157 research outputs found
Electrochemical polymerisation of phenol in aqueous solution on a Ta/PbO2 anode
This paper deals with the treatment of aqueous phenol solutions using an electrochemical technique. Phenol can be partly eliminated from aqueous solution by electrochemically initiated polymerisation. Galvanostatic electrolyses of phenol solutions at concentration up to 0.1 mol dm−3 were carried out on a Ta/PbO2 anode. The polymers formed are insoluble in acidic medium but soluble in alkaline. These polymers were filtered and then dissolved in aqueous solution of sodium hydroxide (1 mol dm−3). The polymers formed were quantified by total organic carbon (TOC) measurement. It was found that the conversion of phenol into polymers increases as a function of initial concentration, anodic current density, temperature, and solution pH. The percentage of phenol polymerised can reach 15%
Demonstrating Aqueous-Phase Low-Molecular-Weight-Gel Wicking of Oil for the Remediation of Oil Spilled into Surface Water
Oils spilled into surface water require effective and timely
treatment. In this paper, we report on a low-molecular-weight gelator that can form gels in organic and aqueous phases. The aqueous gel was observed to absorb oils, which is proposed as a new class of materials for remediating
oil spilled into surface water. The gels and the low molecular-weight gelator have both fundamental and applied significance. Fundamentally, identifying the mechanisms that govern the formation of these gels and their resultant mechanical properties is of interest. Subsequently, these fundamental insights aid in the optimization of these gels for addressing spilled oil. First, we briefly compare the organic and aqueous gels qualitatively before focusing on the aqueous gel. Second, we demonstrate the ability of the aqueous gel to wick oils through experiments in a Hele-Shaw cell and compare our results to the Washburn equation for porous media. The Washburn equation is not entirely adequate in describing our results due to the change in volume of the porous media during the wicking process. Finally, we investigate mechanisms proposed to govern the formation of low-molecular-weight gels in the literature through rheological shear measurements during gel formation. Our experiments suggest that the proposed mechanisms are applicable to our aqueous gels, growing as anisotropic crystal networks with fractal dimensions between one and two dimensions from temporally sporadic nucleation sites
Four-electron deoxygenative reductive coupling of carbon monoxide at a single metal site
Carbon dioxide is the ultimate source of the fossil fuels that are both central to modern life and problematic: their use increases atmospheric levels of greenhouse gases, and their availability is geopolitically constrained. Using carbon dioxide as a feedstock to produce synthetic fuels might, in principle, alleviate these concerns. Although many homogeneous and heterogeneous catalysts convert carbon dioxide to carbon monoxide, further deoxygenative coupling of carbon monoxide to generate useful multicarbon products is challenging. Molybdenum and vanadium nitrogenases are capable of converting carbon monoxide into hydrocarbons under mild conditions, using discrete electron and proton sources. Electrocatalytic reduction of carbon monoxide on copper catalysts also uses a combination of electrons and protons, while the industrial Fischer–Tropsch process uses dihydrogen as a combined source of electrons and electrophiles for carbon monoxide coupling at high temperatures and pressures6. However, these enzymatic and heterogeneous systems are difficult to probe mechanistically. Molecular catalysts have been studied extensively to investigate the elementary steps by which carbon monoxide is deoxygenated and coupled, but a single metal site that can efficiently induce the required scission of carbon–oxygen bonds and generate carbon–carbon bonds has not yet been documented. Here we describe a molybdenum compound, supported by a terphenyl–diphosphine ligand, that activates and cleaves the strong carbon–oxygen bond of carbon monoxide, enacts carbon–carbon coupling, and spontaneously dissociates the resulting fragment. This complex four-electron transformation is enabled by the terphenyl–diphosphine ligand, which acts as an electron reservoir and exhibits the coordinative flexibility needed to stabilize the different intermediates involved in the overall reaction sequence. We anticipate that these design elements might help in the development of efficient catalysts for converting carbon monoxide to chemical fuels, and should prove useful in the broader context of performing complex multi-electron transformations at a single metal site
Influence of temperature and applied potential on the permeability of polyphenol films prepared on vitreous carbon in acid and alkaline media
