Influence of MWCNT/surfactant dispersions on the mechanical properties of Portland cement pastes

This work studies the reinforcing effect of Multi Walled Carbon Nanotubes (MWCNT) on cement pastes. A 0.35% solid concentration of MWCNT in powder was dispersed in deionized water with sodium dodecyl sulfate (cationic surfactant), cetylpyridinium chloride (anionic surfactant) and triton X-100 (amphoteric surfactant) using an ultrasonic tip processor. Three concentrations of each surfactant (1mM, 10mM and 100mM) were tested, and all samples were sonicated until an adequate dispersion degree was obtained. Cement pastes with additions of carbon nanotubes of 0.15% by mass of cement were produced in two steps; first the dispersions of MWCNT were combined with the mixing water using an ultrasonic tip processor to guarantee homogeneity, and then cement was added and mixed until a homogeneous paste was obtained. Direct tensile strength, apparent density and open porosity of the pastes were measured after 7 days of curing. It was found that the MWCNT/surfactants dispersions decrease the mechanical properties of the cement based matrix due to an increased porosity caused by the presence of surfactants. © Published under licence by IOP Publishing Ltd

Deflection hardening of sustainable fiber–cement composites

In the present study sisal fiber–cement composites reinforced with 4% and 6% of short fibers were developed and their physical–mechanical behavior was characterized. To ensure the composite sustainability and durability, the ordinary Portland cement matrix was modified by adding fly ash and metakaolin, and the natural aggregate was substituted by 10% and 20% of recycled concrete aggregate. Flat sheets were cast in a self-compacted cement matrix and bending tests were performed to determine the first crack, postpeak strength and toughness of the composites. Cyclic flexural tests were carried out to determine the stiffness variation of composite due to cracking formation and propagation. It can be seen that the reinforcement provided by short sisal fibers for recycled cement matrices guaranteed a composite with multiple cracking and an increase of strength after the first crack. Reduction of stiffness and increase the damping capacity of composite are verified with progressive cracking.CAPES (PVE Program: Project 047/2012) and CNPqBrazilian agency FAPESBBrazilian agency CAPES through the PVE Progra

Dissipative collisions in 16^{16}O + 27^{27}Al at Elab_{lab}=116 MeV

The inclusive energy distributions of fragments (3$\leq$Z$\leq$7) emitted in the reaction $^{16}$O + $^{27}$Al at $E_{lab} =$116 MeV have been measured in the angular range $\theta_{lab}$= 15$^\circ$ - 115$^\circ$. A non-linear optimisation procedure using multiple Gaussian distribution functions has been proposed to extract the fusion-fission and deep inelastic components of the fragment emission from the experimental data. The angular distributions of the fragments, thus obtained, from the deep inelastic component are found to fall off faster than those from the fusion-fission component, indicating shorter life times of the emitting di-nuclear systems. The life times of the intermediate di-nuclear configurations have been estimated using a diffractive Regge-pole model. The life times thus extracted ($\sim 1 - 5\times 10^{-22}$ Sec.) are found to decrease with the increase in the fragment charge. Optimum Q-values are also found to increase with increasing charge transfer i.e. with the decrease in fragment charge.Comment: 9 pages, 4 figures, 1 tabl

Efeito da argila calcinada sobre a durabilidade de argamassas reforçadas com fibras curtas de sisal

O interesse pelo uso de fibras vegetais como reforço de matrizes, à base de cimento, tem crescido em todo o mundo nos últimos anos, sendo limitado pela baixa durabilidade das fibras no meio alcalino. Com o tempo, as fibras podem mineralizar devido à migração de hidróxido de cálcio (CH) da matriz para o lúmen e paredes das fibro-células. Procurou-se consumir, no presente estudo, o CH livre utilizando-se resíduo de tijolo moído e metacaulinita em substituição parcial, de 20 e 40% em peso, do cimento portland. Compósitos com fibras de sisal e matrizes cimento-pozolana foram submetidos a ensaios de resistência a flexão, após 28 dias de cura em água, 135 e 180 dias de envelhecimento natural e após 94 ciclos de molhagem e secagem. Os resultados indicaram que é possível consumir todo o CH da matriz, o que resultou na manutenção da tenacidade inicial do compósito e no aumento da sua resistência a flexão após exposição natural ou ciclos de molhagem e secagem.In the last few years a growing interest in the use of sisal fibers as reinforcement in cement based composites has been observed. However, the main concern for its use is related with the durability of the fibers in the alkaline water of concrete as they can mineralize due to the migration of calcium hydroxide to the fiber lumen and cell walls. In this study, the alkalinity of the matrix was reduced using metakaolin and crushed waste calcined clay bricks as cement replacement. The percentage of cement replacement ranged from 20 to 40% on weight basis. Flexural tests were carried out in the composites after 28 days of cure in water, 135 and 180 days of ageing in the open air and after 94 cycles of wetting and drying. These results indicated that the mixture with cement replacement consumed all calcium hydroxide and kept the toughness over time

Índice de vegetação por diferença normalizada (NDVI) de cultivares de soja sob três níveis de disponibilidade hídirca no solo.

bitstream/item/71971/1/ID-30959.pd

Multiplicity dependence of jet-like two-particle correlations in p-Pb collisions at sNN\sqrt{s_{NN}} = 5.02 TeV

