7 research outputs found
COVID-19 Pandemic and Dental Practice
SARS-CoV-2, a virus causing severe acute respiratory syndrome, has inundated the whole world, generating global health concerns. There is a wildfire-like effect, despite the extensive range of efforts exercised by the affected countries to restrain the expanse of this pandemic, owing to its community spread pattern. Dental specialists in the upcoming days will likely come across patients with presumed or confirmed COVID-19 and will have to ensure stringent infection prevention and control to prevent its nosocomial spread. This paper strives to provide a brief overview of the etiology, incubation, symptoms, and transmission paradigms of this novel infection and how to minimize the spread in a dental healthcare setting. This review presents evidence-based patient management practice and protocols from the available literature to help formulate a contingency plan with recommendations, for the dental practices prior to patients’ visit, during in-office dental treatment, and post-treatment, during the pandemic and after
Eruption cysts: A series of two cases
Eruption cysts are benign cysts that appear on the mucosa of a tooth shortly before its eruption. They may disappear by themselves but if they hurt, bleed or are infected they may require surgical treatment to expose the tooth and drain the contents. Here we present 2 case reports of eruption cysts presenting with different chief complaint. The treatment included incising the eruption cyst and draining the contents of the cyst
Delaying Intraoral Radiographs during the COVID-19 Pandemic: A Conundrum
Background. The COVID-19 pandemic has made dentists very assiduous about cross-infection during dental treatment, thereby delaying dental radiographs for treatment. However, patients needing dental emergency treatment in the ongoing pandemic require relevant intra/extraoral dental radiography for adequate diagnosis and treatment planning. Methods. This article is aimed at adding to the hot debate: Is delay for intraoral radiographs justified or a possible proxy? As a narrative review, it provides an insight into the reasons for delaying intra-oral dental radiographs during in the pandemic and options of the nontraditional radiographic techniques available until the pandemic subsides. Discussion and Conclusion. Cross-contamination concerns through respiratory droplets grow while using intraoral film holders that stimulate gag reflex, coughing, saliva secretion, and if proper disinfection protocols are not applied. Since the patients’ acquiring emergency dental treatment cannot be neglected, the return-to-work guidelines by the health regulatory bodies urge to prioritize extraoral radiographic imaging techniques to curb the infection, offering the best diagnostic efficacy. The dental professionals can consider cone-beam computed tomography (CBCT) scans and sectional dental panoramic radiographs (SDPRs), followed by a risk assessment for COVID-19, a safer modality in reducing cross-contamination and assuring an innocuous environment for both patient and coworkers.Peer Reviewe
Frontal and Axial Evaluation of Craniofacial Morphology in Repaired Unilateral Cleft Lip and Palate Patients Utilizing Cone Beam Computed Tomography; An Observational Study
The current study was conducted to assess the extent of maxillary arch collapse on the cleft vis-a-vis non-cleft sides in the same individual presenting withunilateral cleft lip and palate (UCLP), using cone-beam computed tomography (CBCT). Thirty-one children (eighteen boys andthirteen girls) with surgically repaired UCLP, who met the inclusion criteria, were selected. Following the acquisition of CBCT scans, fourteen bilateral landmarks were selected. The distance of the bilateral landmark was calculated from the midsagittal plane on the cleft and non-cleft sides for both frontal and axial views. Tracings were done;the data obtained was subjected to statistical analysis;and intra-observer variability was checked with intraclass correlation coefficient (ICC) and two-way ANOVA. Subsequently, the measurements were subjected to paired t-tests at the 95% level of significance with Bonferroni correction. A significant reduction of pyriforme and an alveolar crest above the maxillary 1st molar were discerned in frontal analysis on the cleft side. In the axial view, the zygomatic arch, malar, porion and alveolar crest at the molar region were non-significant, but the alveolar crest at the premolar region (p < 0.004)) was significantly decreased. In the frontal analysis, pyriforme and the alveolar crest above the maxillary 1st molar, and, in the axial view, premolar widths, showed significant reduction when comparing the cleft vis-a-vis non-cleft sides
Frontal and Axial Evaluation of Craniofacial Morphology in Repaired Unilateral Cleft Lip and Palate Patients Utilizing Cone Beam Computed Tomography; An Observational Study
The current study was conducted to assess the extent of maxillary arch collapse on the cleft vis-a-vis non-cleft sides in the same individual presenting withunilateral cleft lip and palate (UCLP), using cone-beam computed tomography (CBCT). Thirty-one children (eighteen boys andthirteen girls) with surgically repaired UCLP, who met the inclusion criteria, were selected. Following the acquisition of CBCT scans, fourteen bilateral landmarks were selected. The distance of the bilateral landmark was calculated from the midsagittal plane on the cleft and non-cleft sides for both frontal and axial views. Tracings were done;the data obtained was subjected to statistical analysis;and intra-observer variability was checked with intraclass correlation coefficient (ICC) and two-way ANOVA. Subsequently, the measurements were subjected to paired t-tests at the 95% level of significance with Bonferroni correction. A significant reduction of pyriforme and an alveolar crest above the maxillary 1st molar were discerned in frontal analysis on the cleft side. In the axial view, the zygomatic arch, malar, porion and alveolar crest at the molar region were non-significant, but the alveolar crest at the premolar region (p < 0.004)) was significantly decreased. In the frontal analysis, pyriforme and the alveolar crest above the maxillary 1st molar, and, in the axial view, premolar widths, showed significant reduction when comparing the cleft vis-a-vis non-cleft sides
Intra- and Interobserver Reliability of Bone Volume Estimation Using OsiriX Software in Patients with Cleft Lip and Palate Using Cone Beam Computed Tomography
The objective of the current study was to evaluate intra- and interobserver bone volume measurements and effect of orientation on the reliability of bone volume evaluation in as-acquired vis-à-vis oriented cone beam computed tomography scans using Osirix software and possible correlation between gender, age, and bone volume required. For this, 31 cone beam computed tomography (CBCT) scans of 14 girls and 17 boys (aged 9–13) with unilateral cleft lip and/or palate who met the inclusion criteria were analyzed. Efficacy and reliability of third party software Osirix for bone volume calculation was assessed using as acquired and oriented volumes by three specialists (a radiologist, an orthodontist, and an oral maxillofacial surgeon). The dataset and readings were anonymized to prevent any bias. Two-way mixed model analysis on as-acquired and oriented observations exhibited intra-class coefficient (ICC) values ≥ 0.90. Wilcoxon signed rank test (p = 0.10) and Kruskal–Wallis ANOVA (p = 0.46) indicated that although a clinical difference in volume assessment was seen between as-acquired and oriented observations (inter-observer and intra-observer), it was statistically insignificant. Spearman’s bi-variate correlation analysis revealed a significant relation between the type (side) of cleft and bone volume required to fill the defect (p < 0.05). Although there was clinical difference in bone volume measurement by the three observers, it was insignificant statistically. Clefts on the left side in the patients had significantly more bone required than the right side, whereas age and gender had no relation with bone needed to fill the defect. OsiriX software provided good reliability in measurements of bone volume