Possible Verification of Tilted Anisotropic Dirac Cone in \alpha-(BEDT-TTF)_2 I_3 Using Interlayer Magnetoresistance

It is proposed that the presence of a tilted and anisotropic Dirac cone can be verified using the interlayer magnetoresistance in the layered Dirac fermion system, which is realized in quasi-two-dimensional organic compound \alpha-(BEDT-TTF)_2 I_3. Theoretical formula is derived using the analytic Landau level wave functions and assuming local tunneling of electrons. It is shown that the resistivity takes the maximum in the direction of the tilt if anisotropy of the Fermi velocity of the Dirac cone is small. The procedure is described to determine the parameters of the tilt and anisotropy.Comment: 4 pages, 4 figures, corrected Fig.

Atmospheric-pressure plasma seawater desalination: Clean energy, agriculture, and resource recovery nexus for a blue planet

Water connects every aspect of life. Only 4% of the world's water is fresh water, as most water sources have different degrees of salinity. As a result, billions of people face water scarcity, which is a global challenge. Desalination technologies that separate fresh water from solvated salt ions in saline water are attracting major attention. However, conventional desalination processes including thermally and pressure driven processes are highly energy intensive. To address this issue we demonstrate that the atmospheric-pressure plasma (APP) treatment of saline water can be a new potential alternative low-energy and green desalination route. Valuable salts are recovered by direct salt crystal precipitation within a short plasma processing time. During desalination and salt precipitation, plasma activated desalinated water (PADW) is generated and can be used for clean energy processes such as water electrolysis and sustainable agriculture by enhanced plant seed germination. In addition, functional nanomaterials can be extracted from the precipitated salt. The PADW exhibited a low salinity of 5.6 mS/cm with a low pH value of 2.1. The unique intrinsic PADW chemistries enabled electrochemical water splitting for both the hydrogen evolution reaction (HER) at a Pt electrode and the oxygen evolution reaction (OER) at a RuO2 electrode. Moreover, the feasibility of using PADW in sustainable agriculture was demonstrated by enhancing mungbean seed germination using tap water mixed with PADW. At optimum mix concentration, both seed germination rates and germination percentages increased. Finally, we demonstrated the feasibility of synthesizing high-value 2D nanomaterials exemplified by Mg(OH)2 nanosheets via a single step thermal process using the salt precipitated from the seawater by the plasma process. Combined with straightforward use of renewable electricity to generate APPs, this study reveals the plasma potential for sustainable recovery of clean water, clean energy applications, sustainable agriculture, and manufacturing of advanced functional nanomaterials – all from the greatest treasure of our blue planet – seawater.</p

Intrinsic and Extrinsic Performance Limits of Graphene Devices on SiO2

The linear dispersion relation in graphene[1,2] gives rise to a surprising prediction: the resistivity due to isotropic scatterers (e.g. white-noise disorder[3] or phonons[4-8]) is independent of carrier density n. Here we show that acoustic phonon scattering[4-6] is indeed independent of n, and places an intrinsic limit on the resistivity in graphene of only 30 Ohm at room temperature (RT). At a technologically-relevant carrier density of 10^12 cm^-2, the mean free path for electron-acoustic phonon scattering is >2 microns, and the intrinsic mobility limit is 2x10^5 cm^2/Vs, exceeding the highest known inorganic semiconductor (InSb, ~7.7x10^4 cm^2/Vs[9]) and semiconducting carbon nanotubes (~1x10^5 cm^2/Vs[10]). We also show that extrinsic scattering by surface phonons of the SiO2 substrate[11,12] adds a strong temperature dependent resistivity above ~200 K[8], limiting the RT mobility to ~4x10^4 cm^2/Vs, pointing out the importance of substrate choice for graphene devices[13].Comment: 16 pages, 3 figure

A transverse current rectification in graphene superlattice

A model for energy spectrum of superlattice on the base of graphene placed on the striped dielectric substrate is proposed. A direct current component which appears in that structure perpendicularly to pulling electric field under the influence of elliptically polarized electromagnetic wave was derived. A transverse current density dependence on pulling field magnitude and on magnitude of component of elliptically polarized wave directed along the axis of a superlattice is analyzed.Comment: 12 pages, 6 figure

