The turbulent burning velocity of iso-octane/air mixtures

Turbulent burning velocities of iso-octane air mixtures have been measured for expanding flame kernels within a turbulent combustion bomb. High speed schlieren images were used to derive turbulent burning velocity. Turbulent velocity measurements were made at u’ = 0.5, 1.0, 2.0, 4.0, 6.0 m/s, equivalence ratios of 0.8, 1.0, 1.2, 1.4 and pressures of P = 0.1, 0.5, 1.0 MPa. The turbulent burning velocity was found to increase with time and radius from ignition, this was attributed to turbulent flame development. The turbulent burning velocity increased with increasing rms turbulent velocity, and with pressure; although differences were found in the magnitude of this increase for different turbulent velocities. Generally, raising the equivalence ratio resulted in enhanced turbulent burning velocity, excepting measurements made at the lowest turbulent velocity. The results obtained in this study have been compared with those evaluated for a number turbulent burning velocity correlations and the differences are discussed

Laser ignition of iso-octane air aerosols

Iso-octane aerosols in air have been ignited with a focused Nd:YAG laser at pressures and temperatures of 100kPa and 270K and imaged using schlieren photography. The aerosol was generated using the Wilson cloud chamber technique. The droplet diameter, gas phase equivalence ratio and droplet number density were determined. The input laser energy and overall equivalence ratio were varied. For 270mJ pulse energies initial breakdown occurred at a number of sites along the laser beam axis. From measurements of the shock wave velocity it was found that energy was not deposited into the sites evenly. At pulse energies of 32mJ a single ignition site was observed. Overall fuel lean flames were observed to locally extinguish, however both stoichiometric and fuel rich flames were ignited. The minimum ignition energy was found to depend on the likelihood of a droplet existing at the focus of the laser beam

Cellular Flame Instabilities

The onset of Darrieus Landau and thermo-diffusive instabilities in an exploding spherical laminar flame is marked by the value of the Peclet number, Pecl, which is dependent upon the Markstein number. Values of Pecl for a number of different mixtures have been measured at 0.5 and 1.0 MPa in a spherical explosion bomb. These values are presented as a function of the flame speed Markstein number, Mab, and it is found that neither different pressures nor the different mixtures have a great effect on this correlation. Values derived from much larger scale atmospheric explosions of methane/air and propane/air also closely follow the same correlation. This suggests data from high pressure laboratory explosions might be used to predict the effects of large scale atmospheric explosions. Findings from other workers follow the same trend, although different detailed results can arise from both different definitions of Markstein number, and different measurement techniques. Because of the importance of a necessary minimal stretch rate to stabilise a flame, a more logical and fundamental criterion for the onset of this type of instability is one based on the flame stretch rate, such as a critical Karlovitz stretch factor, Kcl. As a result, the correlations are also expressed in terms of Kcl, instead of Pecl. As Masr becomes highly negative, the regime of stability is severely reduced

Variation of turbulent burning rate of methane, methanol, and iso-octane air mixtures with equivalence ratio at elevated pressure

Turbulent burning velocities for premixed methane, methanol, and iso-octane/air mixtures have been experimentally determined for an rms turbulent velocity of 2 m/s and pressure of 0.5 MPa for a wide range of equivalence ratios. Turbulent burning velocity data were derived using high-speed schlieren photography and transient pressure recording; measurements were processed to yield a turbulent mass rate burning velocity, utr. The consistency between the values derived using the two techniques, for all fuels for both fuel-lean and fuel-rich mixtures, was good. Laminar burning measurements were made at the same pressure, temperature, and equivalence ratios as the turbulent cases and laminar burning velocities and Markstein numbers were determined. The equivalence ratio (φ) for peak turbulent burning velocity proved not always coincident with that for laminar burning velocity for the same fuel; for isooctane, the turbulent burning velocity unexpectedly remained high over the range φ = 1 to 2. The ratio of turbulent to laminar burning velocity proved remarkably high for very rich iso-octane/air and lean methane/air mixtures

Burning Velocity and Markstein Length Blending Laws for Methane/Air and Hydrogen/Air Blends

