An early stage in the transition of the intestine from the umbilical cord

No Abstrac

Radiation effects on beta 10.6 of pure and europium doped KCl

Changes in the optical absorption coefficient as a result of X-ray and electron bombardment of pure KCl (monocrystalline and polycrystalline), and divalent europium doped polycrystalline KCl were determined. The optical absorption coefficients were measured by a constant heat flow calorimetric method. Both 300 KV X-irradiation and 2 MeV electron irradiation produced significant increases in beta 10.6, measured at room temperature. The X-irradiation of pure moncrystalline KCl increased beta 10.6 by 0.005/cm for a 113 MR dose. For an equivalent dose, 2 MeV electrons were found less efficient in changing beta 10.6. However, electron irradiation of pure and Eu-doped polycrystalline KCl produced marked increases in adsorption. Beta increased to over 0.25/cm in Eu-doped material for a 30 x 10 to the 14th power electrons/sq cm dose, a factor of 20 increase over unirradiated material. Moreover, bleaching the electron irradiated doped KCl with 649 m light produced and additional factor of 1.5 increase. These findings will be discussed in light of known defect-center properties in KCl

Thermal degradation of the tensile strength of unidirectional boron/aluminum composites

The variation of ultimate tensile strength with thermal treatment of B-Al composite materials and of boron fibers chemically removed from these composites in an attempt to determine the mechanism of the resulting strength degradation was studied. Findings indicate that thermally cycling B-Al represents a more severe condition than equivalent time at temperature. Degradation of composite tensile strength from about 1.3 GN/m squared to as low as 0.34 GN/m squared was observed after 3,000 cycles to 420 C for 203 micrometers B-1100 Al composite. In general, the 1100 Al matrix composites degraded somewhat more than the 6061 matrix material studied. Measurement of fiber strengths confirmed a composite strength loss due to the degradation of fiber strength. Microscopy indicated a highly flawed fiber surface

Thermal environment effects on strength and impact properties of boron-aluminum composites

Thermal effects on fracture strength and impact energy were studied in 50 volume percent unidirectional composites of 143 and 203 micron boron fibers in 6061 and 1100 aluminum matrices. For 6061 matrix composites, strength was maintained to approximately 400 C in the cyclic tests and higher than 400 C in the static tests. For the 1100 matrix composites, strength degradation appeared near 260 C after cycling and higher than 260 C in static heating. This composite strength degradation is explained by a fiber degradation mechanism resulting from a boron-aluminum interface reaction. The impact energy absorption degraded significantly only above 400 C for both matrix alloys. Thus, while impact loss for the 6061 composite correlates with the fiber strength loss, other energy absorption processes appear to extend the impact resistance of the 1100 matrix composites to temperatures beyond where its strength is degraded. Interrupted impact tests on as-received and thermally cycled composites define the range of load over which the fibers break in the impact event

Airloads on bluff bodies, with application to the rotor-induced downloads on tilt-rotor aircraft

The aerodynamic characteristics of airfoils with several flap configurations were studied theoretically and experimentally in environments that simulate a wing immersed in the downwash of a hovering rotor. Special techniques were developed for correcting and validating the wind tunnel data for large blockage effects, and the test results were used to evaluate two modern blockage effects, and the test results were used to evaluate two modern computational aerodynamics codes. The combined computed and measured results show that improved flap and leading-edge configurations can be designed which will achieve large reductions in the downloads of tilt-rotor aircraft, and thereby improve their hover efficiency

Aseptic Barriers Allow a Clean Contact for Contaminated Stethoscope Diaphragms.

Objective:To determine whether a single-use stethoscope diaphragm barrier surface remains aseptic when placed on pathogen-contaminated stethoscopes. Methods:From May 31 to August 5, 2019, we tested 2 separate barriers using 3 different strains of 7 human pathogens, including extended-spectrum β-lactamase-producing Escherichia coli, methicillin-resistant Staphylococcus aureus, and vancomycin resistant Enterococcus faecium. Results:For all diaphragms with either of the 2 barriers tested, no growth was recorded for any of the pathogens. Stethoscopes with aseptic barriers remained sterile for up to 24 hours. These single-use barriers also provided aseptic surfaces when stethoscope diaphragms were inoculated with human specimens, including saliva, stool, urine, and sputum. Conclusion:Disposable aseptic diaphragm barriers may provide robust and efficient solutions to reduce transmission of pathogens via stethoscopes

Depressive symptoms in asymptomatic stage B heart failure with Type II diabetic mellitus.

BackgroundThe presence of concomitant Type II diabetic mellitus (T2DM) and depressive symptoms adversely affects individuals with symptomatic heart failure (HF).HypothesisIn presymptomatic stage B HF, this study hypothesized the presence of greater inflammation and depressive symptoms in T2DM as compared to non-T2DM Stage B patients.MethodsThis cross-sectional study examined clinical parameters, inflammatory biomarkers, and depressive symptoms in 349 T2DM and non-T2DM men with asymptomatic stage B HF (mean age 66.4 years ±10.1; range 30-91).ResultsFewer diabetic HF patients had left ventricular (LV) systolic dysfunction (P < .05) although more had LV diastolic dysfunction (P < .001). A higher percentage of T2DM HF patients were taking ACE-inhibitors, beta-blockers, calcium channel blockers, statins, and diuretics (P values < .05). T2DM HF patients had higher circulating levels of interleukin-6 (IL-6) (P < .01), tumor necrosis factor-alpha (P < .01), and soluble ST2 (sST2) (P < .01) and reported more somatic/affective depressive symptoms (Beck Depression Inventory II) (P < .05) but not cognitive/affective depressive symptoms (P = .20). Among all patients, in a multiple regression analysis predicting presence of somatic/affective depressive symptoms, sST2 (P = .026), IL-6 (P = .010), B-type natriuretic peptide (P = .016), and sleep (Pittsburgh Sleep Quality Index [P < .001]) were significant predictors (overall model F = 15.39, P < .001, adjusted R2 = .207).ConclusionsSomatic/affective but not cognitive/affective depressive symptoms are elevated in asymptomatic HF patients with T2DM patients. Linkages with elevated inflammatory and cardiac relevant biomarkers suggest shared pathophysiological mechanisms among T2DM HF patients with somatic depression, and these conditions are responsive to routine interventions, including behavioral. Copyright © 2019 John Wiley & Sons, Ltd