81 research outputs found
Momentum dependence of the superconducting gap and in-gap states in MgB2 multi-band superconductor
We use tunable laser based Angle Resolved Photoemission Spectroscopy to study
the electronic structure of the multi-band superconductor, MgB2. These results
form the base line for detailed studies of superconductivity in multi-band
systems. We find that the magnitude of the superconducting gap on both sigma
bands follows a BCS-like variation with temperature with Delta0 ~7 meV. The
value of the gap is isotropic within experimental uncertainty and in agreement
with pure a s-wave pairing symmetry. We also observe in-gap states confined to
kF of the sigma band that occur at some locations of the sample surface. The
energy of this excitation, ~3 meV, is inconsistent with scattering from the pi
band.Comment: 6 pages, 4 figure
Three-dimensionality of the bulk electronic structure in WTe2
We use temperature- and field-dependent resistivity measurements
[Shubnikov--de Haas (SdH) quantum oscillations] and ultrahigh resolution,
tunable, vacuum ultraviolet (VUV) laser-based angle-resolved photoemission
spectroscopy (ARPES) to study the three-dimensionality (3D) of the bulk
electronic structure in WTe2, a type-II Weyl semimetal. The bulk Fermi surface
(FS) consists of two pairs of electron pockets and two pairs of hole pockets
along the X-Gamma-X direction as detected by using an incident photon energy of
6.7 eV, which is consistent with the previously reported data. However, if
using an incident photon energy of 6.36 eV, another pair of tiny electron
pockets is detected on both sides of the Gamma point, which is in agreement
with the small quantum oscillation frequency peak observed in the
magnetoresistance. Therefore, the bulk, 3D FS consists of three pairs of
electron pockets and two pairs of hole pockets in total. With the ability of
fine tuning the incident photon energy, we demonstrate the strong
three-dimensionality of the bulk electronic structure in WTe2. The combination
of resistivity and ARPES measurements reveal the complete, and consistent,
picture of the bulk electronic structure of this material.Comment: 6 pages, 3 figure
Observation of Fermi Arcs in Type-II Weyl Semimetal Candidate WTe2
We use ultrahigh resolution, tunable, vacuum ultraviolet laser angle-resolved
photoemission spectroscopy (ARPES) to study the electronic properties of
WTe, a material that was predicted to be a type-II Weyl semimetal. The Weyl
fermion states in WTe2 were proposed to emerge at the crossing points of
electron and hole pockets; and Fermi arcs connecting electron and hole pockets
would be visible in the spectral function on (001) surface. Here we report the
observation of such Fermi arcs in WTe2 confirming the theoretical predictions.
This provides strong evidence for type-II Weyl semimetallic states in WTe2.Comment: 5 pages, 4 figure
Electronic structure of RSb (R = Y, Ce, Gd, Dy, Ho, Tm, Lu) studied by angle-resolved photoemission spectroscopy
We use high resolution angle-resolved photoemission spectroscopy (ARPES) and
electronic structure calculations to study the electronic properties of
rare-earth monoantimonides RSb (R = Y, Ce, Gd, Dy, Ho, Tm, Lu). The
experimentally measured Fermi surface (FS) of RSb consists of at least two
concentric hole pockets at the point and two intersecting electron
pockets at the point. These data agree relatively well with the electronic
structure calculations. Detailed photon energy dependence measurements using
both synchrotron and laser ARPES systems indicate that there is at least one
Fermi surface sheet with strong three-dimensionality centered at the
point. Due to the "lanthanide contraction", the unit cell of different
rare-earth monoantimonides shrinks when changing rare-earth ion from CeSb to
LuSb. This results in the differences in the chemical potentials in these
compounds, which is demonstrated by both ARPES measurements and electronic
structure calculations. Interestingly, in CeSb, the intersecting electron
pockets at the point seem to be touching the valence bands, forming a
four-fold degenerate Dirac-like feature. On the other hand, the remaining
rare-earth monoantimonides show significant gaps between the upper and lower
bands at the point. Furthermore, similar to the previously reported results
of LaBi, a Dirac-like structure was observed at the point in YSb,
CeSb, and GdSb, compounds showing relatively high magnetoresistance. This
Dirac-like structure may contribute to the unusually large magnetoresistance in
these compounds.Comment: 8 figure
Temperature induced Lifshitz transition in WTe2
We use ultra-high resolution, tunable, VUV laser-based, angle-resolved
photoemission spectroscopy (ARPES) and temperature and field dependent
resistivity and thermoelectric power (TEP) measurements to study the electronic
properties of WTe2, a compound that manifests exceptionally large, temperature
dependent magnetoresistance. The temperature dependence of the TEP shows a
change of slope at T=175 K and the Kohler rule breaks down above 70-140 K
range. The Fermi surface consists of two electron pockets and two pairs of hole
pockets along the X-Gamma-X direction. Upon increase of temperature from 40K,
the hole pockets gradually sink below the chemical potential. Like BaFe2As2,
WTe2 has clear and substantial changes in its Fermi surface driven by modest
changes in temperature. In WTe2, this leads to a rare example of temperature
induced Lifshitz transition, associated with the complete disappearance of the
hole pockets. These dramatic changes of the electronic structure naturally
explain unusual features of the transport data.Comment: 5 pages, 3 figure
- …