19 research outputs found
Interface characteristics and hot deformation behavior of duplex stainless steels
The phase transformation, precipitation and hot deformation behavior of duplex stainless steel has been studied. The knowledge produced will enable materials scientist and engineers to manipulate the microstructure of these steels to improve the property of interest.<br /
Intergranular precipitation and chemical fluctuations in an additively manufactured 2205 duplex stainless steel
Fluctuations in energy distribution during additive manufacturing (AM) can result in spatial and temporal thermal transients. These transients can lead to complexities, most significantly when alloys with multi phases are subjected to AM. Here we unveil such complexities in a duplex stainless steel, where we report an unanticipated formation of a Ni-Mn-Si rich phase at grain boundaries and a local fluctuation in Cr and Fe concentrations in regions close to grain boundaries, providing Cr-rich precursors for Cr2N formation after laser powder bed fusion (LPBF). The formation of these phases is believed to be due to severe thermal gyrations and thermal stresses associated with LPBF resulting in a high-volume fraction of ferrite supersaturated with N and Ni, and a high density of dislocations accelerating diffusion and phase transformations
Physically-based constitutive modelling of hot deformation behavior in a LDX 2101 duplex stainless steel
The flow behavior modeling of cast A356 aluminum alloy at elevated temperatures considering the effect of strain
Additive manufacturing of steels: a review of achievements and challenges
Metal additive manufacturing (AM), also known as 3D printing, is a disruptive manufacturing technology in which complex engineering parts are produced in a layer-by-layer manner, using a high-energy heating source and powder, wire or sheet as feeding material. The current paper aims to review the achievements in AM of steels in its ability to obtain superior properties that cannot be achieved through conventional manufacturing routes, thanks to the unique microstructural evolution in AM. The challenges that AM encounters are also reviewed, and suggestions for overcoming these challenges are provided if applicable. We focus on laser powder bed fusion and directed energy deposition as these two methods are currently the most common AM methods to process steels. The main foci are on austenitic stainless steels and maraging/precipitation-hardened (PH) steels, the two so far most widely used classes of steels in AM, before summarising the state-of-the-art of AM of other classes of steels. Our comprehensive review highlights that a wide range of steels can be processed by AM. The unique microstructural features including hierarchical (sub)grains and fine precipitates induced by AM result in enhancements of strength, wear resistance and corrosion resistance of AM steels when compared to their conventional counterparts. Achieving an acceptable ductility and fatigue performance remains a challenge in AM steels. AM also acts as an intrinsic heat treatment, triggering ‘in situ’ phase transformations including tempering and other precipitation phenomena in different grades of steels such as PH steels and tool steels. A thorough discussion of the performance of AM steels as a function of these unique microstructural features is presented in this review