Two-particle angular correlations between unidentified charged trigger and associated particles are measured by the ALICE detector in p-Pb collisions at a nucleon-nucleon centre-of-mass energy of 5.02 TeV. The transverse-momentum range 0.7 $< p_{\rm{T}, assoc} < p_{\rm{T}, trig} <$ 5.0 GeV/$c$ is examined, to include correlations induced by jets originating from low momen\-tum-transfer scatterings (minijets). The correlations expressed as associated yield per trigger particle are obtained in the pseudorapidity range $|\eta|<0.9$. The near-side long-range pseudorapidity correlations observed in high-multiplicity p-Pb collisions are subtracted from both near-side short-range and away-side correlations in order to remove the non-jet-like components. The yields in the jet-like peaks are found to be invariant with event multiplicity with the exception of events with low multiplicity. This invariance is consistent with the particles being produced via the incoherent fragmentation of multiple parton--parton scatterings, while the yield related to the previously observed ridge structures is not jet-related. The number of uncorrelated sources of particle production is found to increase linearly with multiplicity, suggesting no saturation of the number of multi-parton interactions even in the highest multiplicity p-Pb collisions. Further, the number scales in the intermediate multiplicity region with the number of binary nucleon-nucleon collisions estimated with a Glauber Monte-Carlo simulation.Comment: 23 pages, 6 captioned figures, 1 table, authors from page 17, published version, figures at http://aliceinfo.cern.ch/ArtSubmission/node/161

Cement composites reinforced by short curaua fibers

ABSTRACT The development of an eco-friendly material that could reduce CO 2 emission and that could aggregate value to a natural fiber, setting man at the countryside and raising the income of populations from poor regions is a challenge. Lignocellulosic fibers are cheap and are a readily available reinforcement, requiring only a low degree of industrialization for their processing. The main drawback of using cement composites reinforced with lignocellulosic fibers is that the fibers can be mineralized inside the alkaline environment. In this work, Portland cement was partially replaced by metakaolinite in order to produce a matrix free from calcium hydroxide, avoiding thus the problem of fiber mineralization. Cement composites reinforced with 2, 4 and 6% of short curaua fibers, were manufactured. The composites were submitted to four pointing bending tests in order to determine their mechanical behavior. The results obtained were compared with those found for cement composites reinforced with sisal fibers

Effective Rheology of Bubbles Moving in a Capillary Tube

We calculate the average volumetric flux versus pressure drop of bubbles moving in a single capillary tube with varying diameter, finding a square-root relation from mapping the flow equations onto that of a driven overdamped pendulum. The calculation is based on a derivation of the equation of motion of a bubble train from considering the capillary forces and the entropy production associated with the viscous flow. We also calculate the configurational probability of the positions of the bubbles.Comment: 4 pages, 1 figur

Charge separation relative to the reaction plane in Pb-Pb collisions at sNN=2.76\sqrt{s_{\rm NN}}= 2.76 TeV

Measurements of charge dependent azimuthal correlations with the ALICE detector at the LHC are reported for Pb-Pb collisions at $\sqrt{s_{\rm NN}} = 2.76$ TeV. Two- and three-particle charge-dependent azimuthal correlations in the pseudo-rapidity range $|\eta| < 0.8$ are presented as a function of the collision centrality, particle separation in pseudo-rapidity, and transverse momentum. A clear signal compatible with a charge-dependent separation relative to the reaction plane is observed, which shows little or no collision energy dependence when compared to measurements at RHIC energies. This provides a new insight for understanding the nature of the charge dependent azimuthal correlations observed at RHIC and LHC energies.Comment: 12 pages, 3 captioned figures, authors from page 2 to 6, published version, figures at http://aliceinfo.cern.ch/ArtSubmission/node/286

Multi-particle azimuthal correlations in p-Pb and Pb-Pb collisions at the CERN Large Hadron Collider

Measurements of multi-particle azimuthal correlations (cumulants) for charged particles in p-Pb and Pb-Pb collisions are presented. They help address the question of whether there is evidence for global, flow-like, azimuthal correlations in the p-Pb system. Comparisons are made to measurements from the larger Pb-Pb system, where such evidence is established. In particular, the second harmonic two-particle cumulants are found to decrease with multiplicity, characteristic of a dominance of few-particle correlations in p-Pb collisions. However, when a $|\Delta \eta|$ gap is placed to suppress such correlations, the two-particle cumulants begin to rise at high-multiplicity, indicating the presence of global azimuthal correlations. The Pb-Pb values are higher than the p-Pb values at similar multiplicities. In both systems, the second harmonic four-particle cumulants exhibit a transition from positive to negative values when the multiplicity increases. The negative values allow for a measurement of $v_{2}\{4\}$ to be made, which is found to be higher in Pb-Pb collisions at similar multiplicities. The second harmonic six-particle cumulants are also found to be higher in Pb-Pb collisions. In Pb-Pb collisions, we generally find $v_{2}\{4\} \simeq v_{2}\{6\}\neq 0$ which is indicative of a Bessel-Gaussian function for the $v_{2}$ distribution. For very high-multiplicity Pb-Pb collisions, we observe that the four- and six-particle cumulants become consistent with 0. Finally, third harmonic two-particle cumulants in p-Pb and Pb-Pb are measured. These are found to be similar for overlapping multiplicities, when a $|\Delta\eta| > 1.4$ gap is placed.Comment: 25 pages, 11 captioned figures, 3 tables, authors from page 20, published version, figures at http://aliceinfo.cern.ch/ArtSubmission/node/87