Oxygen adsorption on the Ru (10 bar 1 0) surface: Anomalous coverage dependence

Oxygen adsorption onto Ru (10 bar 1 0) results in the formation of two ordered overlayers, i.e. a c(2 times 4)-2O and a (2 times 1)pg-2O phase, which were analyzed by low-energy electron diffraction (LEED) and density functional theory (DFT) calculation. In addition, the vibrational properties of these overlayers were studied by high-resolution electron loss spectroscopy. In both phases, oxygen occupies the threefold coordinated hcp site along the densely packed rows on an otherwise unreconstructed surface, i.e. the O atoms are attached to two atoms in the first Ru layer Ru(1) and to one Ru atom in the second layer Ru(2), forming zigzag chains along the troughs. While in the low-coverage c(2 times 4)-O phase, the bond lengths of O to Ru(1) and Ru(2) are 2.08 A and 2.03 A, respectively, corresponding bond lengths in the high-coverage (2 times 1)-2O phase are 2.01 A and 2.04 A (LEED). Although the adsorption energy decreases by 220 meV with O coverage (DFT calculations), we observe experimentally a shortening of the Ru(1)-O bond length with O coverage. This effect could not be reconciled with the present DFT-GGA calculations. The nu(Ru-O) stretch mode is found at 67 meV [c(2 times 4)-2O] and 64 meV [(2 times 1)pg-2O].Comment: 10 pages, figures are available as hardcopies on request by mailing [email protected], submitted to Phys. Rev. B (8. Aug. 97), other related publications can be found at http://www.rz-berlin.mpg.de/th/paper.htm

Surface atomic geometry of Si(001)-(2X1): A low-energy electron-diffraction structure analysis

The reconstruction of the Si(001)-2×1 surface consists of asymmetric and buckled Si dimers. The vertical separation between the up and the down atom within the dimer is about 0.72±0.05 Å and the dimer bond length of 2.24±0.08 Å has been found to be slightly smaller than the Si-Si distance in the bulk. The tilt of the dimer is 19±2°. The formation of Si dimers induces pronounced distortions in the substrate that were detectable down to the fifth Si layer. The structure determination is based on two independent low-energy electron-diffraction data sets taken in two different laboratories. The structural results agree well within the error limits, though noticeable differences occur between the experimental data sets. These differences in the experimental data can possibly be attributed to different preparation procedures

High-level feature detection from video in TRECVid: a 5-year retrospective of achievements

Successful and effective content-based access to digital video requires fast, accurate and scalable methods to determine the video content automatically. A variety of contemporary approaches to this rely on text taken from speech within the video, or on matching one video frame against others using low-level characteristics like colour, texture, or shapes, or on determining and matching objects appearing within the video. Possibly the most important technique, however, is one which determines the presence or absence of a high-level or semantic feature, within a video clip or shot. By utilizing dozens, hundreds or even thousands of such semantic features we can support many kinds of content-based video navigation. Critically however, this depends on being able to determine whether each feature is or is not present in a video clip. The last 5 years have seen much progress in the development of techniques to determine the presence of semantic features within video. This progress can be tracked in the annual TRECVid benchmarking activity where dozens of research groups measure the effectiveness of their techniques on common data and using an open, metrics-based approach. In this chapter we summarise the work done on the TRECVid high-level feature task, showing the progress made year-on-year. This provides a fairly comprehensive statement on where the state-of-the-art is regarding this important task, not just for one research group or for one approach, but across the spectrum. We then use this past and on-going work as a basis for highlighting the trends that are emerging in this area, and the questions which remain to be addressed before we can achieve large-scale, fast and reliable high-level feature detection on video

The origins of belonging : Social motivation in infants and young children

Our reliance on our group members has exerted a profound influence over our motivation: successful group functioning requires that we are motivated to interact, and engage, with those around us. In other words, we need to belong. In this article, I explore the developmental origins of our need to belong. I discuss existing evidence that, from early in development, children seek to affiliate with others and to form long-lasting bonds with their group members. Furthermore, when children are deprived of a sense of belonging, it has negative consequences for their well-being. This focus on social motivation enables us to examine why and in what circumstances children engage in particular behaviours. It thus provides an important complement to research on social cognition. In doing so, it opens up important questions for future research and provides a much-needed bridge between developmental and social psychology

Metastable precursors during the oxidation of the Ru(0001) surface

Using density-functional theory, we predict that the oxidation of the Ru(0001) surface proceeds via the accumulation of sub-surface oxygen in two-dimensional islands between the first and second substrate layer. This leads locally to a decoupling of an O-Ru-O trilayer from the underlying metal. Continued oxidation results in the formation and stacking of more of these trilayers, which unfold into the RuO_2(110) rutile structure once a critical film thickness is exceeded. Along this oxidation pathway, we identify various metastable configurations. These are found to be rather close in energy, indicating a likely lively dynamics between them at elevated temperatures, which will affect the surface chemical and mechanical properties of the material.Comment: 11 pages including 9 figures. Submitted to Phys. Rev. B. Related publications can be found at http://www.fhi-berlin.mpg.de/th/paper.htm

