2,617 research outputs found
Hierarchical decomposition of domains with fractures
We consider the efficient and robust numerical solution of elliptic problems with jumping coefficients occuring on a network of fractures. These thin geometric structures are resolved by anisotropic trapezoidal elements. We present an iterative solution concept based on a hierarchical separation of the fractures and the surrounding rock matrix. Upper estimates for the convergence rates are independent of the the jump of coefficients and of the width of the fractures and depend only polynomially on the number of refinement steps. The theoretical results are illustrated by numerical experiments
Very high-energy γ-ray observations of the Crab nebula and other potential sources with the GRAAL experiment
The “γ-ray astronomy at Almeria” (GRAAL) experiment uses 63 heliostat-mirrors with a total mirror area of ≈2500 m2 from the CESA-1 field at the “Plataforma Solar de Almeria” to collect Cherenkov light from air showers. The detector is located in a central solar tower and detects photon-induced showers with an energy threshold of 250±110 GeV and an asymptotic effective detection area of about 15 000 m2. A comparison between the results of detailed Monte-Carlo simulations and data is presented.
Data sets taken in the period September 1999–September 2000 in the direction of the Crab pulsar, the active galaxy 3C 454.3, the unidentified γ-ray source 3EG J1835+59 and a “pseudosource” were analyzed for high energy γ-ray emission. Evidence for a γ-ray flux from the Crab pulsar with an integral flux of 2.2±0.4 above threshold and a significance of 4.5σ in a total measuring time of 7 h and 10 min on source was found. No evidence for emission from the other sources was found.
Some difficulties with the use of heliostat fields for γ-ray astronomy are pointed out. In particular the effect of field-of-view restricted to the central part of a detected air shower on the lateral distribution and timing properties of Cherenkov light are discussed. Upon restriction the spread of the timing front of proton-induced showers sharply decreases and the reconstructed direction becomes biased towards the pointing direction. This is shown to make efficient γ-hadron separation difficult
Water and nitrogen uptake patterns following moisture pulses in a cold desert community
Journal ArticleVariation in the ability to utilize pulses of both water and nitrogen (N) is one possible mechanism allowing the coexistence of species in the cold desert community on the Colorado Plateau. We simulated 25-mm precipitation events and used stable isotope tracers (2H and 15N) to follow water and N uptake patterns in six dominant perennials (Artemisia filifolia, Coleogyne ramosissima, Cryptantha flava, Ephedra viridis, Quercus havardii, and Vanclevea stylosa) at different times of the growing season
Interspecific competition and resource pulse utilization in a cold desert community
Journal ArticleIn desert ecosystems a large proportion of water and nitrogen is supplied in rain-induced pulses. It has been suggested that competitive interactions among desert plants would be most intense during these pulse periods of high resource availability. We tested this hypothesis with three cold desert shrub species of the Colorado Plateau (Gutierrezia sarothrae, Atriplex confertifolia, and Chrysothamnus nauseosus), which differ in their distribution of functional roots. In a three-year field study we conducted a neighbor removal experiment in conjunction with simulated 25-mm precipitation events and the addition of a nitrogen pulse in either spring or summer
The population of deformed bands in Cr by emission of Be from the S + Mg reaction
Using particle- coincidences we have studied the population of final
states after the emission of 2 -particles and of Be in nuclei
formed in S+Mg reactions at an energy of . The data were obtained in a setup
consisting of the GASP -ray detection array and the multidetector array
ISIS. Particle identification is obtained from the E and E signals of
the ISIS silicon detector telescopes, the Be being identified by the
instantaneous pile up of the E and E pulses. -ray decays of the
Cr nucleus are identified with coincidences set on 2 -particles
and on Be. Some transitions of the side-band with show
stronger population for Be emission relative to that of 2
-particles (by a factor ). This observation is interpreted as
due to an enhanced emission of Be into a more deformed nucleus.
Calculations based on the extended Hauser-Feshbach compound decay formalism
confirm this observation quantitatively.Comment: 17 pages, 9 figures accepted for publication in J. Phys.
