Effect of niobium on the directional solidification and properties of alnico alloys

The effect of niobium on the extent of columnar growth of grains and on the magnetic properties in Alnico alloys has been studied. Alloys containing 1 % Nb show maximum growth of columnar crystals. In columnar alloys, coercivity increases slowly with increasing niobium content up to approximately 1 %. With further increase in niobium, coercivity and remanence decrease. The maximum energy product (55 kJ m-3) has been obtained at 1 % Nb. Niobium addition has also been found to suppress the precipitation of the undesirable gamma phase

Size-dependent electronic-transport mechanism and sign reversal of magnetoresistance in Nd0.5Sr0.5CoO3

A detailed investigation of electronic-transport properties of Nd0.5Sr0.5CoO3 has been carried out as a function of grain size ranging from micrometer order down to an average size of 28 nm. Interestingly, we observe a size induced metal-insulator transition in the lowest grain size sample while the bulk-like sample is metallic in the whole measured temperature regime. An analysis of the temperature dependent resistivity in the metallic regime reveals that the electron-electron interaction is the dominating mechanism while other processes like electron-magnon and electron-phonon scatterings are also likely to be present. The fascinating observation of enhanced low temperature upturn and minimum in resistivity on reduction of grain size is found due to electron-electron interaction (quantum interference effect). This effect is attributed to enhanced disorder on reduction of grain size. Interestingly, we observed a cross over from positive to negative magnetoresistance in the low temperature regime as the grain size is reduced. This observed sign reversal is attributed to enhanced phase separation on decreasing the grain size of the cobaltite

Developments of rubber material wear in conveyer belt system

Regular degradation of rubbers contribute frequent maintenance of conveyer belt system. This paper investigates wear rate and mechanisms of rubber and associated influential parameters based on the information available in literature. Abrasion, fatigue and roll formation are dominate wear mechanisms that are influenced by load, sliding velocity, hardness and friction. Correlations among influential parameters and their effect on rubber wear was established in details. Archad's equation does not work for rubber wear but researchers have proposed equations similar to that. Adhesion wear forms roll in the smooth surface when tear strength of rubber is low. Wear caused by adhesion is abrasion when surface texture is harsh. Hysteresis enhances fatigue wear if the substrate asperities are round or blunt

Tissue temperature monitoring using thermoacoustic and photoacoustic techniques

Real-time temperature monitoring with high spatial resolution (~1 mm) and high temperature sensitivity (1 °C or better) is needed for the safe deposition of heat energy in surrounding healthy tissue and efficient destruction of tumor and abnormal cells during thermotherapy. A temperature sensing technique using thermoacoustic and photoacoustic measurements combined with a clinical Philips ultrasound imaging system (iU22) has been explored in this study. Using a tissue phantom, this noninvasive method has been demonstrated to have high temporal resolution and temperature sensitivity. Because both photoacoustic and thermoacoustic signal amplitudes depend on the temperature of the source object, the signal amplitudes can be used to monitor the temperature. The signal is proportional to the dimensionless Grueneisen parameter of the object, which in turn varies with the temperature of the object. A temperature sensitivity of 0.5 °C was obtained at a temporal resolution as short as 3.6 s with 50 signal averages

Single spin universal Boolean logic

Recent advances in manipulating single electron spins in quantum dots have brought us close to the realization of classical logic gates based on representing binary bits in spin polarizations of single electrons. Here, we show that a linear array of three quantum dots, each containing a single spin polarized electron, and with nearest neighbor exchange coupling, acts as the universal NAND gate. The energy dissipated during switching this gate is the Landauer-Shannon limit of kTln(1/p) [T = ambient temperature and p = intrinsic gate error probability]. With present day technology, p = 1E-9 is achievable above 1 K temperature. Even with this small intrinsic error probability, the energy dissipated during switching the NAND gate is only ~ 21 kT, while today's nanoscale transistors dissipate about 40,000 - 50,000 kT when they switch

The interparticle interaction and crossover in critical lines on field-temperature plane in Pr0.5_{0.5}Sr0.5_{0.5}MnO3_{3} nanoparticles

The magnetic properties and the effects of interparticle interaction on it have been studied in nanoparticles of half doped Pr$_{0.5}$Sr$_{0.5}$MnO$_{3}$. Three samples consisting of nanoparticles of different average particle sizes are synthesized to render the variation in interparticle interaction. Though all the samples crystallize in the same structure to that of their bulk compound, the low temperature ferromagnetic-antiferromagnetic transition, which is present in bulk compound, is not evident in the nanoparticles. Linear as well as nonlinear ac susceptibility coupled with dc magnetic measurements have shown the superparamagnetic behavior of these nanoparticles where the blocking temperature increases with the increasing particle size. Presence of interparticle interaction is confirmed from the temperature variation of coercive field and the analysis of frequency dependent ac susceptibility. We have identified the nature of this interaction to be of dipolar type, and show that its strength decreases with the increasing particle size. The effect of this dipolar interaction on magnetic properties is intriguing as the compounds exhibit crossover from de Almeida-Thouless to Gabay-Toulouse like critical lines on field-temperature plane above their respective interaction field. In agreement with theoretical prediction, we infer that this crossover is induced by the unidirectional anisotropy arising from interparticle interaction, and this is confirmed from the presence of exchange bias phenomenon.Comment: To appear in Phys. Rev.