Coulomb Drag of Massless Fermions in Graphene

Using a novel structure, consisting of two, independently contacted graphene single layers separated by an ultra-thin dielectric, we experimentally measure the Coulomb drag of massless fermions in graphene. At temperatures higher than 50 K, the Coulomb drag follows a temperature and carrier density dependence consistent with the Fermi liquid regime. As the temperature is reduced, the Coulomb drag exhibits giant fluctuations with an increasing amplitude, thanks to the interplay between coherent transport in the graphene layer and interaction between the two layers.Comment: 5 pages, 5 figure

Tuning of Fermi Contour Anisotropy in GaAs (001) 2D Holes via Strain

We demonstrate tuning of the Fermi contour anisotropy of two-dimensional (2D) holes in a symmetric GaAs (001) quantum well via the application of in-plane strain. The ballistic transport of high-mobility hole carriers allows us to measure the Fermi wavevector of 2D holes via commensurability oscillations as a function of strain. Our results show that a small amount of in-plane strain, on the order of $10^{-4}$, can induce significant Fermi wavevector anisotropy as large as 3.3, equivalent to a mass anisotropy of 11 in a parabolic band. Our method to tune the anisotropy \textit{in situ} provides a platform to study the role of anisotropy on phenomena such as the fractional quantum Hall effect and composite fermions in interacting 2D systems.Comment: Accepted to Applied Physics Letter

Direct Measurement of the Fermi Energy in Graphene Using a Double Layer Structure

We describe a technique which allows a direct measurement of the relative Fermi energy in an electron system using a double layer structure, where graphene is one of the two layers. We illustrate this method by probing the Fermi energy as a function of density in a graphene monolayer, at zero and in high magnetic fields. This technique allows us to determine the Fermi velocity, Landau level spacing, and Landau level broadening in graphene. We find that the N=0 Landau level broadening is larger by comparison to the broadening of upper and lower Landau levels.Comment: 5 pages, 4 figure

Realization of a High Mobility Dual-gated Graphene Field Effect Transistor with Al2O3 Dielectric

We fabricate and characterize dual-gated graphene field-effect transistors (FETs) using Al2O3 as top-gate dielectric. We use a thin Al film as a nucleation layer to enable the atomic layer deposition of Al2O3. Our devices show mobility values of over 8,000 cm2/Vs at room temperature, a finding which indicates that the top-gate stack does not significantly increase the carrier scattering, and consequently degrade the device characteristics. We propose a device model to fit the experimental data using a single mobility value.Comment: 3 pages, 3 figures; to appear in Appl. Phys. Let

Experimental investigation of thermal transport in graphene and hexagonal boron nitride

textTwo-dimensional graphene, a single layer of graphite, has emerged as an excellent candidate for future electronic material due to its unique electronic structure and remarkably high carrier mobility. Even higher carrier mobility has been demonstrated in graphene devices using hexagonal boron nitride as an underlying dielectric support instead of silicon oxide. Interestingly, both graphene and boron nitride exhibit superior thermal properties, therefore may potentially offer a solution to the increasingly severe heat dissipation problem in nanoelectronics caused by increased power density. In this thesis, we focus on the investigation of the thermal properties of graphene and hexagonal boron nitride. First, scanning thermal microscopy based on a sub-micrometer thermocouple at the apex of a microfabricated tip was employed to image the temperature profiles in electrically biased graphene devices with ~ 100 nm scale spatial resolution. Non-uniform temperature distribution in the devices was observed, and the "hot spot" locations were correlated with the charge concentrations in the channel, which could be controlled by both gate and drain-source biases. Hybrid contact and lift mode scanning has enabled us to obtain the quantitative temperature profiles, which were compared with the profiles obtained from Raman-based thermometry. The temperature rise in the channel provided an important insight into the heat dissipation mechanism in Joule-heated graphene devices. Next, thermal conductivity of suspended single and few-layer graphene was measured using a micro-bridge device with built-in resistance thermometers. Polymer-assisted transfer technique was developed to suspend graphene layers on the pre-fabricated device. The room temperature thermal conductivity values of 1-7 layer graphene were measured to be lower than that of bulk graphite, and the value appeared to increase with increasing sample thickness. These observations can be explained by the impact of the phonon scattering by polymer residue remaining on the sample surfaces. Lastly, thermal conductivity of few-layer hexagonal boron nitride sample was measured by using the same device and technique used for suspended graphene. Measurements on samples with different suspended lengths but similar thickness allowed us to extract the intrinsic thermal conductivity of the samples as well as the contribution of contact thermal resistance to the overall thermal measurement. The room temperature thermal conductivity of 11 layer sample approaches the basal-plane value reported in the bulk sample. Lower thermal conductivity was measured in a 5 layer sample than an 11 layer sample, which again supports the polymer effect on the thermal transport in few-layer hexagonal boron nitride.Physic

Signatures of an annular Fermi sea

The concept of a Fermi surface, the constant-energy surface containing all the occupied electron states in momentum, or wave-vector (k), space plays a key role in determining electronic properties of conductors. In two-dimensional (2D) carrier systems, the Fermi surface becomes a contour which, in the simplest case, encircles the occupied states. In this case, the area enclosed by the contour, which we refer to as the Fermi sea (FS), is a simple disk. Here we report the observation of an FS with a new topology, namely, an FS in the shape of an annulus. Such an FS is expected in a variety of 2D systems where the energy band dispersion supports a ring of extrema at finite k, but its experimental observation has been elusive. Our study provides (1) theoretical evidence for the presence of an annular FS in 2D hole systems confined to wide GaAs quantum wells and (2) experimental signatures of the onset of its occupation as an abrupt rise in the sample resistance, accompanied by a sudden appearance of Shubnikov-de Haas oscillations at an unexpectedly high frequency whose value does not simply correspond to the (negligible) density of holes contained within the annular FS