Solitary fibrous tumour of the pleura: surgical treatment

OBJECTIVE: Solitary fibrous tumours (SFT) of the pleura are rare tumours originated from the mesenchimal tissue underlying the mesothelial layer of the pleura. This tumours present unpredictable clinical course probably related to their histological and morphological characteristics. METHODS: Twenty-one patients affected by SFT of the pleura were referred to us for surgical resection from September 1984 to April 2000. They were 15 males and six females with median age of 51 (range 15--73) years. Nine patients (43%) were symptomatic and predominant clinical symptoms or signs were dyspnoea (19%), coughing (14.3%), chest pain (28.5%), finger clubbing (14.3%) and hypoglycaemia (14.3%). Hypoglycaemia was related to a pathological incretion of insulin-like growth factor 2 by the tumour. Chest radiograph and computed tomography of the chest revealed intra-thoracic homogeneous sharply delineated round or lobulated mass sometimes associated with ipsilateral pleural effusion (19%) or causing pulmonary atelectasis with opacification of the complete hemithorax (19%). Surgical excision required 14 posterolateral thoracotomies, six anterior thoracotomies and one video-assisted thoracoscopy. Thirteen tumours arose from visceral pleura and wedge resection was performed, seven tumours arose from parietal pleura and extrapleural resection was carried out without any chest-wall resection, one tumour growth within the upper left lobe and required lobectomy. Tumours weighted from 22 to 1942 g and measured from 22x12x8 to 330x280x190 mm. At cut section seven cases (34%) revealed focal necrosis and hemorrhagic zones and on light microscopy six cases (28.5%) were characterized by high mitotic count: characteristics related with uncertain clinical behaviour. Immuno-histochemical reactions were in all cases positive for CD34. RESULTS: In all our patients resections were complete. Paraneoplastic syndromes like hypoglycaemia and clubbing receded after surgery. No intraoperative or perioperative medical or surgical complications occurred. Median chest-drain duration timed 3 (range 2--5) days and median hospital stay was 5 (range 4--7) days. Perioperative mortality rate was 0%. Median follow-up was 68 (range 2--189) months: during this period patients were submitted to chest X-ray with 6-months interval to evaluate possible local recurrence. Only one patient experienced tumour recurrence after 124 months follow-up: the tumour was suspected after observation of finger clubbing. The tumour was detected and excised by redo-thoracotomy. CONCLUSIONS: Surgical resection of benign solitary fibrous tumours is usually curative, but local recurrences can occur years after seemingly adequate surgical treatment. Malignant solitary fibrous tumours generally have a poor prognosis. Clinical follow-up and radiological follow-up are indicated for both benign and malignant solitary fibrous tumours

Comparison of anticoagulation quality between acenocoumarol and warfarin in patients with mechanical prosthetic heart valves: Insights from the nationwide PLECTRUM study

Vitamin K antagonists are indicated for the thromboprophylaxis in patients with mechanical prosthetic heart valves (MPHV). However, it is unclear whether some differences between acenocoumarol and warfarin in terms of anticoagulation quality do exist. We included 2111 MPHV patients included in the nationwide PLECTRUM registry. We evaluated anticoagulation quality by the time in therapeutic range (TiTR). Factors associated with acenocoumarol use and with low TiTR were investigated by multivariable logistic regression analysis. Mean age was 56.8 ± 12.3 years; 44.6% of patients were women and 395 patients were on acenocoumarol. A multivariable logistic regression analysis showed that patients on acenocoumarol had more comorbidities (i.e., ≥3, odds ratio (OR) 1.443, 95% confidence interval (CI) 1.081-1.927, p = 0.013). The mean TiTR was lower in the acenocoumarol than in the warfarin group (56.1 ± 19.2% vs. 61.6 ± 19.4%, p < 0.001). A higher prevalence of TiTR (<60%, <65%, or <70%) was found in acenocoumarol users than in warfarin ones (p < 0.001 for all comparisons). Acenocoumarol use was associated with low TiTR regardless of the cutoff used at multivariable analysis. A lower TiTR on acenocoumarol was found in all subgroups of patients analyzed according to sex, hypertension, diabetes, age, valve site, atrial fibrillation, and INR range. In conclusion, anticoagulation quality was consistently lower in MPHV patients on acenocoumarol compared to those on warfarin

