Three dimensionality of pulsed second-sound waves in He II

Three dimensionality of 3D pulsed second sound wave in He II emitted from a finite size heater is experimentally investigated and theoretically studied based on two-fluid model in this study. The detailed propagation of 3D pulsed second sound wave is presented and reasonable agreement between the experimental and theoretical results is obtained. Heater size has a big influence on the profile of 3D second sound wave. The counterflow between the superfluid and normal fluid components becomes inverse in the rarefaction of 3D second sound wave. The amplitude of rarefaction decreases due to the interaction between second sound wave and quantized vortices, which explains the experimental results about second sound wave near [Phys. Rev. Lett. 73, 2480 (1994)]. The accumulation of dense quantized vortices in the vicinity of heater surface leads to the formation of a thermal boundary layer, and further increase of heating duration results in the occurrence of boiling phenomena. PACS numbers: 67.40.Pm 43.25.+y 67.40.BzComment: 30 pages, 9 figures. Physical Review B, Accepte

Polycrystalline Thin-Film Cadmium Telluride Solar Cells Fabricated by Electrodeposition; Final Technical Report, 20 March 1995-15 June 1998

This report summarizes work performed by the Colorado School of Mines Department of Physics under this subcontract. Based on the studies conducted, researchers increased the efficiency of the cells with electrodeposited CdTe and CBD CdS by 3% on average ({approx}30 relative %). The improvement came from 1. Optimization of CdS initial thickness taking into account CdS consumption of CdTe during the CdTe/CdS post-deposition treatment; optimization of CdS post-deposition treatment with CdCl2 aimed at prevention of Te diffusion into CdS and improvement of the CdS film morphology and electronic properties. That led to a considerable increase in short circuit current, by 13% on average. 2. Optimization of CdTe thickness and post-deposition treatment which led to a significant increase in Voc, by {approx}70 mV. The highest Voc obtained exceeded 800 mV. 3. Development of a ZnTe:Cu/Metal back contact processing procedure that included selection of optimal Cu content, deposition regime and post-deposition treatment conditions. As a result, back contact resistance as low as 0.1W-cm2 was obtained. The cell stability was measured on exposure to accelerated stress conditions. Preliminary studies of some new approaches to improvement of CdS/CdTe structure were conducted