Biodegradable polycaprolactone-chitosan three-dimensional scaffolds fabricated by melt stretching and multilayer deposition for bone tissue engineering: Assessment of the physical properties and cellular response

Fabrication of polycaprolactone (PCL)-chitosan (CS) three-dimensional (3D) scaffolds using the novel technique of melt stretching and multilayer deposition was introduced. In brief, firstly, the PCL-CS monofilaments containing 0% (pure PCL), 10%, 20% and 30% CS by weight were fabricated by melting and stretching processes. Secondly, the desired multilayer (3D) scaffolds were fabricated by arranging and depositing the filaments. Physical properties of the filaments and the scaffolds were evaluated. MC3T3-E1 cell lines were seeded on the scaffolds to assess their proliferation. A typical micro-groove pattern was found on the surfaces of pure PCL filaments due to stretching. The filaments of PCL-30%CS had the highest tendency of fracture during stretching and could not be used to form the scaffold. Increasing CS proportions tended to reduce the micro-groove pattern, surface roughness, tensile strength and elasticity of the filaments, whilst compressive strength of the PCL-CS scaffolds was not affected. The average pore size and porosity of the scaffolds were 536.90 ± 17.91 μm and 45.99 ± 2.8% respectively. Over 60 days, degradation of the scaffolds gradually increased (p > 0.05). The more CS containing scaffolds were found to increase in water uptake, but decrease in degradation rate. During the culture period, the growth of the cells in PCL-CS groups was significantly higher than in the pure PCL group (p < 0.05). On culture-day 21, the growth in the PCL-20%CS group was significantly higher than the other groups (p < 0.05). In conclusion, the PCL-20%CS scaffolds obtained the optimum results in terms of physical properties and cellular response. © 2011 IOP Publishing Ltd.link_to_subscribed_fulltex

A preliminary study of the effect of low intensity pulsed ultrasound on new bone formation during mandibular distraction osteogenesis in rabbits

This study assesses the effect of low intensity pulsed ultrasound (LIPUS) on new bone formation during mandibular distraction osteogenesis (DO) in rabbits. 24 rabbits underwent DO on the right side of the mandible. 12 rabbits received a daily 20-min LIPUS (1.5 MHz, 30 mW/cm2) treatment on the first day of the distraction until they were killed at week 0 (immediately after the distraction), week 2 and week 4 after the distraction. Four rabbits were killed at each time point. The other 12 rabbits followed the same protocol without the ultrasound treatment. A plain radiography, a micro-CT scan, a microhardness test and a histological examination were used to evaluate new bone formation in the distraction gap. At week 0 and week 2 after the distraction, the treatment groups showed higher radiopacity and microhardness (p<0.05), and more bone formation was detected by the histological examination. At week 4 after the distraction, there was no statistical difference between the two groups. In this study, LIPUS accelerated new bone formation during the distraction period and 2 weeks after the distraction, which implies that the effective time for using LIPUS is in the early stage of DO.link_to_subscribed_fulltex