The quadrupole resonator: Construction, RF System Field Calculations and First Applications

The quadrupole resonator allows measurement of the RF properties of superconducting (sc) films deposited on disk-shaped metallic substrates. We describe the construction of the apparatus, the brazing and electron-beam welding procedures, the arrangements for compensating mechanical tolerances of samples and for assuring reproducible sample illumination. We explain the special features of the RF sy stem and give the results of field calculations with a 3D cavity code. Finally we present first measurements of Nb on Cu film samples and compare them with calibrations done with a bulk Nb sample

Ion-stimulated gas desorption yields and their dependence on the surface preparation of stainless steel

Ion-induced gas desorption yields were investigated for 4.2 MeV/u lead ions incident on 316 LN stainless steel surfaces. Focussed on a possible application for the Low Energy Ion Ring (LEIR) vacuum system, the influence of surface treatments like chemical etching, electropolishing and gold-coating on the desorption yields was studied with accelerator-type vacuum chambers. The surface composition of similar prepared samples was investigated with X-ray Photoemission Spectroscopy (XPS). Desorption yields for H2, CH4, CO, Ar and CO2, which are of fundamental interest for LEIR and future accelerator applications, are reported as a function of impact angle, ion dose and charge state (+27, +53) of the lead ion beam

Electron Cloud Mitigation by Fast Bunch Compression in the CERN PS

A fast transverse instability has been observed with nominal LHC beams in the CERN Proton Synchrotron (PS) in 2006. The instability develops within less than 1 ms, starting when the bunch length decreases below a threshold of 11.5 ns during the RF procedure to shorten the bunches immediately prior to extraction. An alternative longitudinal beam manipulation, double bunch rotation, has been proposed to compress the bunches from 14 ns to the 4 ns required at extraction within 0.9 ms, saving some 4.5 ms with respect to the present compression scheme. The resultant bunch length is found to be equivalent for both schemes. In addition, electron cloud and vacuum measurements confirm that the development of an electron cloud and the onset of an associated fast pressure rise are delayed with the new compression scheme. Beam dynamics simulations and measurements of the double bunch rotation are presented as well as evidence for its beneficial effect from the electron cloud standpoint

Experimental Investigation of Impact-Induced Molecular Desorption by 4.2 MeV/u Pb ions

In preparation for the heavy ion program of the LHC, accumulation and cooling test with lead ion beams have been performed in the LEAR storage ring. These tests have revealed that due to the unexpected, large outgassing of the vacuum system, the dynamic pressure of the ring could not be maintained low enough to reach the required beam intensities. To determine the actions necessary to lower the dynamic pressure rise, an experimental program has been initiated for measuring the molecular desorption yields of stainless steel vacuum chambers by the impact of 4.2 MeV/u lead ions with the charge states +27 and +53. The test chambers were exposed either at grazing or at perpendicular incidence. Different surface treatments are reported in terms of the molecular desorption yields for H2, CH4, CO and CO2. Unpexpected large values of molecular yields per incident ion up to 2x104 molecules/ion have been observed. The implications of these results for the vacuum system of the future ion accumulator ring (LEIR) and possible remedies to reduce the vacuum degradation will be discussed

Radiation zoning for vacuum equipment of the CERN Large Hadron Collider

Beam losses in high-energy particle accelerators are responsible for beam lifetime degradation. In the LHC beam losses will create a shower of particles while interacting with materials from the beam pipes and surroundings, resulting in a partial activation of material in the tunnel. Efforts have been made during the accelerator design to monitor and to reduce the activation induced by beam losses. Traceability for all vacuum components has been established providing a tool to follow-up individually each component or subcomponents installed in the tunnel, regardless of their future destination e.g. recycling or disposal. In the latter case, the history of vacuum components will allow calculating the beam-induced activation and permit comparisons with in-situ and ex-situ measurements. This zoning will also help to reduce collective and individual radiation doses to personnel during interventions. The paper presents the vacuum system layout and describes the LHC vacuum zoning and its implementation using an ORACLE© database

Dependence of e-cloud on the longitudinal bunch profile: studies in the PS & extension to the HL-LHC