Progress of the ECHo SDR Readout Hardware for Multiplexed MMCs
The electron capture in Holmium (ECHo) experiment seeks to achieve sub-eV sensitivity of the electron neutrino mass through calorimetric decay spectroscopy of Ho in large arrays of cryogenic magnetic microcalorimeters (MMCs). Microwave SQUID multiplexing serves to efficiently increase the number of readout channels, thus calorimeters per array and ultimately per cryostat. A corresponding frequency multiplexing room temperature software-defined radio (SDR) system is in development to enable the readout of this increased number of MMCs per cable. The SDR consists of a custom FPGA platform that provides signal generation and analysis capabilities, as well as tailored signal conversion and analog conditioning front end electronics that enable the room-temperature-to-cryogenic interface. Ultimately, the system will read out 400 multiplexer channels with double pixel detectors through a bandwidth of 4 GHz (IEEE C band). As high-resolution data converters are limited in sample rate, the C-band is split into five sub-bands using a two-stage mixing method. In this contribution, a prototype of the heterodyne RF design is presented. It comprises one of the five 800 MHz sub-bands for a target frequency range between 4 and 8 GHz. Furthermore, the second version of the A/D converter stage is presented, capable of generating and digitizing up to five complex basebands using 1 GSs converters, the reference clocks and a flux-ramp signal. We will show first results of their single and combined characterization in the lab. The current state of the prototype hardware enables preliminary measurements, only limited in bandwidth and with slightly higher noise. Potential improvements could be derived and will be implemented in the full bandwidth, 5-sub-band RF PCB design
The GRAAL Project
26th International Cosmic Ray Conference Salt Lake City, Utah August 17-25,1999The GRAAL Project (Gamma Ray Astronomy at ALmeria) makes use of the CESA-1 heliostat field at the
“Plataforma Solar de Almeria” (Spain) as a gamma-ray telescope with an energy threshold of about 100 GeV.
Cherenkov light generated by EAS is reflected by the heliostats and collected into photomultipliers (PMTs)
with nonimaging secondary optics. Each PMT collects the light reflected by 13 - 18 heliostats of 40 m2
using a Winston cone. After successful tests with two collecting cones, a more advanced setup on a dedicated
platform, using four collectors and 63 heliostats (total reflecting area of about 2500 m2
) is being installed.
A description of this setup together with Monte Carlo results about its excellent capabilities in the precise
determination of pulse arrival times are presented
Equidimensional modelling of flow and transport processes in fractured porous systems I
Flow and transport in fractured porous media play an important role for many environmental applications, e.g. the design of disposal systems for hazardous waste. The different hydraulic properties of the fractures and the surrounding rock matrix have a strong influence on the behaviour of the physical processes existing on site.
In the two papers of this conference, we will present a new numerical concept to describe saturated flow and transport processes in arbitrarily fractured porous media. We will use an equidimensional approach where fracture and matrix are discretized with elements of the same dimension. To solve the problem, we developed a two-level multigrid method based on a hierarchical decomposition into a fracture problem and a matrix problem. This decoupled treatment of fracture and matrix allows us to handle the locally governing physical processes appropriately. In this paper we will also present convergence comparisons with classical multigrid and algebraic multigrid methods (AMG). In Neunhäuserer et al. (this issue, part II) we will discuss the effect of equidimensionality on the modelling results and the influence of the chosen transport discretisation technique
Equidimensional modelling of flow and transport processes in fractured porous systems II
In fractured formations, the vastly different hydraulic properties of fractures and porous matrix lead to a considerable mass exchange between fracture and matrix, strongly affecting the flow and transport conditions in the domain of interest. This plays an important role for many environmental applications, e.g. the design of disposal systems for hazardous waste.
In two papers, we display a new numerical concept describing saturated flow and transport processes in arbitrarily fractured porous media. An equidimensional approach is developed using elements of the same dimension for fracture and matrix discretisation. In Gebauer et al. (this issue, part I) we introduced a two-level multigrid method based on a hierarchical decomposition designed to solve equidimensional fracture-matrix-problems. In this paper we will discuss the effect of equidimensionality on the modelling results. Furthermore, the influence of the chosen transport discretisation technique will be shown
Development of a Marslander with crushable shock absorber by virtual and experimental testing
Since the beginning of space exploration, probes have been sent to other planets or moons with the associated
challenge of landing on these bodies. For a soft landing several damping methods like landing legs or airbags have
been used. A new and potentially less complex and lighter way to reduce the shock loads at touchdown is the use of
a crushable shield underneath the lander platform. This crushable shield could be made for example out of an energy
absorbing materials like an aluminum honeycomb core with a High Performance Polyethylene cover sheet. The
design is particularly advantageous since no moving parts nor other mechanisms are required, thus making the shield
very robust and fail safe. The only mission that is currently planned to use this technique is the ESA-mission
“ExoMars” which is planned to start in 2016.
The development of such a crushable shock absorber implies and requires assessment of materials,
manufacturing processes, the setup of a numerical simulation and the experimental validation in a test lab. In an
independent research project (Marslander1) a representative engineering mockup of the landing platform has been
build and tested at the Landing & Mobility Test Facility (LAMA) to support the numerical simulation model with
experimental data. The simulations are based on the explicit Finite Element Method, which discretizes the structure
into a defined number of elements, such that each element is assigned a set of equations describing the material
properties and applied loads. The goal is to generate a simplified but still accurate model to predict landing scenarios
by running Monte Carlo simulations.
Results of the above stated development and testing processes will be presented and discussed in this paper
- …