4,893 research outputs found
Ultra-high-sensitivity two-dimensional bend sensor
A multicore fibre Fabry-Perot-based strain sensor interrogated with tandem interferometry for bend measurement is described. Curvature in two dimensions is obtained by measuring the difference in strain between three co-located low finesse Fabry-Perot interferometers formed in each core of the fibre by pairs of Bragg gratings. This sensor provides a responsivity enhancement of up to 30 times that of a previously reported fibre Bragg grating based sensor. Strain resolutions of 0.6 n epsilon/Hz(1/2) above 1 Hz are demonstrated, which corresponds to a curvature resolution of similar to 0.012 km(-1)/Hz(1/2)
Interaction of Supernova Ejecta with Nearby Protoplanetary Disks
The early Solar System contained short-lived radionuclides such as 60Fe (t1/2
= 1.5 Myr) whose most likely source was a nearby supernova. Previous models of
Solar System formation considered a supernova shock that triggered the collapse
of the Sun's nascent molecular cloud. We advocate an alternative hypothesis,
that the Solar System's protoplanetary disk had already formed when a very
close (< 1 pc) supernova injected radioactive material directly into the disk.
We conduct the first numerical simulations designed to answer two questions
related to this hypothesis: will the disk be destroyed by such a close
supernova; and will any of the ejecta be mixed into the disk? Our simulations
demonstrate that the disk does not absorb enough momentum from the shock to
escape the protostar to which it is bound. Only low amounts (< 1%) of mass loss
occur, due to stripping by Kelvin-Helmholtz instabilities across the top of the
disk, which also mix into the disk about 1% of the intercepted ejecta. These
low efficiencies of destruction and injectation are due to the fact that the
high disk pressures prevent the ejecta from penetrating far into the disk
before stalling. Injection of gas-phase ejecta is too inefficient to be
consistent with the abundances of radionuclides inferred from meteorites. On
the other hand, the radionuclides found in meteorites would have condensed into
dust grains in the supernova ejecta, and we argue that such grains will be
injected directly into the disk with nearly 100% efficiency. The meteoritic
abundances of the short-lived radionuclides such as 60Fe therefore are
consistent with injection of grains condensed from the ejecta of a nearby (< 1
pc) supernova, into an already-formed protoplanetary disk.Comment: 57 pages, 16 figure
Effectiveness and reach of a directed-population approach to improving dental health and reducing inequalities: a cross sectional study
Background
Childsmile School adopts a directed-population approach to target fluoride varnish applications to 20% of the primary one (P1) population in priority schools selected on the basis of the proportion of enrolled children considered to be at increased-risk of developing dental caries. The study sought to compare the effectiveness of four different methods for identifying individuals most in need when a directed-population approach is taken. <p></p>
Methods
The 2008 Basic National Dental Inspection Programme (BNDIP) cross-sectional P1 Scottish epidemiological survey dataset was used to model four methods and test three definitions of increased-risk. Effectiveness was determined by the positive predictive value (PPV) and explored in relation to 1-sensitivity and 1-specificity. <p></p>
Results
Complete data was available on 43470 children (87% of the survey). At the Scotland level, at least half (50%) of the children targeted were at increased-risk irrespective of the method used to target or the definition of increased-risk. There was no one method across all definitions of <i>increased-risk</i> that maximised PPV. Instead, PPV was highest when the targeting method complimented the definition of <i>increased-risk</i>. There was a higher percentage of children at <i>increased-risk</i> who were not targeted (1-sensitivity) when caries experience (rather than deprivation) was used to define <i>increased-risk</i>, irrespective of the method used for targeting. Over all three definitions of <i>increased-risk</i>, there was no one method that minimised (1-sensitivity) although this was lowest when the method and definition of <i>increased-risk</i> were complimentary. The false positive rate (1-specificity) for all methods and all definitions of <i>increased-risk</i> was consistently low (<20%), again being lowest when the method and definition of <i>increased-risk</i> were complimentary. <p></p>
Conclusion
Developing a method to reach all (or even the vast majority) of individuals at <i>increased-risk</i> defined by either caries experience or deprivation is difficult using a directed-population approach at a group level. There is a need for a wider debate between politicians and public health experts to decide how best to reach those most at need of intervention to improve health and reduce inequalities. <p></p>
Quantitative localized proton-promoted dissolution kinetics of calcite using scanning electrochemical microscopy (SECM)
Scanning electrochemical microscopy (SECM) has been used to determine quantitatively the kinetics of proton-promoted dissolution of the calcite (101Ì
