Properties of Si/SiC ceramic composite subjected to chemical vapour infiltration

Si/SiC ceramic composite was prepared by infiltration of liquid silicon into carbon preforms that was made from cotton fabric and phenolic resin. This composite was subjected to the chemical vapour infiltration (CVI), using methyltrichlorosilane as a precursor gas. The effect of infiltration time on densification and mechanical properties was studied. Results show a significant improvement in density by pore closure. Flexural strength increases with increasing infiltration time. However, beyond 60 h of infiltration, the strength improvement was insignificant. The high temperature oxidation resistance of the above ceramics was also studied. The CVI treated samples show considerable resistance to oxidation compared to untreated samples. Thermogravimetric analysis also confirmed the better oxidation resistance of the CVI treated samples

Structure-property correlation in discontinuously reinforced aluminium matrix composites as a function of relative particle size ratio

Metal matrix composites made by a powder metallurgy route often exhibit clustering of the reinforcements due to geometrical reasons. The clustering tendency was studied in 2124 Al/30 v/o SiCp composites as a function of relative particle size ratio between the matrix and reinforcement particles. Dry blended composite powders. with different RPS ratios, were vacuum hot-pressed and micro structures were examined to assess the uniformity of the microstructure by measuring the local area fraction of the constituents. It was found that a decrease in RPS ratio resulted in an increase in strength as well as ductility, as a result of improved distribution of the SiCp. The improved response to the homogenisation treatment, observed in the composite with lower RPS ratio, is attributed to the smaller diffusion path length for the alloying element. (C) 2002

Solid particle erosion studies on biomorphic Si/SiC ceramic composites

Solid particle erosion tests were conducted on four different types of silicon carbide ceramic composites. The composites are cotton fabric based Si/SiC with and without chemical vapour infiltration, fine teak wood powder based Si/SiC and coarse teak wood powder based Si/SiC. The erodents used are angular SiC particles of average size 80, 250 and 450�m. The velocities with which particles impacted on the target materials were varied from 20 to 50 m/s. Similarly the angle of impact was varied from 20◦ to 90◦. Scanning electron microscopic observations on the eroded surface show brittle and cleavage like fracture. Fine teak wood powder based Si/SiC ceramic shows better erosion resistance than the other ceramics. Homogenous distribution of SiC grains with the presence of very fine grains of silicon and carbon is responsible for the improved erosion resistance. The higher erosion rate in cotton fabric based SiC arises from its microstructure. Here, the free carbon and free silicon grains are large in size and the SiC phase has very low hardness as compared to the erodent

Synthesis and characterization of Si/SiC ceramics prepared using cotton fabric

A Si/SiC ceramic was prepared from cotton fabric by the reactive infiltration of liquid silicon into the carbon template. A large density difference between the samples has been observed. This may be due to the variation in the pore size and its distribution within the sample. Scanning electron microscopy with energy dispersive spectroscopy shows the presence of three distinct phases, i.e., SiC, free Si and free carbon. X-ray diffraction pattern also confirms the presence of SiC and Si phases. However, there is no peak corresponding to carbon. So, it is inferred that the carbon exists in amorphous form. Micro-hardness, fracture toughness and bending strength of the ceramics were also studied. The values are lower than commercially available SiC ceramics. This may be due to the highly porous nature of cotton fabric-based SiC, as compared to commercially available SiC