10 research outputs found
Recommended from our members
Superconducting Magnet Technology for Future Hadron Colliders
The application of superconducting magnets to large-scale particle accelerators was successfully demonstrated with the completion of the Tevatron at Fermilab in 1983. This machine, utilizing dipole magnets operating at 4.5 T, has been operating successfully for the past 12 years. This success was followed a few years later by HERA, an electron-proton collider that uses superconducting quadrupoles and dipoles of a design similar to those in the Tevatron. The next major project was the ill-fated SSC, which was cancelled in 1993. However, the SSC R&D effort did succeed in demonstrating the reliable operation of dipole magnets up to 6.6 T. The LHC, now under construction, pushes the ductile superconductor, NbTi, to its limit in dipoles designed to operate at fields of 8.6 T at 1.8 K. Several recent studies have addressed the issues involved in taking the next step beyond the LHC. The Division of Particles and Fields Workshop on Future Hadron Facilities in the U.S., held at Indiana U. in 1994, examined two possible facilities--a 2-TeV on 2-TeV collider and a 30-Tev on 30-Tev collider. The participants arrived at the following conclusions with regard to superconducting magnets: (1) Superconducting magnets are the enabling technology for high energy colliders. As such, the highest priority for the future of hadron facilities in the U.S. is the reassembly of a U.S. superconducting magnet R&D program. (2) emphasis on conductor development and new magnet designs; and (3) goals of such a program might be (a) the development of a 9-10 Tesla magnet based on NbTi technology; (b) the development of high quality quadrupoles with gradients in the range 250-300 T/m; and (c) initiation of R&D activities aimed at moving beyond the existing technology as appears to be required for the development of a magnet operating at 12-15 Tesla. In order to reach fields above 10 T, magnet designers must turn to new materials with higher critical fields than that of NbTi. Several candidate conductors exist; unfortunately, all of these new materials are brittle, and thus pose new challenges to the magnet designers. At the same time that the forces on the magnet windings are increasing due to the higher Lorentz force associated with the higher magnetic fields, the conductor tensile strain must be limited to less than about 0.5% to prevent damage to the brittle superconducting material. Also, coil fabrication methods must be changed. If the superconductor is in the reacted, or brittle, state, the coil winding procedure must be modified to prevent overstraining. If the alternative wind and react approach is used, new insulating materials must be used that can survive the high temperature reactions (650 to 800 C) necessary to form the superconducting compounds. The issues associated with high-field dipole magnets have been discussed at a number of workshops, including those at DESY in 1991 and LBL in 1992. These workshops were extremely useful in defining the problems and focusing the attention of both materials and magnet experts on high-field dipole magnets; however, since neither set of proceedings was published, the information is not readily available. More recently, a workshop was held in Erice, Italy, under the sponsorship of the Ettore Maiorana Center for Scientific Culture. This international workshop was attended by 20 scientists from Europe, Japan, and the U.S., and the summary of that work, which represents the most recent and thorough assessment of the status of high-field magnets for accelerator magnets, is presented