Experimental demonstration of a high quality factor photonic crystal microcavity

Sub-threshold measurements of a photonic crystal (PC) microcavity laser operating at 1.3 microns show a linewidth of 0.10 nm, corresponding to a quality factor Q ~ 1.3x10^4. The PC microcavity mode is a donor-type mode in a graded square lattice of air holes, with a theoretical Q ~ 10^5 and mode volume Veff ~ 0.25 cubic half-wavelengths in air. Devices are fabricated in an InAsP/InGaAsP multi-quantum well membrane and are optically pumped at 830 nm. External peak pump power laser thresholds as low as 100 microWatts are also observed

Deviation from Snell's Law for Beams Transmitted Near the Critical Angle: Application to Microcavity Lasers

We show that when a narrow beam is incident upon a dielectric interface near the critical angle for total internal reflection it will be transmitted into the far-field with an angular deflection from the direction predicted by Snell's Law, due to a phenomenon we call "Fresnel Filtering". This effect can be quite large for the parameter range relevant to dielectric microcavity lasers.Comment: 4 pages, 3 figures (eps), RevTeX 3.1, to be published in Optics Letter

High-Power Directional Emission from Microlasers with Chaotic Resonators

High-power and highly directional semiconductor cylinder-lasers based on an optical resonator with deformed cross section are reported. In the favorable directions of the far-field, a power increase of up to three orders of magnitude over the conventional circularly symmetric lasers was obtained. A "bow-tie"-shaped resonance is responsible for the improved performance of the lasers in the higher range of deformations, in contrast to "whispering-gallery"-type modes of circular and weakly deformed lasers. This resonator design, although demonstrated here in midinfrared quantum-cascade lasers, should be applicable to any laser based on semiconductors or other high-refractive index materials.Comment: Removed minor discrepancies with published version in the text and in Fig.

Scars on quantum networks ignore the Lyapunov exponent

We show that enhanced wavefunction localization due to the presence of short unstable orbits and strong scarring can rely on completely different mechanisms. Specifically we find that in quantum networks the shortest and most stable orbits do not support visible scars, although they are responsible for enhanced localization in the majority of the eigenstates. Scarring orbits are selected by a criterion which does not involve the classical Lyapunov exponent. We obtain predictions for the energies of visible scars and the distributions of scarring strengths and inverse participation ratios.Comment: 5 pages, 2 figure

Quantum cascade photonic crystal surface emitting injection laser

A surface emitting quantum cascade injection laser is presented. Direct surface emission is obtained by using a 2D photonic-band-gap structure that simultaneously acts as a microcavity. The approach may allow miniaturization and on-chip-integration of the devices

Observation of emission from chaotic lasing modes in deformed microspheres: displacement by the stable orbit modes

By combining detailed imaging measurements at different tilt angles with simulations of ray emission from prolate deformed lasing micro-droplets, we conclude that the probability density for the lasing modes in a three-dimensional dielectric microcavity must reside in the chaotic region of the ray phase space. In particular, maximum emission from such chaotic lasing modes is not from tangent rays emerging from the highest curvature part of the rim. The laser emission is observed and calculated to be non-tangent and displaced from the highest curvature due to the presence of stable orbits. In this Letter we present the first experimental evidence for this phenomenon of ``dynamical eclipsing''.Comment: 4 figure

Fabrication methods for a quantum cascade photonic crystal surface emitting laser

Conventional quantum cascade (QC) lasers are intrinsically edge-emitting devices with mode confinement achieved via a standard mesa stripe configuration. Surface emission in edge emitting QC lasers has therefore necessitated redirecting the waveguided laser emission using a second order grating. This paper describes the methods used to fabricate a 2D photonic crystal (PC) structure with or without a central defect superimposed on an electrically pumped QC laser structure with the goal of achieving direct surface emission. A successful systematic study of PC hole radius and spacing was performed using e-beam lithography. This PC method offers the promise of a number of interesting applications, including miniaturization and integration of QC lasers

Lasing mode pattern of a quantum cascade photonic crystal surface-emitting microcavity laser

The identification of the lasing mode within a quantum cascade photonic crystal microcavity laser emitting at λ ~8 µm is presented. The symmetry of the lasing mode is determined by the position of nodal lines within micro-bolometer camera measurements of its polarized spatial distribution. Full three-dimensional finite-difference time-domain simulations are also performed, and the resulting vertically emitted radiation field pattern is seen to follow the experimental results closely

Steady-State Ab Initio Laser Theory for N-level Lasers

We show that Steady-state Ab initio Laser Theory (SALT) can be applied to find the stationary multimode lasing properties of an N-level laser. This is achieved by mapping the N-level rate equations to an effective two-level model of the type solved by the SALT algorithm. This mapping yields excellent agreement with more computationally demanding N-level time domain solutions for the steady state