Influence of thermal hydrolysis pretreatment on physicochemical properties and anaerobic biodegradability of waste activated sludge with different solids content

© 2018 Elsevier Ltd The influence of thermal hydrolysis pretreatment (THP) on physicochemical properties (pH, total solids, volatile solids, chemical oxygen demand, total nitrogen, ammonium nitrogen, volatile fatty acids, viscosity, and cell morphology) and anaerobic biodegradability of highly concentrated waste activated sludge (WAS) with TS content ranging from 1 to 7% was evaluated at different temperatures ranging from 100 to 220 °C. The biomethane potential (BMP) of the WAS was systematically analyzed and evaluated. Images of its cellular structure were also analyzed. The results indicated that THP is a useful method for solubilizing volatile solids and enhancing CH 4 production regardless of the TS content of the WAS feed. The ultimate CH 4 production determined from the BMP analysis was 313–348 L CH 4 /kg VS (72.6–74.1% CH 4 ) at the optimum THP temperature of 180 °C. The results showed that THP could improve both the capacity and efficiency of anaerobic digestion, even at a high TS content, and could achieve the dual purpose of sludge reduction and higher energy recovery

Effect of organic loading rate on the recovery of nutrients and energy in a dual-chamber microbial fuel cell

© 2019 Elsevier Ltd This study aimed to assess the impacts of organic loading rate (OLR) (435–870 mgCOD/L·d) on nutrients recovery via a double-chamber microbial fuel cell (MFC) for treating domestic wastewater. Electricity generation was also explored at different OLRs, including power density and coulombic efficiency. Experimental results suggested the MFC could successfully treat municipal wastewater with over 90% of organics being removed at a wider range of OLR from 435 to 725 mgCOD/L·d. Besides, the maximum power density achieved in the MFC was 253.84 mW/m2 at the OLR of 435 mgCOD/L·d. Higher OLR may disrupt the recovery of PO43−-P and NH4+-N via the MFC. The same pattern was observed for the coulombic efficiency of the MFC and its highest value was 25.01% at the OLR of 435 mgCOD/L·d. It can be concluded that nutrients and electrical power can be simultaneously recovered from municipal wastewater via the dual-chamber MFC

Anaerobic membrane bioreactors for antibiotic wastewater treatment: Performance and membrane fouling issues

© 2018 Elsevier Ltd Antibiotic wastewater has become a major concern due to the toxicity and recalcitrance of antibiotics. Anaerobic membrane bioreactors (AnMBRs) are considered alternative technology for treating antibiotic wastewater because of their advantages over the conventional anaerobic processes and aerobic MBRs. However, membrane fouling remains the most challenging issue in the AnMBRs’ operation and this limits their application. This review critically discusses: (i) antibiotics removal and antibiotic resistance genes (ARGs) in different types of AnMBRs and the impact of antibiotics on membrane fouling and (ii) the integrated AnMBRs systems for fouling control and removal of antibiotics. The presence of antibiotics in AnMBRs could aggravate membrane fouling by influencing fouling-related factors (i.e., sludge particle size, extracellular polymeric substances (EPS), soluble microbial products (SMP), and fouling-related microbial communities). Conclusively, integrated AnMBR systems can be a practical technology for antibiotic wastewater treatment

Insight into greenhouse gases emissions from the two popular treatment technologies in municipal wastewater treatment processes

© 2019 Elsevier B.V. Due to the impact of methane, carbon dioxide and nitrous oxide on global warming, the quantity of these greenhouse gases (GHG) emissions from municipal wastewater treatment plants (WWTPs) has attracted more and more attention. Consequently, GHG emissions from the two popular treatment technologies: anaerobic/anoxic/oxic (AAO) process and sequencing batch reactor (SBR) should be properly identified and discussed toward the current situation in developing countries. Direct and indirect carbon dioxide (with and/or without including in Intergovernmental Panel on Climate Change (IPCC) report) are all discussed in this article. This literature study observed that a quantity of total carbon dioxide emissions from SBR (374 g/m3 of wastewater) was double that of AAO whilst 10% of these was direct carbon dioxide. Methane emitted from an SBR was 0.50 g/m3 wastewater while 0.18 g CH4/m3 wastewater was released from an AAO. The level of nitrous oxide from AAO and SBR accounted for 0.97 g/m3 wastewater and 4.20 g/m3 wastewater, respectively. Although these results were collected from different WWTPs and where influent was in various states, GHGs emitted from both biological units and other treatment units in various processes are significant. The results also revealed that aerated zone is the major contributing factor in a wastewater treatment plant to the large amount of GHG emissions

