Observation of Precipitation Evolution in Fe-Ni-Mn-Ti-Al Maraging Steel by Atom Probe Tomography

We describe the full decomposition sequence in an Fe-Ni-Mn-Ti-Al maraging steel during isothermal annealing at 550 °C. Following significant pre-precipitation clustering reactions within the supersaturated martensitic solid solution, (Ni,Fe)3Ti and (Ni,Fe)3(Al,Mn) precipitates eventually form after isothermal aging for ~60 seconds. The morphology of the (Ni,Fe)3Ti particles changes gradually during aging from predominantly plate-like to rod-like, and, importantly, Mn and Al were observed to segregate to these precipitate/matrix interfaces. The (Ni,Fe)3(Al,Mn) precipitates occurred at two main locations: uniformly within the matrix and at the periphery of the (Ni,Fe)3Ti particles. We relate this latter mode of precipitation to the Mn-Al segregation

Postoperative complications after procedure for prolapsed hemorrhoids (PPH) and stapled transanal rectal resection (STARR) procedures

Procedure for prolapsing hemorrhoids (PPH) and stapled transanal rectal resection for obstructed defecation (STARR) carry low postoperative pain, but may be followed by unusual and severe postoperative complications. This review deals with the pathogenesis, prevention and treatment of adverse events that may occasionally be life threatening. PPH and STARR carry the expected morbidity following anorectal surgery, such as bleeding, strictures and fecal incontinence. Complications that are particular to these stapled procedures are rectovaginal fistula, chronic proctalgia, total rectal obliteration, rectal wall hematoma and perforation with pelvic sepsis often requiring a diverting stoma. A higher complication rate and worse results are expected after PPH for fourth-degree piles. Enterocele and anismus are contraindications to PPH and STARR and both operations should be used with caution in patients with weak sphincters. In conclusion, complications after PPH and STARR are not infrequent and may be difficult to manage. However, if performed in selected cases by skilled specialists aware of the risks and associated diseases, some complications may be prevented

Towards the design of antiviral inhibitors against flaviviruses: The case for the multifunctional NS3 protein from Dengue virus as a target

10.1016/j.antiviral.2008.07.001Antiviral Research80294-101ARSR

Rapid determination of protein stability and ligand binding by differential scanning fluorimetry of GFP-tagged proteins

10.1039/c2ra22368fRSC Advances23111892-1190

Flexibility of NS5 methyltransferase-polymerase linker region is essential for dengue virus replication

10.1128/JVI.01239-15Journal of Virology892010717-1072

A Crystal Structure of the Dengue Virus NS5 Protein Reveals a Novel Inter-domain Interface Essential for Protein Flexibility and Virus Replication

10.1371/journal.ppat.1004682PLoS ONE113e100468

Effect of aging and deformation on the microstructure and properties of Fe-Ni-Ti maraging steel

The age-hardening behavior of Fe−25.3Ni−1.7 Ti (wt pct) alloy both in undeformed specimens and in specimens cold deformed by 10 or 20 pct prior to aging was studied. The microstructural changes during aging were observed using transmission electron microscopy (TEM) and atom probe analysis and there were related to the mechanical properties as measured by microhardness and shear punch testing. An excellent combination of hardness, strength, and ductility was achieved after only 5 seconds aging at 550°C. We propose that this rapid strengthening is due to a dislocation friction effect arising from the formation of a fine dispersion of Ni−Ti atomic co-clusters during this short aging time. The concomitant effects of a reverse transformation of martensite to austenite during aging and a gradual increase in both size of the clusters and distance between them contributed to a decrease in strength after aging for 15 seconds. This decline proceeded until aging for 300 seconds and was followed by a secondary hardening reaction toward peak hardness (at 10,800 seconds) and subsequent overaging. This secondary hardening was associated with fine-scale precipitation of Ni3Ti and this process was accelerated by deformation prior to aging, leading to a reduction or elimination of hardness decline after the initial cluster hardening