Recent studies have shown that the prospects for significantly increasing bunch intensities in the LHC for the luminosity upgrade (HL-LHC) may be severely limited by the available cryogenic cooling capacity and the electron-cloud (EC) driven beam instability. However, it is planned that during the HL-LHC era the bunch intensities in the LHC will go up by nearly a factor of two compared to the LHC-design values. This motivates the exploration of additional EC mitigation techniques that can be adopted in addition to those already in place. Preliminary simulations indicated that long flat bunches can be beneficial over Gaussian bunches to reduce the EC build up. Rigorous studies using realistic bunch profiles have never been done. Therefore, we have undertaken an in-depth investigation in the CERN 26 GeV PS to see if we can validate the previous findings and, in particular, if flattening the bunch can mitigate the EC. Here we present the results from dedicated EC measurements in the PS using a variety of bunch shapes and a comparison with simulations. Finally, we investigate if reshaping the bunch profiles using a 2nd harmonic rf cavity can mitigate EC in the HL-LHC

Measurement and analysis of SPS kicker magnet heating and outgassing with Different Bunch Spacing

Fast kicker magnets are used to inject beam into and eject beam out of the CERN SPS accelerator ring. These kickers are generally ferrite loaded transmission line type magnets with a rectangular shaped aperture through which the beam passes. Unless special precautions are taken the impedance of the ferrite yoke can provoke significant beam induced heating, over several hours, even above the Curie temperature of the ferrite. At present the nominal bunch spacing in the SPS is 25 ns, however for an early stage of LHC operation it is preferable to have 50 ns bunch spacing. Machine Development (MD) studies have been carried out with an inter-bunch spacing of 25 ns, 50 ns or 75 ns. For some of the SPS kicker magnets the 75 ns bunch spacing resulted in considerable beam induced heating. In addition the MDs showed that 50 ns bunch spacing could result in a very rapid pressure rise in the kicker magnet and thus cause an interlock. This paper discusses the MD observations of the SPS kickers and analyses the available data to provide explanations for the phenomena: possible remedies are also discussed

Whose Science and whose Religion? Reflections on the Relations between Scientific and Religious Worldviews

Arguments about the relationship between science and religion often proceed by identifying a set of essential characteristics of scientific and religious worldviews and arguing on the basis of these characteristics for claims about a relationship of conflict or compatibility between them. Such a strategy is doomed to failure because science, to some extent, and religion, to a much larger extent, are cultural phenomena that are too diverse in their expressions to be characterized in terms of a unified worldview. In this paper I follow a different strategy. Having offered a loose characterization of the nature of science, I pose five questions about specific areas where religious and scientific worldviews may conflict - questions about the nature of faith, the belief in a God or Gods, the authority of sacred texts, the relationship between scientific and religious conceptions of the mind/soul, and the relationship between scientific and religious understandings of moral behavior. My review of these questions will show that they cannot be answered unequivocally because there is no agreement amongst religious believers as to the meaning of important religious concepts. Thus, whether scientific and religious worldviews conflict depends essentially upon whose science and whose religion one is considering. In closing, I consider the implications of this conundrum for science education

Local Resection of Primary Tumor in Upfront Stage IV Breast Cancer

Background: This study aimed to identify the association of local surgery of the primary tumor in metastatic breast cancer (MBC) patients with overall survival (OS) and prognostic factors. Patients and Methods: Patients with primary MBC (1990-2006) were included in our retrospective analysis (n = 236). 83.1% had surgery for the primary tumor. OS was evaluated using Kaplan-Meier estimates. Predictive factors for OS were determined. Results: Median follow-up was 123 months for all patients still alive at the time of analysis. In univariate analysis, patients with surgery of the primary tumor had significantly prolonged OS (28.9 vs. 23.9 months). Within the surgery group, patients with MBC limited to 1 organ system had a better outcome (39.3 vs. 24.9 months), as did asymptomatic patients. Independent risk factors for shorter OS were hormone receptor negativity, symptoms, and involvement of > 1 organ system. Conclusion: Patient selection for local therapy was confounded by a more favorable profile and a lesser tumor burden before surgery, which might implicate a bias. Nevertheless, our univariate results indicate that local surgery of the primary tumor in MBC patients could be considered as part of the therapeutic regimen in selected patients. However, larger patient numbers are needed to prove these findings in the multivariate model. (C) 2016 S. Karger GmbH, Freibur