Dependence of the Superconducting Transition Temperature of MgB2 on Pressure to 20 GPa

The dependence of Tc on nearly hydrostatic pressure has been measured for an isotopically pure (11B) MgB2 sample in a helium-loaded diamond-anvil-cell to nearly 20 GPa. Tc decreases monotonically with pressure from 39.1 K at ambient pressure to 20.9 K at 19.2 GPa. The initial dependence is the same as that obtained earlier (dTc/dP = -1.11(2) K/GPa) on the same sample in a He-gas apparatus to 0.7 GPa. The observed pressure dependence Tc(P) to 20 GPa can be readily described in terms of simple lattice stiffening within standard phonon-mediated BCS superconductivity.Comment: 9 pages, 3 figure

Synthesis and Stoichiometry of MgB2

The system MgxB2 has been investigated to investigate possible nonstoichiometry in MgB2. When synthesized at 850oC, MgB2 is a line compound with a possible Mg vacancy content of about 1%. Small changes in lattice constants as a function of starting composition result from grain interaction stresses, whose character is different in the Mg-rich, near-stoichiometric, and Mg-deficient regimes. A small linear decrease of the superconducting transition temperature, Tc, in the Mg-rich regime results from accidental impurity doping.Comment: Accepted for publication in Physica C. 24 pages, 7 figure

Transformation of in-plane ρ(T)\rho (T) in YBa2Cu3O7−δYBa_{2}Cu_{3}O_{7-\delta} at fixed oxygen content

This paper reveals the origin of variation in the magnitude and temperature dependence of the normal state resistivity frequently observed in different YBCO single crystal or thin film samples with the same $T_{c}$. We investigated temperature dependence of resistivity in $YBa_{2}Cu_{3}O_{7-\delta}$ thin films with 7- $\delta = 6.95$ and 6.90, which were subjected to annealing in argon at 400-420 K ($120-140^{o}C$). Before annealing these films exhibited a non-linear $\rho_{ab}(T)$, with a flattening below 230 K, similar to $\rho_{b}(T)$ and $\rho_{ab}(T)$ observed in untwinned and twinned YBCO crystals, respectively. For all films the annealing causes an increase of resistivity and a transformation of $\rho_{ab}(T)$ from a non-linear dependence towards a more linear one (less flattening). In films with 7- $\delta = 6.90$ the increase of resistivity is also associated with an increase in $T_{c}$. We proposed the model that provides an explanation of these phenomena in terms of thermally activated redistribution of residual O(5) oxygens in the chain-layer of YBCO. Good agreement between the experimental data for $\rho_{ab}(t,T)$, where t is the annealing time, and numerical calculations was obtained.Comment: 8 pages, 9 figures, submitted to PR

X-Ray-Diffraction Study of Charge-Density-Waves and Oxygen-Ordering in YBa2Cu3O6+x Superconductor

We report a temperature-dependent increase below 300 K of diffuse superlattice peaks corresponding to q_0 =(~2/5,0,0) in an under-doped YBa_2Cu_3O_6+x superconductor (x~0.63). These peaks reveal strong c-axis correlations involving the CuO_2 bilayers, show a non-uniform increase below \~220 K with a plateau for ~100-160 K, and appear to saturate in the superconducting phase. We interpret this unconventional T-dependence of the ``oxygen-ordering'' peaks as a manifestation of a charge density wave in the CuO_2 planes coupled to the oxygen-vacancy ordering.Comment: 4 pages, 4 figure

Concerning Order and Disorder in the Ensemble of Cu-O Chain Fragments in Oxygen Deficient Planes of Y-Ba-Cu-O