Deciphering interplay between Salmonella invasion effectors

Bacterial pathogens have evolved a specialized type III secretion system (T3SS) to translocate virulence effector proteins directly into eukaryotic target cells. Salmonellae deploy effectors that trigger localized actin reorganization to force their own entry into non-phagocytic host cells. Six effectors (SipC, SipA, SopE/2, SopB, SptP) can individually manipulate actin dynamics at the plasma membrane, which acts as a ‘signaling hub’ during Salmonella invasion. The extent of crosstalk between these spatially coincident effectors remains unknown. Here we describe trans and cis binary entry effector interplay (BENEFIT) screens that systematically examine functional associations between effectors following their delivery into the host cell. The results reveal extensive ordered synergistic and antagonistic relationships and their relative potency, and illuminate an unexpectedly sophisticated signaling network evolved through longstanding pathogen–host interaction

Investigation of the cerebral hemodynamic response function in single blood vessels by functional photoacoustic microscopy

The specificity of the hemodynamic response function (HRF) is determined spatially by the vascular architecture and temporally by the evolution of hemodynamic changes. Here, we used functional photoacoustic microscopy (fPAM) to investigate single cerebral blood vessels of rats after left forepaw stimulation. In this system, we analyzed the spatiotemporal evolution of the HRFs of the total hemoglobin concentration (HbT), cerebral blood volume (CBV), and hemoglobin oxygen saturation (SO2). Changes in specific cerebral vessels corresponding to various electrical stimulation intensities and durations were bilaterally imaged with 36 × 65-μm2 spatial resolution. Stimulation intensities of 1, 2, 6, and 10 mA were applied for periods of 5 or 15 s. Our results show that the relative functional changes in HbT, CBV, and SO2 are highly dependent not only on the intensity of the stimulation, but also on its duration. Additionally, the duration of the stimulation has a strong influence on the spatiotemporal characteristics of the HRF as shorter stimuli elicit responses only in the local vasculature (smaller arterioles), whereas longer stimuli lead to greater vascular supply and drainage. This study suggests that the current fPAM system is reliable for studying relative cerebral hemodynamic changes, as well as for offering new insights into the dynamics of functional cerebral hemodynamic changes in small animals. © 2012 Society of Photo-Optical Instrumentation Engineers (SPIE)

Optimization of hydraulic retention time and organic loading rate for volatile fatty acid production from low strength wastewater in an anaerobic membrane bioreactor

© 2018 Elsevier Ltd This study aims to investigate the production of volatile fatty acids (VFAs) from low strength wastewater at various hydraulic retention time (HRT) and organic loading rate (OLR) in a continuous anaerobic membrane bioreactor (AnMBR) using glucose as carbon source. This experiment was performed without any selective inhibition of methanogens and the reactor pH was maintained at 7.0 ± 0.1. 48, 24, 18, 12, 8 and 6 h-HRTs were applied and the highest VFA concentration was recorded at 8 h with an overall VFA yield of 48.20 ± 1.21 mg VFA/100 mg COD feed . Three different ORLs were applied (350, 550 and 715 mg COD feed ) at the optimum 8 h-HRT. The acetic and propanoic acid concentration maximums were (1.1845 ± 0.0165 and 0.5160 ± 0.0141 mili-mole/l respectively) at 550 mg COD feed . The isobutyric acid concentration was highest (0.3580 ± 0.0407 mili-mole/l) at 715 mg COD feed indicating butyric-type fermentation at higher organic loading rate

Substantial emission reductions from Chinese power plants after the introduction of ultra-low emissions standards

In 2014, China introduced an ultra-low emissions (ULE) standards policy for renovating coal-fired power-generating units to limit SO2, NOx and particulate matter (PM) emissions to 35, 50 and 10 mg m−3, respectively. The ULE standard policy had ambitious levels (surpassing those of all other countries) and implementation timeline. We estimate emission reductions associated with the ULE policy by constructing a nationwide, unit-level, hourly-frequency emissions dataset using data from a continuous emissions monitoring systems network covering 96–98% of Chinese thermal power capacity during 2014–2017. We find that between 2014 and 2017 China’s annual power emissions of SO2, NOx and PM dropped by 65%, 60% and 72%, respectively. Our estimated emissions using actual monitoring data are 18–92% below other recent estimates. We detail the technologies used to meet the ULE standards and the determinants of compliance, underscoring the importance of ex post evaluation and providing insights for other countries wishing to reduce their power emissions

Nanoscale temperature measurements using non-equilibrium Brownian dynamics of a levitated nanosphere

Einstein realised that the fluctuations of a Brownian particle can be used to ascertain properties of its environment. A large number of experiments have since exploited the Brownian motion of colloidal particles for studies of dissipative processes, providing insight into soft matter physics, and leading to applications from energy harvesting to medical imaging. Here we use optically levitated nanospheres that are heated to investigate the non-equilibrium properties of the gas surrounding them. Analysing the sphere's Brownian motion allows us to determine the temperature of the centre-of-mass motion of the sphere, its surface temperature and the heated gas temperature in two spatial dimensions. We observe asymmetric heating of the sphere and gas, with temperatures reaching the melting point of the material. This method offers new opportunities for accurate temperature measurements with spatial resolution on the nanoscale, and a new means for testing non-equilibrium thermodynamicsComment: 5 pages, 4 figures, supplementary material available upon reques