4) cleavage surface (from natural âIceland Sparâ) at the microscopic scale. By working under conditions where the probe size is much less than the characteristic dislocation spacing (as revealed from etching), it has been possible to measure kinetics mainly in regions of the surface which are free from dislocations, for the first time. To clearly reveal the locations of measurements, studies focused on cleaved âmirrorâ surfaces, where one of the two faces produced by cleavage was etched freely to reveal defects intersecting the surface, while the other (mirror) face was etched locally (and quantitatively) using SECM to generate high proton fluxes with a 25 ÎŒm diameter Pt disk ultramicroelectrode (UME) positioned at a defined (known) distance from a crystal surface. The etch pits formed at various etch times were measured using white light interferometry to ascertain pit dimensions. To determine quantitative dissolution kinetics, a moving boundary finite element model was formulated in which experimental time-dependent pit expansion data formed the input for simulations, from which solution and interfacial concentrations of key chemical species, and interfacial fluxes, could then be determined and visualized. This novel analysis allowed the rate constant for proton attack on calcite, and the order of the reaction with respect to the interfacial proton concentration, to be determined unambiguously. The process was found to be first order in terms of interfacial proton concentration with a rate constant k = 6.3 (± 1.3) Ă 10â4 m sâ1. Significantly, this value is similar to previous macroscopic rate measurements of calcite dissolution which averaged over large areas and many dislocation sites, and where such sites provided a continuous source of steps for dissolution. Since the local measurements reported herein are mainly made in regions without dislocations, this study demonstrates that dislocations and steps that arise from such sites are not needed for fast proton-promoted calcite dissolution. Other sites, such as point defects, which are naturally abundant in calcite, are likely to be key reaction sites
Theory of Pump Depletion and Spike Formation in Stimulated Raman Scattering
By using the inverse spectral transform, the SRS equations are solved and the
explicit output data is given for arbitrary laser pump and Stokes seed profiles
injected on a vacuum of optical phonons. For long duration laser pulses, this
solution is modified such as to take into account the damping rate of the
optical phonon wave. This model is used to interprete the experiments of Druhl,
Wenzel and Carlsten (Phys. Rev. Lett., (1983) vol. 51, p. 1171), in particular
the creation of a spike of (anomalous) pump radiation. The related nonlinear
Fourier spectrum does not contain discrete eigenvalue, hence this Raman spike
is not a soliton.Comment: LaTex file, includes two figures in LaTex format, 9 page
Explaining trends in alcohol-related harms in Scotland 1991â2011 (II): policy, social norms, the alcohol market, clinical changes and a synthesis
Objective:
To provide a basis for evaluating post-2007 alcohol policy in Scotland, this paper tests the extent to which pre-2007 policy, the alcohol market, culture or clinical changes might explain differences in the magnitude and trends in alcohol-related mortality outcomes in Scotland compared to England & Wales (E&W).
Study design:
Rapid literature reviews, descriptive analysis of routine data and narrative synthesis.
Methods:
We assessed the impact of pre-2007 Scottish policy and policy in the comparison areas in relation to the literature on effective alcohol policy. Rapid literature reviews were conducted to assess cultural changes and the potential role of substitution effects between alcohol and illicit drugs. The availability of alcohol was assessed by examining the trends in the number of alcohol outlets over time. The impact of clinical changes was assessed in consultation with key informants. The impact of all the identified factors were then summarised and synthesised narratively.
Results:
The companion paper showed that part of the rise and fall in alcohol-related mortality in Scotland, and part of the differing trend to E&W, were predicted by a model linking income trends and alcohol-related mortality. Lagged effects from historical deindustrialisation and socio-economic changes exposures also remain plausible from the available data.
This paper shows that policy differences or changes prior to 2007 are unlikely to have been important in explaining the trends. There is some evidence that aspects of alcohol culture in Scotland may be different (more concentrated and home drinking) but it seems unlikely that this has been an important driver of the trends or the differences with E&W other than through interaction with changing incomes and lagged socio-economic effects. Substitution effects with illicit drugs and clinical changes are unlikely to have substantially changed alcohol-related harms: however, the increase in alcohol availability across the UK is likely to partly explain the rise in alcohol-related mortality during the 1990s.
