Measuring the quality factor of a microwave cavity using superconduting qubit devices

We propose a method to create superpositions of two macroscopic quantum states of a single-mode microwave cavity field interacting with a superconducting charge qubit. The decoherence of such superpositions can be determined by measuring either the Wigner function of the cavity field or the charge qubit states. Then the quality factor Q of the cavity can be inferred from the decoherence of the superposed states. The proposed method is experimentally realizable within current technology even when the $Q$ value is relatively low, and the interaction between the qubit and the cavity field is weak.Comment: 8 page

Object Picture of Quasinormal Modes for Stringy Black Holes

We study the quasinormal modes (QNMs) for stringy black holes. By using numerical calculation, the relations between the QNMs and the parameters of black holes are minutely shown. For (1+1)-dimensional stringy black hole, the real part of the quasinormal frequency increases and the imaginary part of the quasinormal frequency decreases as the mass of the black hole increases. Furthermore, the dependence of the QNMs on the charge of the black hole and the flatness parameter is also illustrated. For (1+3)-dimensional stringy black hole, increasing either the event horizon or the multipole index, the real part of the quasinormal frequency decreases. The imaginary part of the quasinormal frequency increases no matter whether the event horizon is increased or the multipole index is decreased.Comment: 4 pages, 5 figure

Long-term spatial and temporal variation of CO2 partial pressure in the Yellow River, China

10.5194/bg-12-921-2015Biogeosciences124921-93

Thickness dependence of the properties of epitaxial MgB2 thin films grown by hybrid physical-chemical vapor deposition

We have studied the effect of deposition rate and layer thickness on the properties of epitaxial MgB2 thin films grown by hybrid physical-chemical vapor deposition on 4H-SiC substrates. The MgB2 film deposition rate depends linearly on the concentration of B2H6 in the inlet gas mixture. We found that the superconducting and normal-state properties of the MgB2 films are determined by the film thickness, not by the deposition rate. When the film thickness was increased, the transition temperature, Tc, increased and the residual resistivity, rho0, decreased. Above about 300 nm, a Tc of 41.8 K, a rho0 of 0.28 mikroOhm.cm, and a residual resistance ratio RRR of over 30 were obtained. These values represent the best MgB2 properties reported thus far.Comment: 10 pages, 4 figure

Critical Current Density and Resistivity of MgB2 Films

The high resistivity of many bulk and film samples of MgB2 is most readily explained by the suggestion that only a fraction of the cross-sectional area of the samples is effectively carrying current. Hence the supercurrent (Jc) in such samples will be limited by the same area factor, arising for example from porosity or from insulating oxides present at the grain boundaries. We suggest that a correlation should exist, Jc ~ 1/{Rho(300K) - Rho(50K)}, where Rho(300K) - Rho(50K) is the change in the apparent resistivity from 300 K to 50 K. We report measurements of Rho(T) and Jc for a number of films made by hybrid physical-chemical vapor deposition which demonstrate this correlation, although the "reduced effective area" argument alone is not sufficient. We suggest that this argument can also apply to many polycrystalline bulk and wire samples of MgB2.Comment: 11 pages, 3 figure

Geometric entanglement from matrix product state representations

An efficient scheme to compute the geometric entanglement per lattice site for quantum many-body systems on a periodic finite-size chain is proposed in the context of a tensor network algorithm based on the matrix product state representations. It is systematically tested for three prototypical critical quantum spin chains, which belong to the same Ising universality class. The simulation results lend strong support to the previous claim [Q.-Q. Shi, R. Or\'{u}s, J. O. Fj{\ae}restad, and H.-Q. Zhou, New J. Phys \textbf{12}, 025008 (2010); J.-M. St\'{e}phan, G. Misguich, and F. Alet, Phys. Rev. B \textbf{82}, 180406R (2010)] that the leading finite-size correction to the geometric entanglement per lattice site is universal, with its remarkable connection to the celebrated Affleck-Ludwig boundary entropy corresponding to a conformally invariant boundary condition.Comment: 4+ pages, 3 figure

A New Method to Calculate Electromagnetic Impedance Matching Degree in One-Layer Microwave Absorbers

A delta-function method was proposed to quantitatively evaluate the electromagnetic impedance matching degree. Measured electromagnetic parameters of {\alpha}-Fe/Fe3B/Y2O3 nanocomposites are applied to calculate the matching degree by the method. Compared with reflection loss and quarter-wave principle theory, the method accurately reveals the intrinsic mechanism of microwave transmission and reflection properties. A possible honeycomb structure with promising high-performance microwave absorption according to the method is also proposed.Comment: 13 pages, 3 figure