Hydrodynamic Performance and Acoustic Response of Ship Propeller

The aim of the paper is to predict the hydrodynamic performance and noise generated by the propeller at different advance ratio and the speed of the propeller. Three bladed, DTMB 4119 propeller model was created using the NACA66 modified line, a = 0.8 hydrofoil profile. ANSYS Workbench software is used for mesh generation and computational analysis. A large-eddy simulation turbulence model and Ffowcs Williams-Hawkings (FWH) acoustic model is used for all simulations. A moving reference frame is used to simulate the rotational effects of the propeller. The speed of the propeller is 792 rpm, the propeller being 0.2 m, and inlet velocity is varied to study the effect of the advance ratio. A transient analysis is carried out using a time step value of 0.0005 seconds and the total simulation time is 0.6 seconds. The hydrodynamic performance parameters are validated by comparing with the experimental data available in the literature. The sound pressure level (SPL) is plotted over the frequency range of 0 to 1000 Hz at different locations, speed, and an advance ratio of 0.5, 0.7, 0.833, and 0.9,1. The structural, acoustic and hydrodynamic behaviour of the propeller was predicted using a two-way fluid structure interaction at an advance ratio of 0.833. The major conclusions drawn from the analysis are that the sound pressure level values are increased at the propeller off-design conditions and varying with the receiver locations. The data generated from this study is useful for the designers to carry out further research in order to reduce the noise generated from the propeller

Hybrid quantum repeater using bright coherent light

We describe a quantum repeater protocol for long-distance quantum communication. In this scheme, entanglement is created between qubits at intermediate stations of the channel by using a weak dispersive light-matter interaction and distributing the outgoing bright coherent light pulses among the stations. Noisy entangled pairs of electronic spin are then prepared with high success probability via homodyne detection and postselection. The local gates for entanglement purification and swapping are deterministic and measurement-free, based upon the same coherent-light resources and weak interactions as for the initial entanglement distribution. Finally, the entanglement is stored in a nuclear-spin-based quantum memory. With our system, qubit-communication rates approaching 100 Hz over 1280 km with fidelities near 99% are possible for reasonable local gate errors.Comment: title changed, final published versio

Fault-tolerant quantum computation with cluster states

The one-way quantum computing model introduced by Raussendorf and Briegel [Phys. Rev. Lett. 86 (22), 5188-5191 (2001)] shows that it is possible to quantum compute using only a fixed entangled resource known as a cluster state, and adaptive single-qubit measurements. This model is the basis for several practical proposals for quantum computation, including a promising proposal for optical quantum computation based on cluster states [M. A. Nielsen, arXiv:quant-ph/0402005, accepted to appear in Phys. Rev. Lett.]. A significant open question is whether such proposals are scalable in the presence of physically realistic noise. In this paper we prove two threshold theorems which show that scalable fault-tolerant quantum computation may be achieved in implementations based on cluster states, provided the noise in the implementations is below some constant threshold value. Our first threshold theorem applies to a class of implementations in which entangling gates are applied deterministically, but with a small amount of noise. We expect this threshold to be applicable in a wide variety of physical systems. Our second threshold theorem is specifically adapted to proposals such as the optical cluster-state proposal, in which non-deterministic entangling gates are used. A critical technical component of our proofs is two powerful theorems which relate the properties of noisy unitary operations restricted to act on a subspace of state space to extensions of those operations acting on the entire state space.Comment: 31 pages, 54 figure

ORIGINAL ARTICLE: Will An Additional Observer Enhance Adenoma Detection During Colonoscopy?

