More Flexible Damping Systems for Blades and Vanes

The blades and the vanes of aero engines are subject to very high thermo-mechanical loads. In some cases, an additional damping system is necessary to reach the lifetime goals. Commonly, damping systems based on energy dissipation due to friction are used, e.g. under platform dampers for blades and spring dampers for the vanes. These damping systems have some limitations: under platform dampers work well mostly for just one mode family, their effectiveness is limited relative to rotational speed (because of the associated contact forces) and is dependent on the excitation order. The spring dampers work well for more than one mode family but their effectiveness is limited concerning the available contact force (just one value). Additionally, the use of the spring dampers requires a significant, sometimes suboptimal design change of the vane cluster. In this paper, some alternative damping systems are introduced and analyzed. All these new systems offer additional possibilities for damping and give more design flexibility. Two of them: insert damping and rocking damping are also based on frictional energy dissipation. The third one, impulse mistuning, adopts a special kind of absorption and is based on the so called targeted energy transfer. The analytical results for the insert damping systems were presented previously in Borufka et al. (2009), while in this paper the experimental validation by shaker tests is shown. The rocking damping was not presented so far – to the knowledge of the authors. Impulse mistuning was first presented in: Hartung and Retze (2011) and Hartung et al. (2016). In this work, an overview of such damping systems and some additional information on the experimental validation of some impulse mistuning systems are presented

ALFA: First Operational Experience of the MPE/MPIA Laser Guide Star System for Adaptive Optics

The sodium laser guide star adaptive optics system ALFA has been constructed at the Calar Alto 3.5-m telescope. Following the first detection of the laser beacon on the wavefront sensor in 1997 the system is now being optimized for best performance. In this contribution we discuss the current status of the launch beam and the planned improvements and upgrades. We report on the performance level achieved when it is used with the adaptive optics system, and relate various aspects of our experience during operation of the system. We have begun to produce scientific results and mention two of these.Comment: 9 pages, 6 figures, LaTeX (spie.sty). SPIE conf proc 3353, Adaptive Optical System Technologies, March 199

A Mechanism-Based Approach to Life Prediction for a Nickel-Base Alloy subjected to Cyclic and Creep-Fatigue

A large number of damage parameters have been proposed to estimate cyclic fatigue life predominantly at ambient temperatures. However, especially in aerospace and automotive industry fatigue models with a wide temperature application range are required. Here, the regimes of high temperature creep-fatigue and nonisothermal thermo-mechanical fatigue are of particular interest. Within the present work a new mechanism-based life prediction approach is proposed for a nickel-base superalloy. The ability of the model to describe fatigue at low, intermediate, and also at high temperatures is investigated. Isothermal, as well as non-isothermal loading conditions are considered. The enhanced model formulation is based on the micro crack growth parameter Z d introduced by Heitmann et al. (1984). The model incorporates a threshold concept and corrections for mean stress and creep effects. In addition the detrimental effects caused by oxygen-induced embrittlement of the near tip region are accounted for by a parabolic oxidation approach. Test data from literature is used to compare the proposed model to several other fatigue models. Basis for all life prediction approaches under investigation is the stress-strain response of the material obtained by finite element analysis. Therefore, an inelastic constitutive model is applied. The fatigue model accuracy is evaluated on a statistical basis through an evaluation of the variance in the ratio of predicted life to actual life. This is done for the entire test database as well as for subsets, like isothermal, thermo-mechanical, and dwell tests only

Cell-Free Synthesis of the Mitochondrial ADP/ATP Carrier Protein of Neurospora crassa

ADP/ATP carrier protein was synthesized in heterologous cell-free systems programmed with Neurospora poly(A)-containing RNA and homologous cell-free systems from Neurospora. The apparent molecular weight of the product obtained in vitro was the same as that of the authentic mitochondrial protein. The primary translation product obtained in reticulocyte lysates starts with formylmethionine when formylated initiator methionyl-tRNA (fMet-tRNAfMet) was present. The product synthesized in vitro was released from the ribosomes into the postribosomal supernatant. The evidence presented indicates that the ADP/ATP carrier is synthesized as a polypeptide with the same molecular weight as the mature monomeric protein and does not carry an additional sequence

On insertion-deletion systems over relational words

We introduce a new notion of a relational word as a finite totally ordered set of positions endowed with three binary relations that describe which positions are labeled by equal data, by unequal data and those having an undefined relation between their labels. We define the operations of insertion and deletion on relational words generalizing corresponding operations on strings. We prove that the transitive and reflexive closure of these operations has a decidable membership problem for the case of short insertion-deletion rules (of size two/three and three/two). At the same time, we show that in the general case such systems can produce a coding of any recursively enumerable language leading to undecidabilty of reachability questions.Comment: 24 pages, 8 figure

