430 research outputs found
Calculation of wakefields in 2D rectangular structures
We consider the calculation of electromagnetic fields generated by an
electron bunch passing through a vacuum chamber structure that, in general,
consists of an entry pipe, followed by some kind of transition or cavity, and
ending in an exit pipe. We limit our study to structures having rectangular
cross-section, where the height can vary as function of longitudinal coordinate
but the width and side walls remain fixed. For such structures, we derive a
Fourier representation of the wake potentials through one-dimensional
functions. A new numerical approach for calculating the wakes in such
structures is proposed and implemented in the computer code ECHO(2D). The
computation resource requirements for this approach are moderate and comparable
to those for finding the wakes in 2D rotationally symmetric structures.
Numerical examples obtained with the new numerical code are presented.Comment: 31 pages, 10 figure
Impedance of a Rectangular Beam Tube with Small Corrugations
We consider the impedance of a structure with rectangular, periodic
corrugations on two opposing sides of a rectangular beam tube. Using the method
of field matching, we find the modes in such a structure. We then limit
ourselves to the the case of small corrugations, but where the depth of
corrugation is not small compared to the period. For such a structure we
generate analytical approximate solutions for the wave number , group
velocity , and loss factor for the lowest (the dominant) mode
which, when compared with the results of the complete numerical solution,
agreed well. We find: if , where is the beam pipe width and is
the beam pipe half-height, then one mode dominates the impedance, with
( is the depth of corrugation),
, and , which (when replacing by
) is the same scaling as was found for small corrugations in a {\it round}
beam pipe. Our results disagree in an important way with a recent paper of
Mostacci {\it et al.} [A. Mostacci {\it et al.}, Phys. Rev. ST-AB, {\bf 5},
044401 (2002)], where, for the rectangular structure, the authors obtained a
synchronous mode with the same frequency , but with .
Finally, we find that if is large compared to then many nearby modes
contribute to the impedance, resulting in a wakefield that Landau damps.Comment: 18 pages, 6 figures, 1 bibliography fil
Corrugated Pipe as a Beam Dechirper
We have studied the use of a metallic pipe with small corrugations for the purpose of passively dechirping, through its wakefield, a short, intense electron bunch. The corrugated pipe is attractive for this purpose because its wake: (i) has near maximal possible amplitude for a given aperture and (ii) has a relatively large oscillation wave length, even when the aperture is small. We showed how the corrugated structure can satisfy dechirping requirements encountered in the NGLS project at LBNL. We found that a linear chirp of -40 MeV/mm can be induced by an NGLS-like beam, by having it pass through a corrugated, metallic pipe of radius 3 mm, length 8.2 m, and corrugation parameters full depth 450 {mu}m and period 1000 {mu}m. This structure is about 15 times as effective in the role of dechirper as an S-band accelerator structure used passively
Impedance Analysis of Bunch Length Measurements at the ATF Damping Ring
We present energy spread and bunch length measurements at the Accelerator
Test Facility (ATF) at KEK, as functions of current, for different ring rf
voltages, and with the beam both on and off the coupling resonance. We fit the
on-coupling bunch shapes to those of an impedance model consisting of a
resistor and an inductor connected in series. We find that the fits are
reasonably good, but that the resulting impedance is unexpectedly large.Comment: 9 pages, 5 figures, presented at 10th International Symposium on
Applied Electromagnetics and Mechanics (ISEM2001
Intrabeam Scattering Analysis of ATF Beam Measurements
At the Accelerator Test Facility (ATF) at KEK intrabeam scattering (IBS) is a
strong effect for an electron machine. It is an effect that couples all
dimensions of the beam, and in April 2000, over a short period of time, all
dimensions were measured as functions of current. In this report we derive a
simple relation for the growth rates of emittances due to IBS. We apply the
theories of Bjorken-Mtingwa, Piwinski, and a formula due to Raubenheimer to the
ATF parameters, and find that the results all agree (if in Piwinski's formalism
we replace the dispersion squared over beta by the dispersion invariant).
Finally, we compare theory, including the effect of potential well bunch
lengthening, with the April 2000 measurements, and find reasonably good
agreement in the energy spread and horizontal emittance dependence on current.
The vertical emittance measurement, however, implies that either: there is
error in the measurement (equivalent to an introduction of 0.6% x-y coupling
error), or the effect of intrabeam scattering is stronger than predicted (35%
stronger in growth rates).Comment: 4 pages, 3 figures, Presented at IEEE Particle Accelerator Conferenc
- …