Background: Due to varied level of experience, the detection rate of adenoma on colonoscopy is different. In presence of both fellows and attending the incidence rates of adenoma are shown to increase in a small study reported by Rogart et al [4]. Based on similar hypothesis, a study was undertaken with much larger sample size to improve the power of the study. Aims and objective: To know if presence of additional observer will enhance adenoma detection during colonoscopy. Material and Methods: 2236 consecutive colonoscopies performed at Metro Health Medical Centre, Cleveland, Ohio were included in the study from July 2005 to August 2006. Cases with history of colorectal, surgical resection of colon, inflammatory bowel diseases and hereditary polyposis syndrome were excluded. Inpatient colonoscopies were also excluded. With all usual precautions for colonoscopy and after giving polyethylene glycol electrolyte (PEGEL) colonoscopies were performed by one of the nine experienced staff attending using an Olympus colonoscope and Evis Exera processors. All colonoscopies performed by fellows were supervised by an attending throughout the procedure. Advanced adenomas were defined as adenomas greater than 1 cm size. Statistical analysis was done using Tall hassee, FL software; Fisher’s exact test, unpaired t test and multiple logistic regression analysis were performed. p-value of <0.05 is considered as statistically significant. Results: Of the total 2236 colonoscopies included in the study, 1527 were performed by fellows under supervision of attending and 709 by the attending. There was no significant difference in patient demographics, caecal intubation or poor preparation colonoscopies. The mean age of the group was 55 years in both of the groups. There was no statistically significant different in the polyp detection rate (35% Vs 36.8%) as well as overall adenoma detection rate (28.4% Vs 27.7%) between these two groups of performers. However, increased rate of adenoma detection was seen for the adenomas of size 0.5 to 1.00 cm in the fellow and attending group (7.2%) as compared to attending alone group (4.0%). There was no difference in the number of colonoscopies aborted due to poor bowel preparations There was no statistically significant difference in the number of colonoscopies aborted due to poor bowel prep, 91(5.9%) Vs 32(4.5%). Conclusions: Our retrospective study has shown no improvement in the rate of adenoma detection when fellows performed colonoscopy with a supervising attending in comparison to procedures performed by attending alone. In fact, Adenoma Detection Rate (ADR) and caecal intubation rates are increasingly seen as important quality measure. We propose that ADR needs to be used as a tool to assess trainee competency and should be a marker to evaluate proper training. These could be evaluated in randomized prospective trials in future

Lasing of donor-bound excitons in ZnSe microdisks

Excitons bound to flourine atoms in ZnSe have the potential for several quantum optical applications. Examples include optically accessible quantum memories for quantum information processing and lasing without inversion. These applications require the bound-exciton transitions to be coupled to cavities with high cooperativity factors, which results in the experimental observation of low-threshold lasing. We report such lasing from fluorine-doped ZnSe quantum wells in 3 and 6 micron microdisk cavities. Photoluminescence and selective photoluminescence spectroscopy confirm that the lasing is due to bound-exciton transitions.Comment: 4 pages, 3 figures; introduction rewritte

Hybrid quantum repeater based on dispersive CQED interactions between matter qubits and bright coherent light

We describe a system for long-distance distribution of quantum entanglement, in which coherent light with large average photon number interacts dispersively with single, far-detuned atoms or semiconductor impurities in optical cavities. Entanglement is heralded by homodyne detection using a second bright light pulse for phase reference. The use of bright pulses leads to a high success probability for the generation of entanglement, at the cost of a lower initial fidelity. This fidelity may be boosted by entanglement purification techniques, implemented with the same physical resources. The need for more purification steps is well compensated for by the increased probability of success when compared to heralded entanglement schemes using single photons or weak coherent pulses with realistic detectors. The principle cause of the lower initial fidelity is fiber loss; however, spontaneous decay and cavity losses during the dispersive atom/cavity interactions can also impair performance. We show that these effects may be minimized for emitter-cavity systems in the weak-coupling regime as long as the resonant Purcell factor is larger than one, the cavity is over-coupled, and the optical pulses are sufficiently long. We support this claim with numerical, semiclassical calculations using parameters for three realistic systems: optically bright donor-bound impurities such as 19-F:ZnSe with a moderate-Q microcavity, the optically dim 31-P:Si system with a high-Q microcavity, and trapped ions in large but very high-Q cavities.Comment: Please consult the published version, where assorted typos are corrected. It is freely available at http://stacks.iop.org/1367-2630/8/18

Entanglement generation by Fock-state filtration

We demonstrate a Fock-state filter which is capable of preferentially blocking single photons over photon pairs. The large conditional nonlinearities are based on higher-order quantum interference, using linear optics, an ancilla photon, and measurement. We demonstrate that the filter acts coherently by using it to convert unentangled photon pairs to a path-entangled state. We quantify the degree of entanglement by transforming the path information to polarisation information, applying quantum state tomography we measure a tangle of T=(20+/-9)%.Comment: 4 pages, 3 figure

Reduced Deadtime and Higher Rate Photon-Counting Detection using a Multiplexed Detector Array

We present a scheme for a photon-counting detection system that can be operated at incident photon rates higher than otherwise possible by suppressing the effects of detector deadtime. The method uses an array of N detectors and a 1-by-N optical switch with a control circuit to direct input light to live detectors. Our calculations and models highlight the advantages of the technique. In particular, using this scheme, a group of N detectors provides an improvement in operation rate that can exceed the improvement that would be obtained by a single detector with deadtime reduced by 1/N, even if it were feasible to produce a single detector with such a large improvement in deadtime. We model the system for continuous and pulsed light sources, both of which are important for quantum metrology and quantum key distribution applications.Comment: 6 figure