3 research outputs found
Titanium additions to MgB2 conductors
A series of doping experiments are reported for MgB2 conductors that have
been synthesized using doped boron fibers prepared by chemical vapor
deposition(CVD) methods. Undoped MgB2 samples prepared from CVD prepared fibers
consistently give critical current densities, Jc, in the range of 500,000
A/cm^2 in low field at 5K. These values fall by a factor of about 100 as the
magnetic field increases to 3T. For heavily Ti-doped boron fibers where the
B/Ti ratio is comparable to 1, there is a substantial suppression of both Tc,
superconducting volume fraction, and Jc values. If, however, a sample with a
few percent Ti in B is deposited on a carbon coated SiC substrate and reacted
at 1100 degrees C for 15 min, then Tc is suppressed only a couple of degrees
Kelvin and critical current densities are found to be approximately 2-5 x 10^6
A/cm^2 for superconducting layers ranging from 4-10 micrometers thick. These
materials show Jc values over 10,000 A/cm^2 at 25K and 1.3 T.Comment: 10 pages, 6 figure
Superconductivity in MgB_2 doped with Ti and C
Measurements of the superconducting upper critical field, H_{c2}, and
critical current density, J_c, have been carried out for MgB_2 doped with Ti
and/or C in order to explore the problems encountered if these dopants are used
to enhance the superconducting performance. Carbon replaces boron in the MgB_2
lattice and apparently shortens the electronic mean free path thereby raising
H_c2. Titanium forms precipitates of either TiB or TiB_2 that enhance the flux
pinning and raise J_c. Most of these precipitates are intra-granular in the
MgB_2 phase. If approximately 0.5% Ti and approximately 2% C are co-deposited
with B to form doped boron fibers and these fibers are in turn reacted in Mg
vapor to form MgB_2, the resulting superconductor has H_{c2}(T=0) ~ 25 T and
J_c ~ 10,000 A/cm**2 at 5 K and 2.2 T.Comment: 11 pages, 10 figure