Different Transport Pathways of Individual Precursor Proteins in Mitochondria

Transport of mitochondrial precursor proteins into mitochondria of Neurospora crassa was studied in a cellfree reconstituted system. Precursors were synthesized in a reticulocyte lysate programmed with Neurospora mRNA and transported into isolated mitochondria in the absence of protein synthesis. Uptake of the following precursors was investigated: apocytochrome c, ADP/ATP carrier and subunit 9 of the oligomycin-sensitive ATPase. Addition of high concentrations of unlabelled chemically prepared apocytochrome c (1–10 μM) inhibited the appearance in the mitochondrial of labelled cytochrome c synthesized in vitro because the unlabelled protein dilutes the labelled one and because the translocation system has a limited capacity [apparent V is 1–3 pmol × min−1× (mg mitochondrial protein)−1]. Concentrations of added apocytochrome c exceeding the concentrations of precursor proteins synthesized in vitro by a factor of about 104 did not inhibit the transfer of ADP/ATP carrier or ATPase subunit 9 into mitochondria. Carbonylcyanide m-chlorophenylhydrazone, an uncoupler of oxidative phosphorylation, inhibited transfer in vitro of ADP/ATP carrier and of ATPase subunit 9, but not of cytochrome c. These findings suggest that cytochrome c and the other two proteins have different import pathways into mitochondria. It can be inferred from the data presented that different 'receptors' on the mitochondrial surface mediate the specific recognition of precursor proteins by mitochondria as a first step in the transport process

ContDist: a tool for the analysis of quantitative gene and promoter properties

<p>Abstract</p> <p>Background</p> <p>The understanding of how promoter regions regulate gene expression is complicated and far from being fully understood. It is known that histones' regulation of DNA compactness, DNA methylation, transcription factor binding sites and CpG islands play a role in the transcriptional regulation of a gene. Many high-throughput techniques exist nowadays which permit the detection of epigenetic marks and regulatory elements in the promoter regions of thousands of genes. However, so far the subsequent analysis of such experiments (e.g. the resulting gene lists) have been hampered by the fact that currently no tool exists for a detailed analysis of the promoter regions.</p> <p>Results</p> <p>We present ContDist, a tool to statistically analyze quantitative gene and promoter properties. The software includes approximately 200 quantitative features of gene and promoter regions for 7 commonly studied species. In contrast to "traditionally" ontological analysis which only works on qualitative data, all the features in the underlying annotation database are quantitative gene and promoter properties.</p> <p>Utilizing the strong focus on the promoter region of this tool, we show its usefulness in two case studies; the first on differentially methylated promoters and the second on the fundamental differences between housekeeping and tissue specific genes. The two case studies allow both the confirmation of recent findings as well as revealing previously unreported biological relations.</p> <p>Conclusion</p> <p>ContDist is a new tool with two important properties: 1) it has a strong focus on the promoter region which is usually disregarded by virtually all ontology tools and 2) it uses quantitative (continuously distributed) features of the genes and its promoter regions which are not available in any other tool. ContDist is available from <url>http://web.bioinformatics.cicbiogune.es/CD/ContDistribution.php</url></p

Sagittal jaw position in relation to body posture in adult humans – a rasterstereographic study

BACKGROUND: The correlations between the sagittal jaw position and the cranio – cervical inclination are described in literature. Only few studies focus on the sagittal jaw position and the body posture using valid and objective orthopaedic examination methods. The aim of this study was to test the hypothesis that patients with malocclusions reveal significant differences in body posture compared to those without (upper thoracic inclination, kyphotic angle, lordotic angle and lower lumbar inclination). METHODS: Eighty-four healthy adult patients (with a mean age = 25.6 years and ranging from 16.1 to 55.8 years) were examined with informed consent. The orthodontic examination horizontal overjet (distance between upper and lower incisors) was determined by using an orthodontic digital sliding calliper. The subjects were subdivided in respect of the overjet with the following results: 18 revealed a normal overjet (Class I), 38 had an increased overjet (Class II) and 28 had an reversed overjet (Class III). Rasterstereography was used to carry out a three – dimensional back shape analysis. This method is based on photogrammetry. A three-dimensional shape was produced by analysing the distortion of parallel horizontal white light lines projected on the patient's back, followed by mathematical modelling. On the basis of the sagittal profile the upper thoracic inclination, the thoracic angle, the lordotic angle and the pelvic inclination were determined with a reported accuracy of 2.8° and the correlations to the sagittal jaw position were calculated by means of ANOVA, Scheffé and Kruskal-Wallis procedures. RESULTS: Between the different overjet groups, no statistically significant differences or correlations regarding the analysed back shape parameters could be obtained. However, comparing males and females there were statistically significant differences in view of the parameters 'lordotic angle' and 'pelvic inclination'. CONCLUSION: No correlations between overjet and variables of the thoracic, lordotic or the pelvic inclination could be observed