Because of the contrasting chemical kinetics of methane and hydrogen combustion, the development of blending laws for laminar burning velocity, ul, and Markstein length for constituent mixtures of CH4/air and H2/air presents a formidable challenge. Guidance is sought through a study of analytical expressions for laminar burning velocity. For the prediction of burning velocities of blends, six blending laws were scrutinised. The predictions were compared with the measured burning velocities made by Hu et al. under atmospheric conditions [1]. These covered equivalence ratios ranging from 0.6 to 1.3, and the full fuel range for H2 addition to CH4. This enabled assessments to be made of the predictive accuracy of the six laws. The most successful law is one developed in the course of the present study, involving the mass fraction weighting of the product of ul, density, heat of reaction and specific heat, divided by the thermal conductivity of the mixture. There was less success from attempts to obtain a comparably successful blending law for the flame speed Markstein length, Lb, despite scrutiny of several possibilities. Details are given of two possible approaches, one based on the fractional mole concentration of the deficient reactant. A satisfactory empirical law employs mass fraction weighting of the product ulLb

Measurement of turbulence characteristics in a large scale fan-stirred spherical vessel

Particle Image Velocimetry, PIV, is employed to characterise the near-homogeneous, isotropic, turbulence generated inside a large spherical vessel by four rotating fans. Spatial and temporal distributions of mean and root mean square, rms, velocity fluctuations are investigated, as well as integral length scales, L, Taylor microscales, λ, and Kolmogorov length scales, η, in the fan speed range, 1000–6000 rpm. Mean velocities are about 10% of the turbulence velocity, u' and turbulence is close to homogeneous and isotropic in the central volume. This volume decreases with increasing fan speed, and its radius and other characteristics are expressed in terms of the fan speed. At each speed, the mean gas velocity scarcely varies with time. Relationships are presented for the variations of u' and L with fan speed, temperature and pressure. A new relationship between the autocorrelation function and integral length scale is obtained, for when Taylor's hypothesis is invalid

Dielectric anomalies and spiral magnetic order in CoCr2O4

We have investigated the structural, magnetic, thermodynamic, and dielectric properties of polycrystalline CoCr$_2$O$_4$, an insulating spinel exhibiting both ferrimagnetic and spiral magnetic structures. Below $T_c$ = 94 K the sample develops long-range ferrimagnetic order, and we attribute a sharp phase transition at $T_N$ $\approx$ 25 K with the onset of long-range spiral magnetic order. Neutron measurements confirm that while the structure remains cubic at 80 K and at 11 K; there is complex magnetic ordering by 11 K. Density functional theory supports the view of a ferrimagnetic semiconductor with magnetic interactions consistent with non-collinear ordering. Capacitance measurements on CoCr$_2$O$_4$, show a sharp decrease in the dielectric constant at $T_N$, but also an anomaly showing thermal hysteresis falling between approximately $T$ = 50 K and $T$ = 57 K. We tentatively attribute the appearance of this higher temperature dielectric anomaly to the development of \textit{short-range} spiral magnetic order, and discuss these results in the context of utilizing dielectric spectroscopy to investigate non-collinear short-range magnetic structures.Comment: & Figure

Flame speed and particle image velocimetry measurements of laminar burning velocities and Markstein numbers of some hydrocarbons

Particle image velocimetry, PIV, is described for measuring laminar burning velocities during flame propagation in spherical explosions, by the measurement of the flame speed and gas velocity just ahead of the flame. Measurements made in this way are compared with those obtained from the flame speed method, which is based on the flame front propagation speed and the ratio of unburned to burned gas densities. Different values arise between the two methods, and the principal reason is the common assumption in the flame speed method that the burned gas density is at the equilibrium, burned gas, adiabatic temperature. When allowance is made for the effects of flame stretch rate and Lewis number on this density, the differences in burning velocities are significantly decreased. The PIV methodology enables mass rate of burning velocities to be expressed in terms of the burning velocity at zero stretch rate and the Markstein numbers for strain rate and flame curvature. Burning velocities and Markstein numbers are presented for methane, i-octane, ethanol, and n-butanol over a range of equivalence ratios at atmospheric pressure and, in the case of n-butanol, also over a range of pressures. Account is taken of the low stretch rate at which a laminar flame becomes unstable, and, below which, the burn rate increases due to the enhanced flame surface area. The critical stretch rates for the transition are identified. In measuring Markstein numbers, there is a dependency upon the isotherm employed for the measurement of the stretch rate. This aspect is studied by comparing measurements with two different isotherms. It is concluded that the measured PIV flame measurements might under-estimate the Markstein numbers by about 12%