Efficient readout of micromechanical resonator arrays in ambient conditions

We present a method for efficient spectral readout of mechanical resonator arrays in dissipative environments. Magnetomotive drive and detection is used to drive double clamped resonators in the nonlinear regime. Resonators with almost identical resonance frequencies can be tracked individually by sweeping the drive power. Measurements are performed at room temperature and atmospheric pressure. These conditions enable application in high throughput resonant sensor arrays.Comment: 4 pages, 4 figure

Strongly coupled modes in a weakly driven micromechanical resonator

We demonstrate strong coupling between the flexural vibration modes of a clamped-clamped micromechanical resonator vibrating at low amplitudes. This coupling enables the direct measurement of the frequency response via amplitude- and phase modulation schemes using the fundamental mode as a mechanical detector. In the linear regime, a frequency shift of $\mathrm{0.8\,Hz}$ is observed for a mode with a line width of $\mathrm{5.8\,Hz}$ in vacuum. The measured response is well-described by the analytical model based on the Euler-Bernoulli beam including tension. Calculations predict an upper limit for the room-temperature Q-factor of $\mathrm{4.5\times10^5}$ for our top-down fabricated micromechanical beam resonators.Comment: 9 pages, 2 figure

Nanomechanical properties of few-layer graphene membranes

We have measured the mechanical properties of few-layer graphene and graphite flakes that are suspended over circular holes. The spatial profile of the flake's spring constant is measured with an atomic force microscope. The bending rigidity of and the tension in the membranes are extracted by fitting a continuum model to the data. For flakes down to eight graphene layers, both parameters show a strong thickness-dependence. We predict fundamental resonance frequencies of these nanodrums in the GHz range based on the measured bending rigidity and tension.Comment: 9 pages, 3 figures, This article has been accepted by Appl. Phys. Lett. After it is published, it will be found at http://apl.aip.org

Discrete-time quadrature feedback cooling of a radio-frequency mechanical resonator

We have employed a feedback cooling scheme, which combines high-frequency mixing with digital signal processing. The frequency and damping rate of a 2 MHz micromechanical resonator embedded in a dc SQUID are adjusted with the feedback, and active cooling to a temperature of 14.3 mK is demonstrated. This technique can be applied to GHz resonators and allows for flexible control strategies.Comment: To appear in Appl. Phys. Let

Electric-field control of interfering transport pathways in a single-molecule anthraquinone transistor

It is understood that molecular conjugation plays an important role in charge transport through single-molecule junctions. Here, we investigate electron transport through an anthraquinone based single-molecule three-terminal device. With the use of an electric-field induced by a gate electrode, the molecule is reduced resulting into a ten-fold increase in the off-resonant differential conductance. Theoretical calculations link the change in differential conductance to a reduction-induced change in conjugation, thereby lifting destructive interference of transport pathways.Comment: Nano Letters (2015

In-Chain Tunneling Through Charge-Density Wave Nanoconstrictions and Break-Junctions

We have fabricated longitudinal nanoconstrictions in the charge-density wave conductor (CDW) NbSe$_{3}$ using a focused ion beam and using a mechanically controlled break-junction technique. Conductance peaks are observed below the T$_{P1}$$=145$K and T$_{P2}$$=59$K CDW transitions, which correspond closely with previous values of the full CDW gaps $2\Delta_{1}$ and $2\Delta_{2}$ obtained from photo-emission. These results can be explained by assuming CDW-CDW tunneling in the presence of an energy gap corrugation $\epsilon_{2}$ comparable to $\Delta_{2}$, which eliminates expected peak at $\Delta_{1}+\Delta_{2}$. The nanometer length-scales our experiments imply indicate that an alternative explanation based on tunneling through back-to-back CDW-normal junctions is unlikely.Comment: 5 pages, 3 figures, submitted to physical review letter

Single-vortex-induced voltage steps in Josephson-junction arrays

We have numerically and analytically studied ac+dc driven Josephson-junction arrays with a single vortex or with a single vortex-antivortex pair present. We find single-vortex steps in the voltage versus current characteristics (I-V) of the array. They correspond microscopically to a single vortex phase-locked to move a fixed number of plaquettes per period of the ac driving current. In underdamped arrays we find vortex motion period doubling on the steps. We observe subharmonic steps in both underdamped and overdamped arrays. We successfully compare these results with a phenomenological model of vortex motion with a nonlinear viscosity. The I-V of an array with a vortex-antivortex pair displays fractional voltage steps. A possible connection of these results to present day experiments is also discussed.Comment: 10 pages double sided with figures included in the text. To appear in Journal of Physics, Condensed Matte