Spatial Characteristics of Water Spray Formed by Two Impinging Jets at Several Jet Velocities in Quiescent Air

The spatial characteristics of a spray formed by two impinging water jets in quiescent air were studied over a range of nominal jet velocities of 30 to 74 feet per second. The total included angle between the 0.089-inch jets was 90 deg. The jet velocity, spray velocity, disappearance of the ligaments just before drop formation, mass distribution, and size and position of the largest drops were measured in a circumferential survey around the point of jet impingement. Photographic techniques were used in the evaluations. The distance from the point of jet impingement to ligament breakup into drops was about 4 inches on the spray axis and about 1.3 inches in the radial position +/-90 deg from the axis. The distance tended to increase slightly with increase in jet velocity. The spray velocity varied from about 99 to about 72 percent of the jet velocity for a change in circumferential position from the spray axis to the +/-80 deg positions. The percentages tended to increase slightly with an increase in jet velocity. Fifty percent of the mass was distributed about the spray axis in an included angle of slightly less than 40 deg. The effect of jet velocity was small. The largest observed drops (2260-micron or 0.090-in. diam.) were found on and about the spray axis. The size of the largest drops decreased for an increase in radial angular position, being about 1860 microns (0.074 in.) at the +/-90 deg positions. The largest drop sizes tended to decrease for an increase in jet velocity, although the velocity effect was small. A drop-size distribution analysis indicated a mass mean drop size equal to 54 percent of an extrapolated maximum drop size

NACA Technical Notes

Report presenting an investigation of a turbine and propeller to determine the conditions of maximum-efficiency operation when utilized as an independent turbine-propeller combination. The procedure used to determine the conditions of maximum efficiency and speed ratio between the turbine and propeller is described

NACA Technical Notes

From Introduction: "The design of turbojet-engine control systems is intimately related to the dynamic characteristics of the engine and has advanced to the stage where theoretically correct control constants can be determined for fixed dynamic properties (references 1 and 2). The use of the thermodynamic equations presupposes that the engine processes are quansi-static. Such an assumption is shown to be valid for a turbojet engine in references 3 and 4