A Method for Greatly Reduced Edge Effects and Crosstalk in CCT Magnets

Iron-free CCT magnet design offers many advantages, one being the excellent field quality and the absence of multipole components. However, edge effects are present, although they tend to integrate out over the length of the magnet. Many modern accelerator applications, however, require that these magnets are placed in an area of rapidly varying optics parameters, so magnets with greatly reduced edge effects have an advantage. We have designed such a magnet (a quadrupole) by adding multipole components of the opposite sign to the edge distortions of the magnet. A possible application could be the final focus magnets of the FCC-ee, where beam sizes at the entry and exit point of the magnets vary by large factors. We have then used this technique to effectively eliminate cross talk between adjacent final focus quadrupoles for the incoming and outgoing beams.Comment: Poster presented at MT25,25th International Conference on Magnet Technology, Amsterdam, August 27 - September 1, 201

Regolith production and transport at the Susquehanna Shale Hills Critical Zone Observatory, Part 2: Insights from meteoric 10Be

Regolith-mantled hillslopes are ubiquitous features of most temperate landscapes, and their morphology reflects the climatically, biologically, and tectonically mediated interplay between regolith production and downslope transport. Despite intensive research, few studies have quantified both of these mass fluxes in the same field site. Here we present an analysis of 87 meteoric 10Be measurements from regolith and bedrock within the Susquehanna Shale Hills Critical Zone Observatory (SSHO), in central Pennsylvania. Meteoric 10Be concentrations in bulk regolith samples (n=73) decrease with regolith depth. Comparison of hillslope meteoric 10Be inventories with analyses of rock chip samples (n=14) from a 24 m bedrock core confirms that >80% of the total inventory is retained in the regolith. The systematic downslope increase of meteoric 10Be inventories observed at SSHO is consistent with 10Be accumulation in slowly creeping regolith (∼ 0.2 cm yr-1). Regolith flux inferred from meteoric 10Be varies linearly with topographic gradient (determined from high-resolution light detection and ranging-based topography) along the upper portions of hillslopes at SSHO. However, regolith flux appears to depend on the product of gradient and regolith depth where regolith is thick, near the base of hillslopes. Meteoric 10Be inventories at the north and south ridgetops indicate minimum regolith residence times of 10.5 ± 3.7 and 9.1 ± 2.9 ky, respectively, similar to residence times inferred from U-series isotopes in Ma et al. (2013). The combination of our results with U-series-derived regolith production rates implies that regolith production and erosion rates are similar to within a factor of two on SSHO hillcrests. ©2013. American Geophysical Union. All Rights Reserved

Atomic Hydrogen Cleaning of Polarized GaAs Photocathodes

Atomic hydrogen cleaning followed by heat cleaning at 450$^\circ$C was used to prepare negative-electron-affinity GaAs photocathodes. When hydrogen ions were eliminated, quantum efficiencies of 15% were obtained for bulk GaAs cathodes, higher than the results obtained using conventional 600$^\circ$C heat cleaning. The low-temperature cleaning technique was successfully applied to thin, strained GaAs cathodes used for producing highly polarized electrons. No depolarization was observed even when the optimum cleaning time of about 30 seconds was extended by a factor of 100

Surface Analysis of OFE-Copper X-Band Accelerating Structures and Possible Correlation to RF Breakdown Events

X-band accelerator structures meeting the Next Linear Collider (NLC) design requirements have been found to suffer vacuum surface damage caused by radio frequency (RF) breakdown, when processed to high electric-field gradients. Improved understanding of these breakdown events is desirable for the development of structure designs, fabrication procedures, and processing techniques that minimize structure damage. RF reflected wave analysis and acoustic sensor pickup have provided breakdowns localization in RF structures. Particle contaminations found following clean autopsy of four RF-processed travelling wave structures, have been catalogued and analyzed. Their influence on RF breakdown, as well as that of several other material-based properties, will be discussed.Comment: 21 pages, 8 figures, 4 tables, Submitted to JVST A as a proceeding of the 50th AVS conference (Baltimore, MD, 2-7 Nov 2003

An Assessment of the Impact of Internship Programs in the Agricultural Technical Schools of Egypt as Perceived by Participants Groups

Experiential learning including student internships has been central to instructional programs in agriculture for decades. If the Agricultural Technical Schools of Egypt are to prepare students for successful careers and to enhance the agricultural economy, teachers must be well-prepared to use this teaching technique. Further, all stakeholders, including students, teachers, parents, headmasters and agribusiness owners, must recognize the importance and impact that implementing a student internship program could have. In this study, all groups identified important contributions to student learning and growth as a result of student participation in the internship program. While several suggestions were posited to improve the program, all agreed that the schools, the communities, the agribusinesses and the students received valuable benefits. The program of student internships in Egypt could be adopted in other countries where the agricultural economy could be improved through a better prepared agricultural workforce