Science and society in education

This booklet is for teachers who want to expand their teaching approaches to include socio-scientific issues which enrich and give meaning to core scientific principles. It is meant to enhance young people’s curiosity about the social and scientific world and raise important questions about issues which affect their lives. We call this approach Socio-Scientific Inquiry-Based Learning, or ‘SSIBL’ for short. Chapters 1 and 2 present an introduction to the theoretical background of SSIBL. In chapter 3, SSIBL will be approached from a classroom perspective, providing a simplified version of the framework and showing teaching examples

Does morbid obesity influence perioperative outcomes after video-assisted thoracic surgery (VATS) lobectomy for non-small cell lung cancer? Analysis of the Italian VATS group registry

Objectives: Obesity in Europe, and worldwide, has been an increasing epidemic during the past decades. Moreover, obesity has important implications regarding technical issues and the risks associated with surgical interventions. Nevertheless, there is a lack of evidence assessing the influence of obesity on video-assisted thoracic surgery (VATS) lobectomy results. Our study aimed to assess the impact of morbid obesity on perioperative clinical and oncological outcomes after VATS lobectomy using a prospectively maintained nationwide registry. Methods: The Italian VATS lobectomy Registry was used to collect all consecutive cases from 55 Institutions. Explored outcome parameters were conversion to thoracotomy rates, complication rates, intra-operative blood loss, surgical time, hospital postoperative length of stay, chest tube duration, number of harvested lymph-node, and surgical margin positivity. Results: From 2016 to 2019, a total of 4412 patients were collected. 74 patients present morbid obesity (1.7%). Multivariable-adjusted analysis showed that morbid obesity was associated with a higher rate of complications (32.8% vs 20.3%), but it was not associated with a higher rate of conversion, and surgical margin positivity rates. Moreover, morbid obesity patients benefit from an equivalent surgical time, lymph-node retrieval, intraoperative blood loss, hospital postoperative length of stay, and chest tube duration than non-morbid obese patients. The most frequent postoperative complications in morbidly obese patients were pulmonary-related (35%). Conclusion: Our results showed that VATS lobectomy could be safely and satisfactorily conducted even in morbidly obese patients, without an increase in conversion rate, blood loss, surgical time, hospital postoperative length of stay, and chest tube duration. Moreover, short-term oncological outcomes were preserved

Selection of the silicon sensor thickness for the Phase-2 upgrade of the CMS Outer Tracker

During the operation of the CMS experiment at the High-Luminosity LHC the silicon sensors of the Phase-2 Outer Tracker will be exposed to radiation levels that could potentially deteriorate their performance. Previous studies had determined that planar float zone silicon with n-doped strips on a p-doped substrate was preferred over p-doped strips on an n-doped substrate. The last step in evaluating the optimal design for the mass production of about 200 m$^{2}$ of silicon sensors was to compare sensors of baseline thickness (about 300 μm) to thinned sensors (about 240 μm), which promised several benefits at high radiation levels because of the higher electric fields at the same bias voltage. This study provides a direct comparison of these two thicknesses in terms of sensor characteristics as well as charge collection and hit efficiency for fluences up to 1.5 × 10$^{15}$ n$_{eq}$/cm$^{2}$. The measurement results demonstrate that sensors with about 300 μm thickness will ensure excellent tracking performance even at the highest considered fluence levels expected for the Phase-2 Outer Tracker

The CMS Phase-1 pixel detector upgrade

The CMS detector at the CERN LHC features a silicon pixel detector as its innermost subdetector. The original CMS pixel detector has been replaced with an upgraded pixel system (CMS Phase-1 pixel detector) in the extended year-end technical stop of the LHC in 2016/2017. The upgraded CMS pixel detector is designed to cope with the higher instantaneous luminosities that have been achieved by the LHC after the upgrades to the accelerator during the first long shutdown in 2013–2014. Compared to the original pixel detector, the upgraded detector has a better tracking performance and lower mass with four barrel layers and three endcap disks on each side to provide hit coverage up to an absolute value of pseudorapidity of 2.5. This paper describes the design and construction of the CMS Phase-1 pixel detector as well as its performance from commissioning to early operation in collision data-taking.Peer reviewe