Conclusions:
Future policy should ensure that alcohol affordability and availability, as well as socio-economic inequality, are reduced, in order to maintain downward trends in alcohol-related mortality in Scotland
Stability of Neutral Fermi Balls with Multi-Flavor Fermions
A Fermi ball is a kind of non-topological soliton, which is thought to arise
from the spontaneous breaking of an approximate symmetry and to
contribute to cold dark matter. We consider a simple model in which fermion
fields with multi-flavors are coupled to a scalar field through Yukawa
coupling, and examine how the number of the fermion flavors affects the
stability of the Fermi ball against the fragmentation. (1)We find that the
Fermi ball is stable against the fragmentation in most cases even in the lowest
order thin-wall approximation. (2)We then find that in the other specific
cases, the stability is marginal in the lowest order thin-wall approximation,
and the next-to-leading order correction determines the stable region of the
coupling constants; We examine the simplest case where the total fermion number
and the Yukawa coupling constant of each flavor are common to
the flavor, and find that the Fermi ball is stable in the limited region of the
parameters and has the broader region for the larger number of the flavors.Comment: 10 pages, 3 eps figures, ReVTeX
Aluminum-26 in calcium-aluminum-rich inclusions and chondrules from unequilibrated ordinary chondrites
In order to investigate the distribution of ^(26)A1 in chondrites, we measured aluminum-magnesium systematics in four calcium-aluminum-rich inclusions (CAIs) and eleven aluminum-rich chondrules from unequilibrated ordinary chondrites (UOCs). All four CAIs were found to contain radiogenic ^(26)Mg (^(26)Mg^*) from the decay of ^(26)A1. The inferred initial ^(26)Al/^(27)Al ratios for these objects ((^(26)Al/^(27)Al)_0 â
5 Ă 10^(â5)) are indistinguishable from the (^(26)Al/^(27)Al)_0 ratios found in most CAIs from carbonaceous chondrites. These observations, together with the similarities in mineralogy and oxygen isotopic compositions of the two sets of CAIs, imply that CAIs in UOCs and carbonaceous chondrites formed by similar processes from similar (or the same) isotopic reservoirs, or perhaps in a single location in the solar system. We also found ^(26)Mg^* in two of eleven aluminum-rich chondrules. The (^(26)Al/^(27)Al)_0 ratio inferred for both of these chondrules is âŒ1 Ă 10^(â5), clearly distinct from most CAIs but consistent with the values found in chondrules from type 3.0â3.1 UOCs and for aluminum-rich chondrules from lightly metamorphosed carbonaceous chondrites (âŒ0.5 Ă 10^(â5) to âŒ2 Ă 10^(â5)). The consistency of the (^(26)Al/^(27)Al)_0 ratios for CAIs and chondrules in primitive chondrites, independent of meteorite class, implies broad-scale nebular homogeneity with respect to ^(26)Al and indicates that the differences in initial ratios can be interpreted in terms of formation time. A timeline based on ^(26)Al indicates that chondrules began to form 1 to 2 Ma after most CAIs formed, that accretion of meteorite parent bodies was essentially complete by 4 Ma after CAIs, and that metamorphism was essentially over in type 4 chondrite parent bodies by 5 to 6 Ma after CAIs formed. Type 6 chondrites apparently did not cool until more than 7 Ma after CAIs formed. This timeline is consistent with ^(26)Al as a principal heat source for melting and metamorphism
Charged Vacuum Bubble Stability
A type of scenario is considered where electrically charged vacuum bubbles,
formed from degenerate or nearly degenerate vacuua separated by a thin domain
wall, are cosmologically produced due to the breaking of a discrete symmetry,
with the bubble charge arising from fermions residing within the domain wall.
Stability issues associated with wall tension, fermion gas, and Coulombic
effects for such configurations are examined. The stability of a bubble depends
upon parameters such as the symmetry breaking scale and the fermion coupling. A
dominance of either the Fermi gas or the Coulomb contribution may be realized
under certain conditions, depending upon parameter values.Comment: 16 pages,revtex; accepted for publication in Phys.Rev.
- âŠ