Investigation of critical burning of fuel droplets

The steady combustion characteristics of droplets were considered in combustion chamber environments at various pressures, flow conditions, and ambient oxidizer concentrations for a number of hydrocarbon fuels. Using data obtained earlier, predicted gasification rates were within + or - 30% of measurements when the correction for convection was based upon average properties between the liquid surface and the flame around the droplet. Analysis was also completed for the open loop response of monopropellant droplets, based upon earlier strand combustion results. At the limit of large droplets, where the effect of flame curvature is small, the results suggest sufficient response to provide a viable mechanism for combustion instability in the frequency and droplet size range appropriate to practical combustors. Calculations are still in progress for a broader range of droplet sizes, including conditions where active combustion effects are small

Investigation of critical burning of fuel droplets

Steady and unsteady combustion of liquid fuel droplets under rocket engine conditions was analyzed. Emphasis was placed on combustion at elevated pressures and temperatures. The results and their technical application to the design of liquid fueled rocket engines and the determination of combustion instability characteristics of these engines were summarized

Bipropellant droplet burning rates and lifetimes in a combustion gas environment

Liquid rocket propellant droplet burning rate and lifetimes in combustion chambe

Oscillatory combustion of liquid monopropellant droplets

A theoretical investigation was conducted on the open-loop combustion response of monopropellant droplets and sprays to imposed pressure oscillations. The theoretical model was solved as a perturbation analysis through first order, yielding linear response results. Unsteady gas phase effects were considered in some cases, but the bulk of the calculations assumed a quasi-steady gas phase. Calculations were conducted using properties corresponding to hydrazine decomposition. Zero-order results agreed with earlier measurements of hydrazine droplet burning in combustion gases. The droplet response was greatest (exceeding unity in some cases) for large droplets with liquid phase temperature gradients; at frequencies near the characteristic frequency of the liquid phase thermal wave. The response of a spray is less than that of its largest droplet, however, a relatively small percentage of large droplets provides a substantial response (exceeding unity in some cases)

Investigation of air solubility in jet A fuel at high pressures

The solubility and density properties of saturated mixtures of fuels and gases were measured. The fuels consisted of Jet A and dodecane, the gases were air and nitrogen. The test range included pressures of 1.03 to 10.34 MPa and temperatures of 298 to 373 K. The results were correlated successfully, using the Soave equation of state. Over this test range, dissolved gas concentrations were roughly proportional to pressure and increased slightly with increasing temperature. Mixture density was relatively independent of dissolved gas concentration

Predictions of spray combustion interactions

Mean and fluctuating phase velocities; mean particle mass flux; particle size; and mean gas-phase Reynolds stress, composition and temperature were measured in stationary, turbulent, axisymmetric, and flows which conform to the boundary layer approximations while having well-defined initial and boundary conditions in dilute particle-laden jets, nonevaporating sprays, and evaporating sprays injected into a still air environment. Three models of the processes, typical of current practice, were evaluated. The local homogeneous flow and deterministic separated flow models did not provide very satisfactory predictions over the present data base. In contrast, the stochastic separated flow model generally provided good predictions and appears to be an attractive approach for treating nonlinear interphase transport processes in turbulent flows containing particles (drops)

Structure of Evaporating and Combusting Sprays: Measurements and Predictions

Complete measurements of the structure of nonevaporating, evaporating and combusting sprays for sufficiently well defined boundary conditions to allow evaluation of models of these processes were obtained. The development of rational design methods for aircraft combustion chambers and other devices involving spray combustion were investigated. Three methods for treating the discrete phase are being considered: a locally homogeneous flow (LHF) model, a deterministic separated flow (DSF) model, and a stochastic separated flow (SSF) model. The main properties of these models are summarized

Investigation of Critical Burning of Fuel Droplets

An earlier analysis for the combustion response of a liquid monopropellant strand (hydrazine) was extended to consider individual droplets and sprays. While small drops gave low or negative response, large droplets provided response near unity at low frequencies, with the response declining at frequencies greater than the characteristic liquid phase frequency. Temperature gradients in the liquid phase resulted in response peaks greater than unity. A second response peak was found for large drops which corresponded to gas phase transient effects. Spray response was generally reduced from the response of the largest injected droplet, however, even a small percentage of large droplets can yield appreciable response. An apparatus was designed and fabricated to allow observation of bipropellant fuel spray combustion at elevated pressures. A locally homogeneous model was developed to describe this combustion process which allows for high pressure phenomena associated with the thermodynamic critical point

The investigation of critical pressure burning of fuel droplets Annual report, 1 Jan. - 31 Dec. 1970

Experimental and theoretical results of critical pressure burning of fuel droplet