Physician assistants in intensive care units in the Netherlands:a narrative review with recommendations

This review is an overview of the current status of the advanced practice provider (APP) working in critical care. After describing the history of the profession, the paper focuses on the literature available. Although a lot of literature is available, the papers are often heterogeneous and comparison with other clinicians remains difficult. The paper zooms in on the situation in the Netherlands and describes the training courses for the physician assistant (PA), the equivalent of the APP, together with the legislation in place. Furthermore, the review elaborates on the potential superimposed value of the PA for the ICU. Because of the limited amount of studies performed in the Dutch situation this review finishes with the conclusions of 15-year-experience and the possible issues which could arise when implementing a PA on the ICU

Acceleration of the direct identification of Staphylococcus aureus versus coagulase-negative staphylococci from blood culture material: a comparison of six bacterial DNA extraction methods

To accelerate differentiation between Staphylococcus aureus and coagulase-negative staphylococci (CNS), this study aimed to compare six different DNA extraction methods from two commonly used blood culture materials, i.e. BACTEC and BacT/ALERT. Furthermore, we analysed the effect of reduced blood culture incubation for the detection of staphylococci directly from blood culture material. A real-time polymerase chain reaction (PCR) duplex assay was used to compare the six different DNA isolation protocols on two different blood culture systems. Negative blood culture material was spiked with methicillin-resistant S. aureus (MRSA). Bacterial DNA was isolated with automated extractor easyMAG (three protocols), automated extractor MagNA Pure LC (LC Microbiology Kit MGrade), a manual kit MolYsis Plus and a combination of MolYsis Plus and the easyMAG. The most optimal isolation method was used to evaluate reduced bacterial incubation times. Bacterial DNA isolation with the MolYsis Plus kit in combination with the specific B protocol on the easyMAG resulted in the most sensitive detection of S. aureus, with a detection limit of 10 CFU/ml, in BacT/ALERT material, whereas using BACTEC resulted in a detection limit of 100 CFU/ml. An initial S. aureus or CNS load of 1 CFU/ml blood can be detected after 5 h of incubation in BacT/ALERT 3D by combining the sensitive isolation method and the tuf LightCycler assay

Biopsy-based calibration of T2* magnetic resonance for estimation of liver iron concentration and comparison with R2 Ferriscan.

BACKGROUND: There is a need to standardise non-invasive measurements of liver iron concentrations (LIC) so clear inferences can be drawn about body iron levels that are associated with hepatic and extra-hepatic complications of iron overload. Since the first demonstration of an inverse relationship between biopsy LIC and liver magnetic resonance (MR) using a proof-of-concept T2* sequence, MR technology has advanced dramatically with a shorter minimum echo-time, closer inter-echo spacing and constant repetition time. These important advances allow more accurate calculation of liver T2* especially in patients with high LIC. METHODS: Here, we used an optimised liver T2* sequence calibrated against 50 liver biopsy samples on 25 patients with transfusional haemosiderosis using ordinary least squares linear regression, and assessed the method reproducibility in 96 scans over an LIC range up to 42 mg/g dry weight (dw) using Bland-Altman plots. Using mixed model linear regression we compared the new T2*-LIC with R2-LIC (Ferriscan) on 92 scans in 54 patients with transfusional haemosiderosis and examined method agreement using Bland-Altman approach. RESULTS: Strong linear correlation between ln(T2*) and ln(LIC) led to the calibration equation LIC = 31.94(T2*)-1.014. This yielded LIC values approximately 2.2 times higher than the proof-of-concept T2* method. Comparing this new T2*-LIC with the R2-LIC (Ferriscan) technique in 92 scans, we observed a close relationship between the two methods for values up to 10 mg/g dw, however the method agreement was poor. CONCLUSIONS: New calibration of T2* against liver biopsy estimates LIC in a reproducible way, correcting the proof-of-concept calibration by 2.2 times. Due to poor agreement, both methods should be used separately to diagnose or rule out liver iron overload in patients with increased ferritin

Parametric exploration of the liver by magnetic resonance methods

MRI, as a completely noninvasive technique, can provide quantitative assessment of perfusion, diffusion, viscoelasticity and metabolism, yielding diverse information about liver function. Furthermore, pathological accumulations of iron and lipids can be quantified. Perfusion MRI with various contrast agents is commonly used for the detection and characterization of focal liver disease and the quantification of blood flow parameters. An extended new application is the evaluation of the therapeutic effect of antiangiogenic drugs on liver tumours. Novel, but already widespread, is a histologically validated relaxometry method using five gradient echo sequences for quantifying liver iron content elevation, a measure of inflammation, liver disease and cancer. Because of the high perfusion fraction in the liver, the apparent diffusion coefficients strongly depend on the gradient factors used in diffusion-weighted MRI. While complicating analysis, this offers the opportunity to study perfusion without contrast injection. Another novel method, MR elastography, has already been established as the only technique able to stage fibrosis or diagnose mild disease. Liver fat content is accurately determined with multivoxel MR spectroscopy (MRS) or by faster MRI methods that are, despite their widespread use, prone to systematic error. Focal liver disease characterisation will be of great benefit once multivoxel methods with fat suppression are implemented in proton MRS, in particular on high-field MR systems providing gains in signal-to-noise ratio and spectral resolution