Composition, structure and stability of RuO_2(110) as a function of oxygen pressure

Using density-functional theory (DFT) we calculate the Gibbs free energy to determine the lowest-energy structure of a RuO_2(110) surface in thermodynamic equilibrium with an oxygen-rich environment. The traditionally assumed stoichiometric termination is only found to be favorable at low oxygen chemical potentials, i.e. low pressures and/or high temperatures. At realistic O pressure, the surface is predicted to contain additional terminal O atoms. Although this O excess defines a so-called polar surface, we show that the prevalent ionic model, that dismisses such terminations on electrostatic grounds, is of little validity for RuO_2(110). Together with analogous results obtained previously at the (0001) surface of corundum-structured oxides, these findings on (110) rutile indicate that the stability of non-stoichiometric terminations is a more general phenomenon on transition metal oxide surfaces.Comment: 12 pages including 5 figures. Submitted to Phys. Rev. B. Related publications can be found at http://www.fhi-berlin.mpg.de/th/paper.htm

Theoretical study of O adlayers on Ru(0001)

Recent experiments performed at high pressures indicate that ruthenium can support unusually high concentrations of oxygen at the surface. To investigate the structure and stability of high coverage oxygen structures, we performed density functional theory calculations, within the generalized gradient approximation, for O adlayers on Ru(0001) from low coverage up to a full monolayer. We achieve quantitative agreement with previous low energy electron diffraction intensity analyses for the (2x2) and (2x1) phases and predict that an O adlayer with a (1x1) periodicity and coverage of 1 monolayer can form on Ru(0001), where the O adatoms occupy hcp-hollow sites.Comment: RevTeX, 6 pages, 4 figure

Theoretical analysis of the electronic structure of the stable and metastable c(2x2) phases of Na on Al(001): Comparison with angle-resolved ultra-violet photoemission spectra

Using Kohn-Sham wave functions and their energy levels obtained by density-functional-theory total-energy calculations, the electronic structure of the two c(2x2) phases of Na on Al(001) are analysed; namely, the metastable hollow-site structure formed when adsorption takes place at low temperature, and the stable substitutional structure appearing when the substrate is heated thereafter above ca. 180K or when adsorption takes place at room temperature from the beginning. The experimentally obtained two-dimensional band structures of the surface states or resonances are well reproduced by the calculations. With the help of charge density maps it is found that in both phases, two pronounced bands appear as the result of a characteristic coupling between the valence-state band of a free c(2x2)-Na monolayer and the surface-state/resonance band of the Al surfaces; that is, the clean (001) surface for the metastable phase and the unstable, reconstructed "vacancy" structure for the stable phase. The higher-lying band, being Na-derived, remains metallic for the unstable phase, whereas it lies completely above the Fermi level for the stable phase, leading to the formation of a surface-state/resonance band-structure resembling the bulk band-structure of an ionic crystal.Comment: 11 pages, 11 postscript figures, published in Phys. Rev. B 57, 15251 (1998). Other related publications can be found at http://www.rz-berlin.mpg.de/th/paper.htm

Evolution of the cosmic ray anisotropy above 10^{14} eV

The amplitude and phase of the cosmic ray anisotropy are well established experimentally between 10^{11} eV and 10^{14} eV. The study of their evolution into the energy region 10^{14}-10^{16} eV can provide a significant tool for the understanding of the steepening ("knee") of the primary spectrum. In this letter we extend the EAS-TOP measurement performed at E_0 around 10^{14} eV, to higher energies by using the full data set (8 years of data taking). Results derived at about 10^{14} and 4x10^{14} eV are compared and discussed. Hints of increasing amplitude and change of phase above 10^{14} eV are reported. The significance of the observation for the understanding of cosmic ray propagation is discussed.Comment: 4 pages, 3 figures, accepted for publication on ApJ Letter

Density-functional study of hydrogen chemisorption on vicinal Si(001) surfaces

Relaxed atomic geometries and chemisorption energies have been calculated for the dissociative adsorption of molecular hydrogen on vicinal Si(001) surfaces. We employ density-functional theory, together with a pseudopotential for Si, and apply the generalized gradient approximation by Perdew and Wang to the exchange-correlation functional. We find the double-atomic-height rebonded D_B step, which is known to be stable on the clean surface, to remain stable on partially hydrogen-covered surfaces. The H atoms preferentially bind to the Si atoms at the rebonded step edge, with a chemisorption energy difference with respect to the terrace sites of >sim 0.1 eV. A surface with rebonded single atomic height S_A and S_B steps gives very similar results. The interaction between H-Si-Si-H mono-hydride units is shown to be unimportant for the calculation of the step-edge hydrogen-occupation. Our results confirm the interpretation and results of the recent H_2 adsorption experiments on vicinal Si surfaces by Raschke and Hoefer described in the preceding paper.Comment: 13 pages, 8 figures, submitted to Phys. Rev. B. Other related publications can be found at http://www.rz-berlin.mpg.de/th/paper.htm