The electrochemical polymerization of phenol is known to rapidly produce a thin insulating film at the anode surface. This film generally blocks further polymerization. The objective of this study is to show that, depending on the operating conditions, polymeric films resulting from phenol oxidation present different properties and that certain films can be so porous that they allow the oxidation of phenol to continue. The deposition of polyphenol films with improved permeability could be attractive in the removal of phenol from polluted solutions. Polyphenol films were prepared in aqueous solution on a vitreous carbon anode either by cyclic voltammetry or by electro-oxidation at constant potential. The apparent permeability P (%) of the films prepared by these techniques was evaluated by monitoring changes in the electrode response towards phenol and potassium ferricyanide at 25 and 85°C and as a function of the potential applied during electropolymerization performed either in acidic (1 mol L-¹H₂SO₄) or in alkaline (1 mol L-¹ NaOH) aqueous solution. It was shown that: (1) the polyphenol film electrosynthesized in alkaline medium was more permeable than that prepared in acidic medium, (2) the apparent permeability was higher when the polyphenol film was electrosynthesized with simultaneous oxygen evolution and (3) the use of a high temperature in the polyphenol film preparation, especially in the presence of a concomitant oxygen evolution, significantly enhanced its apparent permeability (P ≥ 100 %). These results are interpreted in terms of a mixed-transport mechanism involving both pore and membrane diffusion. The effect of the permeability of the polymeric film on the removal of phenol from aqueous solution by electropolymerization is discussed
Influence of temperature and applied potential on the permeability of polyphenol films prepared on vitreous carbon in acid and alkaline media
The electrochemical polymerization of phenol is known to rapidly produce a thin insulating film at the anode surface. This film generally blocks further polymerization. The objective of this study is to show that, depending on the operating conditions, polymeric films resulting from phenol oxidation present different properties and that certain films can be so porous that they allow the oxidation of phenol to continue. The deposition of polyphenol films with improved permeability could be attractive in the removal of phenol from polluted solutions. Polyphenol films were prepared in aqueous solution on a vitreous carbon anode either by cyclic voltammetry or by electro-oxidation at constant potential. The apparent permeability P (%) of the films prepared by these techniques was evaluated by monitoring changes in the electrode response towards phenol and potassium ferricyanide at 25 and 85°C and as a function of the potential applied during electropolymerization performed either in acidic (1 mol L-¹H₂SO₄) or in alkaline (1 mol L-¹ NaOH) aqueous solution. It was shown that: (1) the polyphenol film electrosynthesized in alkaline medium was more permeable than that prepared in acidic medium, (2) the apparent permeability was higher when the polyphenol film was electrosynthesized with simultaneous oxygen evolution and (3) the use of a high temperature in the polyphenol film preparation, especially in the presence of a concomitant oxygen evolution, significantly enhanced its apparent permeability (P ≥ 100 %). These results are interpreted in terms of a mixed-transport mechanism involving both pore and membrane diffusion. The effect of the permeability of the polymeric film on the removal of phenol from aqueous solution by electropolymerization is discussed
Work-life balance in the police: the development of a self-management competency framework
Purpose Addressing a gap in the current work–life balance (WLB) literature regarding individual-focused approaches to inform interventions, we elicited behaviors used to self-manage WLB to draw up a competency-based WLB framework for relevant learnable knowledge, skills, and abilities (KSAs; Hoffmann, Eur J Ind Train 23:275–285, 1999) and mapping this against extant WLB frameworks. Design/Methodology/Approach Our participants were from a major UK police force, which faces particular challenges to the work–life interface through job demands and organizational cutbacks, covering a range of operational job roles, including uniformed officers and civilian staff. We took a mixed methods approach starting with semi-structured interviews to elicit 134 distinct behaviors (n = 20) and used a subsequent card sort task (n = 10) to group these into categories into 12 behavioral themes; and finally undertook an online survey (n = 356) for an initial validation. Findings Item and content analysis reduced the behaviors to 58, which we analyzed further. A framework of eight competencies fits the data best; covering a range of strategies, including Boundary Management, Managing Flexibility, and Managing Expectations. Implications The WLB self-management KSAs elicited consist of a range of solution-focused behaviors and strategies, which could inform future WLB-focused interventions, showing how individuals may negotiate borders effectively in a specific environment. Originality/Value A competence-based approach to WLB self-management is new, and may extend existing frameworks such as Border Theory, highlighting a proactive and solution-focused element of effective behaviors
Solar conversion of CO2 to CO using Earth-abundant electrocatalysts prepared by atomic layer modification of CuO
Chemical Recycling of Carbon Dioxide to Methanol and Dimethyl Ether: From Greenhouse Gas to Renewable, Environmentally Carbon Neutral Fuels and Synthetic Hydrocarbons
- …