Behavior of divertor and first wall armour materials at plasma heat fluxes relevant to ITER ELMs and disruptions

The paper presents the main results of numerous experiments carried out over the past 10 years at QSPA-T and QSPA-Be plasma guns in support of ITER. Special targets made of pure W, W-1%La2O3 and two types of Be (TGP-56FW and S65-C) were tested under the series of repeated plasma stream and photonic flux impact. Maximum heat load on the target surface was up to 2.5MJ/m2 in the case of plasma testing and was equal to 0.5MJ/m2 in the case of photonic flux testing. Pulse waveform was rectangular with tpulse= 0.5ms. It was found that the main erosion mechanisms of W and Be under plasma stream impact are the melt layer movement, the ejection of droplets and the cracks formation. As a result of repeated photonic fluxes a regular, “corrugated” structure are eventually formed on the Be target surface. Study of erosion products of W formed under plasma stream impact on the W target has shown that the D/W atomic ratio in the deposited W films during pulsed events may be the same or even higher than that for stationary processes. Keywords: ITER, Tungsten, Beryllium, Transient events, Material erosion, Erosion product

Three-dimensional modelling of sputtered materials transport in diagnostic ducts of fusion devices

Migration of plasma erosion products in plasma facilities is studied experimentally and numerically within the framework of modelling transport of plasma-facing materials in the diagnostic ducts of fusion devices. Material transport simulation is discussed for two cases of low and high background neutral gas pressures. Monte Carlo software KITe was used to simulate transport at a neutral gas background pressure 0.1-0.5 Pa – typical during steady-state tokamak operation and during pressure pulses caused by edge localized modes (ELMs). The simulation approach was implemented to describe experiments at the MAGNUM-PSI facility. Fluid dynamic code FLUENT is used to simulate transport during pressure surges as high as 1000 Pa, which can occur in case of severe disruptions in tokamak plasma discharges, such as vertical displacement events (VDE) or accidental events. The hydrodynamic approach was verified in simulation of target sputtering in the QSPA plasma gun facility

Three-dimensional modelling of sputtered materials transport in diagnostic ducts of fusion devices

Migration of plasma erosion products in plasma facilities is studied experimentally and numerically within the framework of modelling transport of plasma-facing materials in the diagnostic ducts of fusion devices. Material transport simulation is discussed for two cases of low and high background neutral gas pressures. Monte Carlo software KITe was used to simulate transport at a neutral gas background pressure 0.1-0.5 Pa – typical during steady-state tokamak operation and during pressure pulses caused by edge localized modes (ELMs). The simulation approach was implemented to describe experiments at the MAGNUM-PSI facility. Fluid dynamic code FLUENT is used to simulate transport during pressure surges as high as 1000 Pa, which can occur in case of severe disruptions in tokamak plasma discharges, such as vertical displacement events (VDE) or accidental events. The hydrodynamic approach was verified in simulation of target sputtering in the QSPA plasma gun facility.<br/