Aliphatic polyketone-based thin film composite membrane with mussel-inspired polydopamine intermediate layer for high performance osmotic power generation

Polydopamine (PDA), formed from self-polymerization of dopamine, was coated on aliphatic polyketone membrane substrate prior to interfacial polymerization (IP), preparing a pressure retarded osmosis (PRO) thin film composite (TFC) membrane with a PDA interlayer. The effect of the formation of two types of PDA interlayers — smooth and particulate — on substrate morphology, polyamide formation, and PRO osmotic performance were investigated. Also, the effect of pH on the particulate PDA interlayer was studied. It was found that the introduction of both smooth and particulate PDA contributes to enhanced water flux and power density of the PRO membranes. pH was found to have significantly affected the formation of particulate PDA and the polyamide formation, as well. At higher pH, PDA self-polymerization led to the formation of more nanoparticles, the subsequent increase in surface roughness and decline in the polyketone substrate porosity. The particulate PDA interlayer formed looser polyamide, compared to the thinner and denser polyamide formed on pristine and smooth PDA-interlayer-coated TFC membranes. The membrane performance was evaluated using deionized water and 1.0 M NaCl as feed and draw solutions, respectively. The TFC membrane with nanoparticulate PDA layer formed at pH 9.0 exhibited the best initial water flux of 40.8 L m−2 h−1, and this membrane also showed the highest power density of 17.1 W m−2 at 25 bar. The results of this study indicate that nanoparticulate PDA interlayer formation is a simple and scalable TFC membrane development method for engineered osmosis

Sizing Up the Impact of Embassies on Exports

The purpose of this study is to test for the effects of trade promotion via the foreign service. We develop a Melitz-based model where firms are heterogeneous with respect to productivity and must pay a beachhead cost to enter a foreign market, which can be reduced by government spending on trade promotion. The model predicts that unilateral trade promotion allows medium-sized firms to export. We test this prediction using Swedish firm-level data and information on the opening and closing of Swedish embassies abroad using Norwegian firms as control group. Our results lend support to the predictions of the model, with large and medium-sized firms responding most strongly to the opening of embassies

Three-dimensional fluid simulation of a plasma display panel cell

In order to understand the discharge characteristics in an alternating current plasma display panel (ac PDP) and optimize it further, a three-dimensional fluid code (FL3P) has been developed. Using this simulator, various three-dimensional features of discharges are investigated in the sustain mode of PDP. First, the striations of wall charge are observed at both the anode and cathode side. Second, the local efficiency is obtained as a function of position. It is mainly divided into the anode region and the cathode region and highest near the anode center. Finally, the effects of various three-dimensional parameters are studied. As one of the examples showing the effect of electrode shaping, the discharge characteristics of a T-shaped electrode cell are compared with those of a conventional cell. The phosphor on barrier ribs contributes to over 44% of the total luminance, but barrier ribs themselves do not play an important role in the overall discharge efficiency. Address electrode width is not always proportional to the size of the discharge because of the wall loss of the particles to barrier ribs.open435

Dynamical symmetry breaking in a 2D electron gas with a spectral node

We study a disordered 2D electron gas with a spectral node in a vicinity of the node. After identifying the fundamental dynamical symmetries of this system, the spontaneous breaking of the latter by a Grassmann field is studied within a nonlinear sigma model approach. This allows us to reduce the average two-particle Green's function to a diffusion propagator with a random diffusion coefficient. The latter has non-degenerate saddle points and is treated by the conventional self-consistent Born approximation. This leads to a renormalized chemical potential and a renormalized diffusion coefficient, where the DC conductivity increases linearly with the density of quasiparticles. Applied to the special case of Dirac fermions, our approach provides a comprehensive description of the minimal conductivity at the Dirac node as well as for the V-shape conductivity inside the bands.Comment: 13 pages, 4 figures, extended versio