Absorption and emission spectra of U4 + diluted in the incommensurate structure of ThCl4

The absorption and fluorescence spectra of U4+ diluted in single crystals of ThCl4 have been measured at temperatures ranging from 4.2 K to room temperature. β-ThCl4 exhibits on incommensurate structure below 70 K with a loss of periodicity along the c axis. This results in a variation of the distance between the metal and the halogen from one cell to another. The site symmetry of the actinide ions is then reduced. The lines corresponding to the sites of the resulting symmetries S4 and D2 are identified spectroscopically. The S4 symmetry is approximated by the D2d one and a parametric analysis of the energy levels of U4 + in the D2d and D 2 symmetries is reported. For 25 levels in the D2d site the root mean square deviation σ is 46 cm-1 and for 34 levels in D2, σ = 56 cm-1. The parameters which occur in both symmetries are only slightly changed

Influence of water adsorbed on gold on van der Waals/Casimir forces

In this paper we investigate the influence of ultra thin water layer (1-1.5 nm) on the van der Waals/Casimir force between gold surfaces. Adsorbed water is inevitably present on gold surfaces at ambient conditions as jump-up-to contact during adhesion experiments demonstrate. Calculations based on the Lifshitz theory give very good agreement with the experiment in absence of any water layer for surface separations d>10 nm. However, a layer of thickness h<1.5 nm is allowed by the error margin in force measurements. At shorter separations, d<10 nm, the water layer can have a strong influence as calculations show for flat surfaces. Nonetheless, in reality the influence of surface roughness must also be considered, and it can overshadow any water layer influence at separations comparable to the total sphere-plate rms roughness w_{shp}+w.Comment: 8 pages, 5 figure, to be published in Phys. Rev.

Bone age estimation with the Greulich-Pyle atlas using 3T MR images of hand and wrist.

The age estimation of the hand bones by means of X-ray examination is a pillar of the forensic age estimation. Since the associated radiation exposure is controversial, the search for ionizing radiation-free alternatives such as MRI is part of forensic research. The aim of the current study was to use the Greulich-Pyle (GP) atlas on MR images of the hand and wrist to provide reference values for assessing the age of the hand bones. 3T hand MR images of 238 male participants between the ages of 13 and 21 were acquired using 3D gradient echo sequences (VIBE, DESS). Two readers rated the images using the X-ray-based GP atlas method. A descriptive analysis and a transitional analysis were used for the statistical processing of the data. The agreement between and within the raters was assessed. In addition, a comparison was made with the chronological age and with X-ray studies. The descriptive analysis and the transition analysis showed similar results. Both evaluations showed good agreement with X-ray studies. The comparison with the chronological age showed a difference of 0.37 and 0.54 years for the two readers. The age estimate based on the cross-validated transition analysis showed a mean error of -0.28 years. Inter- and intra-rater agreement were good. In summary, it can be concluded that age estimation of hand bones with MR images is routinely applicable with the GP atlas as an alternative without ionizing radiation. However, in order to reduce the estimation error, a multi-factorial assessment based on examinations of several body regions is still recommended

Design and Manufacture of the Superconducting Bus-bars for the LHC Main Magnets

The main magnets of the LHC are series-connected electrically in different powering circuits by means of superconducting bus-bars, carrying a maximum current of 13 kA. These superconducting bus-bars consist of a superconducting cable thermally and electrically coupled to a copper profile all along the length. The function of the copper profile is essentially to provide an alternative path for the current in case the superconducting cable loses its superconducting state and returns to normal state because of a transient disturbance or of a normal zone propagation coming from the neighbouring magnets. When a superconducting bus-bar quenches to normal state its temperature must always stay below a safe values of about 100°C while the copper is conducting. When a resistive transition is detected, the protection systems triggers the ramping down of the current from 13000 A to 0. The ramp rate must not exceed a maximum value to avoid the transition of magnets series-connected in the circuit. This paper concerns the design and the manufacture of the high current superconducting bus-bars needed to interconnect the magnetic elements of the main dipoles, the main quadrupoles of the arcs and of the dispersion suppressors of the LHC