300 research outputs found
QCDOC: A 10-teraflops scale computer for lattice QCD
The architecture of a new class of computers, optimized for lattice QCD
calculations, is described. An individual node is based on a single integrated
circuit containing a PowerPC 32-bit integer processor with a 1 Gflops 64-bit
IEEE floating point unit, 4 Mbyte of memory, 8 Gbit/sec nearest-neighbor
communications and additional control and diagnostic circuitry. The machine's
name, QCDOC, derives from ``QCD On a Chip''.Comment: Lattice 2000 (machines) 8 pages, 4 figure
The Influence of Orthopedic Surgery on Circulating Metabolite Levels, and their Associations with the Incidence of Postoperative Delirium
The mechanisms underlying the occurrence of postoperative delirium development are unclear and measurement of plasma metabolites may improve understanding of its causes. Participants (n = 54) matched for age and gender were sampled from an observational cohort study investigating postoperative delirium. Participants were ≥65 years without a diagnosis of dementia and presented for primary elective hip or knee arthroplasty. Plasma samples collected pre-and postoperatively were grouped as either control (n = 26, aged: 75.8 ± 5.2) or delirium (n = 28, aged: 76.2 ± 5.7). Widespread changes in plasma metabolite levels occurred following surgery. The only metabolites significantly differing between corresponding control and delirium samples were ornithine and spermine. In delirium cases, ornithine was 17.6% higher preoperatively, and spermine was 12.0% higher postoperatively. Changes were not associated with various perioperative factors. In binary logistic regression modeling, these two metabolites did not confer a significantly increased risk of delirium. These findings support the hypothesis that disturbed polyamine metabolism is an underlying factor in delirium that warrants further investigation
Quenched Lattice QCD with Domain Wall Fermions and the Chiral Limit
Quenched QCD simulations on three volumes, , and
and three couplings, , 5.85 and 6.0 using domain
wall fermions provide a consistent picture of quenched QCD. We demonstrate that
the small induced effects of chiral symmetry breaking inherent in this
formulation can be described by a residual mass (\mres) whose size decreases
as the separation between the domain walls () is increased. However, at
stronger couplings much larger values of are required to achieve a given
physical value of \mres. For and , we find
\mres/m_s=0.033(3), while for , and ,
\mres/m_s=0.074(5), where is the strange quark mass. These values are
significantly smaller than those obtained from a more naive determination in
our earlier studies. Important effects of topological near zero modes which
should afflict an accurate quenched calculation are easily visible in both the
chiral condensate and the pion propagator. These effects can be controlled by
working at an appropriately large volume. A non-linear behavior of in
the limit of small quark mass suggests the presence of additional infrared
subtlety in the quenched approximation. Good scaling is seen both in masses and
in over our entire range, with inverse lattice spacing varying between
1 and 2 GeV.Comment: 91 pages, 34 figure
Domain wall fermion zero modes on classical topological backgrounds
The domain wall approach to lattice fermions employs an additional dimension,
in which gauge fields are merely replicated, to separate the chiral components
of a Dirac fermion. It is known that in the limit of infinite separation in
this new dimension, domain wall fermions have exact zero modes, even for gauge
fields which are not smooth. We explore the effects of finite extent in the
fifth dimension on the zero modes for both smooth and non-smooth topological
configurations and find that a fifth dimension of around ten sites is
sufficient to clearly show zero mode effects. This small value for the extent
of the fifth dimension indicates the practical utility of this technique for
numerical simulations of QCD.Comment: Updated fig. 3-7, small changes in sect. 3, added fig. 8, added more
reference
Localization and chiral symmetry in 2+1 flavor domain wall QCD
We present results for the dependence of the residual mass of domain wall
fermions (DWF) on the size of the fifth dimension and its relation to the
density and localization properties of low-lying eigenvectors of the
corresponding hermitian Wilson Dirac operator relevant to simulations of 2+1
flavor domain wall QCD. Using the DBW2 and Iwasaki gauge actions, we generate
ensembles of configurations with a space-time volume and an
extent of 8 in the fifth dimension for the sea quarks. We demonstrate the
existence of a regime where the degree of locality, the size of chiral symmetry
breaking and the rate of topology change can be acceptable for inverse lattice
spacings GeV.Comment: 59 Pages, 23 figures, 1 MPG linke
Super Yang-Mills on the lattice with domain wall fermions
The dynamical N=1, SU(2) Super Yang-Mills theory is studied on the lattice
using a new lattice fermion regulator, domain wall fermions. This formulation
even at non-zero lattice spacing does not require fine-tuning, has improved
chiral properties and can produce topological zero-mode phenomena. Numerical
simulations of the full theory on lattices with the topology of a torus
indicate the formation of a gluino condensate which is sustained at the chiral
limit. The condensate is non-zero even for small volume and small supersymmetry
breaking mass where zero mode effects due to gauge fields with fractional
topological charge appear to play a role.Comment: LaTeX, 35 pages, 11 eps figures. A few changes in sec. 5.3, figure 11
added. To appear in Phys. Rev.
- …