Test beam performance of a CBC3-based mini-module for the Phase-2 CMS Outer Tracker before and after neutron irradiation

The Large Hadron Collider (LHC) at CERN will undergo major upgrades to increase the instantaneous luminosity up to 5–7.5×10$^{34}$ cm$^{-2}$s$^{-1}$. This High Luminosity upgrade of the LHC (HL-LHC) will deliver a total of 3000–4000 fb-1 of proton-proton collisions at a center-of-mass energy of 13–14 TeV. To cope with these challenging environmental conditions, the strip tracker of the CMS experiment will be upgraded using modules with two closely-spaced silicon sensors to provide information to include tracking in the Level-1 trigger selection. This paper describes the performance, in a test beam experiment, of the first prototype module based on the final version of the CMS Binary Chip front-end ASIC before and after the module was irradiated with neutrons. Results demonstrate that the prototype module satisfies the requirements, providing efficient tracking information, after being irradiated with a total fluence comparable to the one expected through the lifetime of the experiment

Comparative evaluation of analogue front-end designs for the CMS Inner Tracker at the High Luminosity LHC

The CMS Inner Tracker, made of silicon pixel modules, will be entirely replaced prior to the start of the High Luminosity LHC period. One of the crucial components of the new Inner Tracker system is the readout chip, being developed by the RD53 Collaboration, and in particular its analogue front-end, which receives the signal from the sensor and digitizes it. Three different analogue front-ends (Synchronous, Linear, and Differential) were designed and implemented in the RD53A demonstrator chip. A dedicated evaluation program was carried out to select the most suitable design to build a radiation tolerant pixel detector able to sustain high particle rates with high efficiency and a small fraction of spurious pixel hits. The test results showed that all three analogue front-ends presented strong points, but also limitations. The Differential front-end demonstrated very low noise, but the threshold tuning became problematic after irradiation. Moreover, a saturation in the preamplifier feedback loop affected the return of the signal to baseline and thus increased the dead time. The Synchronous front-end showed very good timing performance, but also higher noise. For the Linear front-end all of the parameters were within specification, although this design had the largest time walk. This limitation was addressed and mitigated in an improved design. The analysis of the advantages and disadvantages of the three front-ends in the context of the CMS Inner Tracker operation requirements led to the selection of the improved design Linear front-end for integration in the final CMS readout chip

Beam test performance of a prototype module with Short Strip ASICs for the CMS HL-LHC tracker upgrade

The Short Strip ASIC (SSA) is one of the four front-end chips designed for the upgrade of the CMS Outer Tracker for the High Luminosity LHC. Together with the Macro-Pixel ASIC (MPA) it will instrument modules containing a strip and a macro-pixel sensor stacked on top of each other. The SSA provides both full readout of the strip hit information when triggered, and, together with the MPA, correlated clusters called stubs from the two sensors for use by the CMS Level-1 (L1) trigger system. Results from the first prototype module consisting of a sensor and two SSA chips are presented. The prototype module has been characterized at the Fermilab Test Beam Facility using a 120 GeV proton beam

Search for a vector-like quark T′ → tH via the diphoton decay mode of the Higgs boson in proton-proton collisions at s \sqrt{s} = 13 TeV

A search for the electroweak production of a vector-like quark T′, decaying to a top quark and a Higgs boson is presented. The search is based on a sample of proton-proton collision events recorded at the LHC at = 13 TeV, corresponding to an integrated luminosity of 138 fb−1. This is the first T′ search that exploits the Higgs boson decay to a pair of photons. For narrow isospin singlet T′ states with masses up to 1.1 TeV, the excellent diphoton invariant mass resolution of 1–2% results in an increased sensitivity compared to previous searches based on the same production mechanism. The electroweak production of a T′ quark with mass up to 960 GeV is excluded at 95% confidence level, assuming a coupling strength κT = 0.25 and a relative decay width Γ/MT′ < 5%