In connection with numerous X-ray and neutron investigations of some high temperature superconductors (YBa$_2$Cu$_3$O$_{6+x}$ and related compounds) a non-trivial part of the structure factor, coming from partly disordered Cu-O-$\dots$-O-Cu chain fragments, situated within basal planes, CuO$_x$, can be a subject of theoretical interest. Closely connected to such a diffusive part of the structure factor are the correlation lengths, which are also available in neutron and X-ray diffraction studies and depend on a degree of oxygen disorder in a basal plane. The quantitative measure of such a disorder can be associated with temperature of a sample anneal, $T_q$, at which oxygen in a basal plane remains frozen-in high temperature equilibrium after a fast quench of a sample to room or lower temperature. The structure factor evolution with $x$ is vizualized in figures after the numerical calculations. The theoretical approach employed in the paper has been developed for the orthorhombic state of YBCO.Comment: Revtex, 27 pages, 14 PostScript figures upon request, ITP/GU/94/0

Evidence for Possible Phase-Separations in RuSr2(Gd,Ce)2Cu2O10-delta

An unusual thermal-magnetic hysteresis was observed between a minor magnetic transition around 120 K and the main one at 80 K in superconducting RuSr2(R,Ce)2Cu2O10-delta (Ru1222R) samples, where R = Gd or Eu, down to a submicron length-scale. The observation suggests a possible phase-separation and is consistent with the very small but universal demagnetizing factor observed, which is difficult to reconcile with the canted spin-structure previously proposed. In such a scenario, the unusual superconducting properties of the Ru-based cuprates can also be understood naturally.Comment: 8 pages, 3 figures, submitted to Phys. Rev. B, "Rapid Communications" (September 26, 2001

Structural features that optimize high temperature superconductivity

For example, various defects can be introduced into the blocking layer to provide the optimum carrier concentration, but defects that form in or adjacent to the CuO{sub 2} layers will lower T{sub c} and eventually destroy superconductivity. After these requirements are satisfied, the highest T{sub c}`s are observed for compounds (such as the HgBa{sub 2}Ca{sub n-1}CuO{sub 2n{plus}2{plus}x} family) that have flat and square CuO{sub 2} planes and long apical Cu-O bonds. This conclusion is confirmed by the study of materials in which the flatness of the CuO{sub 2} plane can be varied in a systematic way. In more recent work, attention has focused on how the structure can be modified, for example, by chemical substitution, to improve flux pinning properties. Two strategies are being investigated: (1) Increasing the coupling of pancake vortices to form vortex-lines by shortening or ``metallizing`` the blocking layer; and (2) the formation of defects that pin flux

X-ray diffraction measurements of the c-axis Debye-Waller factors of YBa2Cu3O7 and HgBa2CaCu2O6

We report the first application of x-rays to the measurement of the temperature dependent Bragg peak intensities to obtain Debye-Waller factors on high-temperature superconductors. Intensities of (0,0,l) peaks of YBa2Cu3O7 and HgBa2CaCu2O6 thin films are measured to obtain the c-axis Debye-Waller factors. While lattice constant and some Debye-Waller factor measurements on high Tc superconductors show anomalies at the transition temperature, our measurements by x-ray diffraction show a smooth transition of the c-axis Debye-Waller factors through T$_c$. This suggests that the dynamic displacements of the heavy elements along the c-axis direction in these compounds do not have anomalies at Tc. This method in combination with measurements by other techniques will give more details concerning dynamics of the lattice.Comment: 4 pages, 2 figures. To be published in Physical Review B (Brief Report

In-situ epitaxial growth of superconducting La-based bilayer cuprate thin films

We investigate the epitaxial growth of bilayer cuprate La2CaCu2O6+\delta using pure ozone as an oxidant, and find that even the crystal with parent composition without cation substitution can show metallic behavior with the aid of epitaxial strain effect. The hole concentration is controlled simply by excess-oxygen doping, and the films grown under the optimum conditions exhibit superconductivity below 30 K. This is the first result on the superconductivity of bilayer La2CaCu2O6+\delta induced purely by the excess oxygen.Comment: 5 pages, 3 figures, To appear in Phys. Rev. B, Rapid Communication