Metallographic Index-Based Quantification of the Homogenization State in Extrudable Aluminum Alloys

Extrudability of aluminum alloys of the 6xxx series is highly dependent on the microstructure of the homogenized billets. It is therefore very important to characterize quantitatively the state of homogenization of the as-cast billets. The quantification of the homogenization state was based on the measurement of specific microstructural indices, which describe the size and shape of the intermetallics and indicate the state of homogenization. The indices evaluated were the following: aspect ratio (AR), which is the ratio of the maximum to the minimum diameter of the particles, feret (F), which is the maximum caliper length, and circularity (C), which is a measure of how closely a particle resembles a circle in a 2D metallographic section. The method included extensive metallographic work and the measurement of a large number of particles, including a statistical analysis, in order to investigate the effect of homogenization time. Among the indices examined, the circularity index exhibited the most consistent variation with homogenization time. The lowest value of the circularity index coincided with the metallographic observation for necklace formation. Shorter homogenization times resulted in intermediate homogenization stages involving rounding of edges or particle pinching. The results indicated that the index-based quantification of the homogenization state could provide a credible method for the selection of homogenization process parameters towards enhanced extrudability

Modeling of Microsegregation and Homogenization of 6xxx Al-Alloys Including Precipitation and Strengthening During Homogenization Cooling

Control of the homogenization process is important in obtaining high extrudability and desirable properties in 6xxx aluminum alloys. Three consecutive steps of the process chain were modeled. Microsegregation arising from solidification was described with the Scheil−Gulliver model. Dissolution of Mg2Si, Si (diamond) and β-AlFeSi (β-Al5FeSi) to α-AlFeSi (α-Al12(FeMn)3Si) transformation during homogenization have been described with a CALPHAD-based multicomponent diffusion Dual-Grain Model (DGM), accounting for grain size inhomogeneity. Mg2Si precipitation and associated strengthening during homogenization cooling were modeled with the Kampmann−Wagner Numerical (KWN) precipitation framework. The DGM model indicated that the fractions of β-AlFeSi and α-AlFeSi exhibit an exact spatial and temporal correspondence during transformation. The predictions are in good agreement with experimental data. The KWN model indicated the development of a bimodal particle size distribution during homogenization cooling, arising from corresponding nucleation events. The associated strengthening, arising from solid solution and precipitation strengthening, was in good agreement with experimental results. The proposed modeling approach is a valuable tool for the prediction of microstructure evolution during the homogenization of 6xxx aluminum alloys, including the often-neglected part of homogenization cooling