher
luminosity type 2 AGN, we confirm that the size of the narrow-line region
(R_NLR) scales with the mid-IR luminosity until the relation flattens at ~10
kpc. Nine out of 12 objects in our sample have regions with broad [OIII]
linewidths (w_80>600 km/s), indicating outflows. We define these regions as the
kinematically-disturbed region (KDR). The size of the KDR (R_KDR) is typically
smaller than R_NLR by few kpc but also correlates strongly with the AGN mid-IR
luminosity. Given the unknown density in the gas, we derive a wide range in the
energy efficiency {\eta}=dot{E}/L_bol=0.01%-30%. We find no evidence for an AGN
luminosity threshold below which outflows are not launched. To explain the
sizes, velocity profiles, and high occurrence rates of the outflows in the most
luminous AGN, we propose a scenario in which energy-conserving outflows are
driven by AGN episodes with ~10^8-year durations. Within each episode the AGN
flickers on shorter timescales, with a cadence of ~10^6 year active phases
separated by ~10^7 years.Comment: 32 pages, 21 figures, ApJ in revie
Electrically driven magnetism on a Pd thin film
Using first-principles density functional calculations we demonstrate that
ferromagnetism can be induced and modulated on an otherwise paramagnetic Pd
metal thin-film surface through application of an external electric field. As
free charges are either accumulated or depleted at the Pd surface to screen the
applied electric field there is a corresponding change in the surface density
of states. This change can be made sufficient for the Fermi-level density of
states to satisfy the Stoner criterion, driving a transition locally at the
surface from a paramagnetic state to an itinerant ferromagnetic state above a
critical applied electric field, Ec. Furthermore, due to the second-order
nature of this transition, the surface magnetization of the ferromagnetic state
just above the transition exhibits a substantial dependence on electric field,
as the result of an enhanced magnetoelectric susceptibility. Using a linearized
Stoner model we explain the occurrence of the itinerant ferromagnetism and
demonstrate that the magnetic moment on the Pd surface follows a square-root
variation with electric field consistent with our first-principles
calculations.Comment: 8 pages, 7 figure
Molecular production at a wide Feshbach resonance in Fermi-gas of cooled atoms
The problem of molecular production from degenerate gas of fermions at a wide
Feshbach resonance, in a single-mode approximation, is reduced to the linear
Landau-Zener problem for operators. The strong interaction leads to significant
renormalization of the gap between adiabatic levels. In contrast to static
problem the close vicinity of exact resonance does not play substantial role.
Two main physical results of our theory is the high sensitivity of molecular
production to the initial value of magnetic field and generation of a large BCS
condensate distributed over a broad range of momenta in inverse process of the
molecule dissociation.Comment: 4 pages, no figure
A Millikelvin Scanned Probe for Measurement of Nanostructures
We demonstrate a scanning force microscope, based upon a quartz tuning fork,
that operates below 100 mK and in magnetic fields up to 6 T. The microscope has
a conducting tip for electrical probing of nanostructures of interest, and it
incorporates a low noise cryogenic amplifier to measure both the vibrations of
the tuning fork and the electrical signals from the nanostructures. At
millikelvin temperatures the imaging resolution is below 1 um in a 22 um x 22
um range, and a coarse motion provides translations of a few mm. This scanned
probe is useful for high bandwidth measurement of many high impedance
nanostructures on a single sample. We show data locating an SET within an array
and measure its coulomb blockade with a sensitivity of 2.6 x 10^-5 e/Hz^1/2.Comment: 5 pages, 5 figures, submitted to RS
- …