Analysis of QTL for high grain protein content in Canadian durum wheat

Non-Peer ReviewedDurum wheat (Triticum turgidum L. var. durum) varieties with high grain protein concentration (GPC) produce pasta products with greater cooking firmness and increased tolerance to overcooking. However, the large environmental effect on expression of GPC and the negative correlation between GPC and grain yield slow breeding progress of durum wheat varieties with elevated GPC. Identification of molecular markers associated with high GPC would aid durum wheat breeders to select for this important trait earlier. The objectives of this study were to identify molecular markers associated with quantitative trait loci (QTL) for elevated GPC in durum wheat. A preliminary genetic map was constructed by screening polymorphic microsatellite markers on a set of 95 double haploid lines derived from the cross Strongfield (high GPC) X DT695 (low GPC). QTL analysis using single marker regression was performed on GPC data collected at Swift Current and Regina in 2002 and Swift Current, Regina and Saskatoon in 2003. To date, we have identified two QTL for GPC flanked by Xgwm448 and Xgwm558 on chromosome 2AS, and on chromosome 2BL at wmc332. No QTL for high GPC could be detected on chromosome 6BS, the location of a high GPC gene isolated previously from durum, wheat suggesting that Strongfield contains novel QTL for high GPC not previously reported in the literature. The molecular markers flanking the QTL identified in this study can be used by durum wheat breeders to enhance selection of high GPC in durum wheat

The effect of potassium infusion on proximal sodium reabsorption and renin release in the dog

The effect of potassium infusion on proximal sodium reabsorption and renin release in the dog. The effect of infusions of potassium chloride (KC1) on sodium reabsorption by the proximal tubule and renal renin release was measured in 18 dogs. Following renal arterial infusions of 8 or 16 µEq/min/kg potassium chloride, fractional and absolute sodium reabsorption by the proximal tubule, measured by micropuncture techniques, was not significantly altered. As compared to five control dogs, urinary sodium excretion was significantly increased following both infusions of KC1. The release of renin was significantly decreased following both rates of potassium infusion. The inhibition of renin release was not associated with consistent changes in either glomerular filtration rate or renal plasma flow. The data indicate that the inhibition of renin release following the infusion of potassium is probably not the result of a marked increase in sodium delivery from the proximal tubule

Cosmological parameters from SDSS and WMAP

We measure cosmological parameters using the three-dimensional power spectrum P(k) from over 200,000 galaxies in the Sloan Digital Sky Survey (SDSS) in combination with WMAP and other data. Our results are consistent with a ``vanilla'' flat adiabatic Lambda-CDM model without tilt (n=1), running tilt, tensor modes or massive neutrinos. Adding SDSS information more than halves the WMAP-only error bars on some parameters, tightening 1 sigma constraints on the Hubble parameter from h~0.74+0.18-0.07 to h~0.70+0.04-0.03, on the matter density from Omega_m~0.25+/-0.10 to Omega_m~0.30+/-0.04 (1 sigma) and on neutrino masses from <11 eV to <0.6 eV (95%). SDSS helps even more when dropping prior assumptions about curvature, neutrinos, tensor modes and the equation of state. Our results are in substantial agreement with the joint analysis of WMAP and the 2dF Galaxy Redshift Survey, which is an impressive consistency check with independent redshift survey data and analysis techniques. In this paper, we place particular emphasis on clarifying the physical origin of the constraints, i.e., what we do and do not know when using different data sets and prior assumptions. For instance, dropping the assumption that space is perfectly flat, the WMAP-only constraint on the measured age of the Universe tightens from t0~16.3+2.3-1.8 Gyr to t0~14.1+1.0-0.9 Gyr by adding SDSS and SN Ia data. Including tensors, running tilt, neutrino mass and equation of state in the list of free parameters, many constraints are still quite weak, but future cosmological measurements from SDSS and other sources should allow these to be substantially tightened.Comment: Minor revisions to match accepted PRD version. SDSS data and ppt figures available at http://www.hep.upenn.edu/~max/sdsspars.htm

Lilium michiganense

Angiosperm

Hot cell preparation of approved testing materials for the Materials Characterization Center

It is important in nuclear waste repository development that testing be done with materials containing a radionuclide spectrum representative of actual wastes. To meet the need for such materials, the Materials Characterization Center (MCC) has prepared simulated high-level waste (HLW) glasses with radionuclides representative of about 10-, 300-, and 1000-year-old waste. A quantity of well characterized spent fuel also has been acquired for the same purpose. Glasses containing 10- and 300-year-old wastes, and the spent fuel specimens, must be fabricated in a hot cell. Hot cell conditions (high radiation field, remote operation, and difficulty of repairs) require that procedures and equipment normally used in materials preparation out-of-cell be modified for hot-cell applications. This paper discusses the fabrication of two glasses, and the preparation of test specimens of these glasses and spent fuel. One of the glasses is a 76 to 68 composition, which is fully loaded with actual commercial reactor fission product waste. The other glass contains simulated Barnwell Nuclear Fuel Plant waste, doped with different combinations of fission products and actinides. The spent fuel is a 10-year-old PWR material. Special techniques have been used to achieve high quality, well characterized testing materials, including specimens in the form of segments, wafers, cylinders, and powders of these materials. 3 references, 1 table

Design and operation of gamma scan and fission gas sampling systems for characterization of irradiated commercial nuclear fuel

One of the primary objectives of the Materials Characterization Center (MCC) is to acquire and characterize spent fuels used in waste form testing related to nuclear waste disposal. The initial steps in the characterization of a fuel rod consist of gamma scanning the rod and sampling the gas contained in the fuel rod (referred to as fission gas sampling). The gamma scan and fission gas sampling systems used by the MCC are adaptable to a wide range of fuel types and have been successfully used to characterize both boiling water reactor (BWR) and pressurized water reactor (PWR) fuel rods. This report describes the design and operation of systems used to gamma scan and fission gas sample full-length PWR and BWR fuel rods. 1 ref., 10 figs., 1 tab