High flux polysulfone braided hollow fiber membrane for wastewater treatment role of zinc oxide as hydrophilic enhancer

Incorporation of zinc oxide (ZnO) nanoparticles has played an important role on the improvement of unique membrane characterization and performance, most notably the hydrophilic modification of the membrane for higher pure water permeability. Additionally, the permeability of the membrane can be improved via introduction of braid support by reducing the thickness of the membrane separation layer. Moreover, the braided hollow fiber membrane (BHFM) is able to perform under higher pressure conditions compared to hollow fiber membranes. In this paper, hybrid polysulfone (PSf)/ZnO BHFMs were fabricated via phase inversion method. Hydrophilic 10 ± 1.8 nm polycrystalline ZnO nanoparticles synthesized via sol-gel method were incorporated on BHFM to improve the hydrophilicity and increase flux with constant rejection under high pressure and the effect of the ZnO loading on the membrane properties and performance were thoroughly studied. The fabricated BHFMs with 0.0, 0.5, 1.0 and 1.5 wt% of ZnO nanoparticles concentration were defined as BHFM1, BHFM2, BHFM3 and BHFM4 respectively. Scanning electron microscopy (SEM), contact angle, mechanical strength, flux performance, rejection with bovine serum albumin (BSA) and fouling of best performed membrane were conducted to achieve the target of this paper. The performance of these hybrid ZnO/PSf BHFMs were compared with neat PSf hollow fiber membrane (HFM) and previous studies. The findings from this research work shows that BHFM4 has the most desired properties for wastewater treatment application. The ZnO nanoparticles in BHFM4 have improved hydrophilicity from 108.79° to 71.02°, and thus BHFM4 has increased flux performance from 36.20 to 919.12 L/m2 h at 1.0 bar pressure and 193.48 to 1909.11 L/m2h at 4.0 bar pressure when compared with BHFM1. Constant BSA rejection rates (> 90%) were observed in all BHFMs. The improved hydrophilicity and pure flux performance with constant rejection rate in high pressure conditions illustrates the suitability of fabricated ZnO/PSf BHFMs in wastewater treatment applications

The feasibility study of CAU-1 as an adsorbent for Cu, Zn, Pb, As, Fe and endocrine disrupting chemical bisphenol-A (BPA)

This work discusses the feasibility of CAU-1 as an adsorbent for both heavy metals and bisphenol A (BPA). CAU-1 was synthesised solvothermally at 120 °C for 8 h. Batch adsorption study was done to investigate the feasibility of CAU-1 as the adsorbent. The CAU-1 weight was constant throughout the study, 0.01 g. CAU-1 was characterised using zeta potential analysis, SEM, FTIR, TGA, and XRD. CAU-1 was only able to remove BPA and not able to adsorb heavy metals due to the repulsion forces between CAU-1 and the heavy metals. Thus, BPA was used as adsorbate for CAU-1 adsorption study. The optimum conditions for BPA adsorption on CAU-1 were at pH 7 and 3 h contact time. The adsorption capacity increased infinitely with increasing concentration of the BPA. The maximum equilibrium adsorption capacity (qe) of CAU-1 for BPA was 310.1 mg/g at 25 °C, and the adsorption followed the pseudo-second-order kinetic model. The thermodynamic studies indicate that the adsorption reaction is a spontaneous and endothermic process, a favourable reaction