Quantum Enhancement of the Zero-Area Sagnac Interferometer Topology for Gravitational Wave Detection

Only a few years ago, it was realized that the zero-area Sagnac interferometer topology is able to perform quantum nondemolition measurements of position changes of a mechanical oscillator. Here, we experimentally show that such an interferometer can also be efficiently enhanced by squeezed light. We achieved a nonclassical sensitivity improvement of up to 8.2 dB, limited by optical loss inside our interferometer. Measurements performed directly on our squeezed-light laser output revealed squeezing of 12.7 dB. We show that the sensitivity of a squeezed-light enhanced Sagnac interferometer can surpass the standard quantum limit for a broad spectrum of signal frequencies without the need for filter cavities as required for Michelson interferometers. The Sagnac topology is therefore a powerful option for future gravitational-wave detectors, such as the Einstein Telescope, whose design is currently being studied.Comment: 4 pages, 4 figure

Achieving ground state and enhancing entanglement by recovering information

For cavity-assisted optomechanical cooling experiments, it has been shown in the literature that the cavity bandwidth needs to be smaller than the mechanical frequency in order to achieve the quantum ground state of the mechanical oscillator, which is the so-called resolved-sideband or good-cavity limit. We provide a new but physically equivalent insight into the origin of such a limit: that is information loss due to a finite cavity bandwidth. With an optimal feedback control to recover those information, we can surpass the resolved-sideband limit and achieve the quantum ground state. Interestingly, recovering those information can also significantly enhance the optomechanical entanglement. Especially when the environmental temperature is high, the entanglement will either exist or vanish critically depending on whether information is recovered or not, which is a vivid example of a quantum eraser.Comment: 9 figures, 18 page

Entanglement of macroscopic test masses and the Standard Quantum Limit in laser interferometry

We show that the generation of entanglement of two heavily macroscopic mirrors with masses of up to several kilograms are feasible with state of the art techniques of high-precision laser interferometry. The basis of such a demonstration would be a Michelson interferometer with suspended mirrors and simultaneous homodyne detections at both interferometer output ports. We present the connection between the generation of entanglement and the Standard Quantum Limit (SQL) for a free mass. The SQL is a well-known reference limit in operating interferometers for gravitational-wave detection and provides a measure of when macroscopic entanglement can be observed in the presence of realistic decoherence processes

Negative optical inertia for enhancing the sensitivity of future gravitational-wave detectors

We consider enhancing the sensitivity of future gravitational-wave detectors by using double optical spring. When the power, detuning and bandwidth of the two carriers are chosen appropriately, the effect of the double optical spring can be described as a "negative inertia", which cancels the positive inertia of the test masses and thus increases their response to gravitational waves. This allows us to surpass the free-mass Standard Quantum Limit (SQL) over a broad frequency band, through signal amplification, rather than noise cancelation, which has been the case for all broadband SQL-beating schemes so far considered for gravitational-wave detectors. The merit of such signal amplification schemes lies in the fact that they are less susceptible to optical losses than noise cancelation schemes. We show that it is feasible to demonstrate such an effect with the {\it Gingin High Optical Power Test Facility}, and it can eventually be implemented in future advanced GW detectors.Comment: 7 pages, 3 figure

Differences in the bovine milk whey proteome between early pregnancy and the estrous cycle

peer-reviewedCurrent bovine pregnancy detection methods are not reliable until at least day 28 post artificial insemination (AI). The bovine estrous cycle is approximately 21 days; consequently, producers miss an opportunity to rebreed at the next estrous event. Therefore, commercial interest exists for the discovery of novel biomarkers of pregnancy which could reliably detect pregnancy status at or before day 21 of pregnancy. The objective of the present study was to use liquid chromatography tandem mass spectrometry (LC-MS/MS) to perform a global, label-free, proteomics study on (i) milk whey and (ii) extracellular vesicle (EV) enriched milk whey samples, from day 21 of pregnancy, compared with day 21 of the estrous cycle, in order to identify potential protein biomarkers of early pregnancy. The estrous cycles of 10 dairy cows were synchronized, they went through one (control) estrous cycle and these cows were artificially inseminated during the following estrus. These cows were confirmed pregnant by ultrasound scanning. Milk whey samples were collected on day 21 of the estrous cycle and on day 21 post AI. Milk whey samples and EV enriched milk whey samples were analyzed by LC-MS/MS and subsequent analyzes of the label-free quantitative data was performed in MaxQuant and Perseus. Four proteins (APOB, SPADH1, PLIN2 and LPO) were differentially expressed between the proteomes of milk whey from day 21 of pregnancy and day 21 of the estrous cycle (P < 0.05). Ten proteins (PIGR, PGD, QSOX1, MUC1, SRPRA, MD2, GAPDH, FOLR1, GPRC5B and HHIPL2) were differentially expressed between the proteomes of EV enriched milk whey from day 21 of pregnancy and day 21 of the estrous cycle (P < 0.05). These proteins are potential milk whey biomarkers of early pregnancy

Enhancing non-classicality in mechanical systems

We study the effects of post-selection measurements on both the non-classicality of the state of a mechanical oscillator and the entanglement between two mechanical systems that are part of a distributed optomechanical network. We address the cases of both Gaussian and non-Gaussian measurements, identifying in which cases simple photon counting and Geiger-like measurements are effective in distilling a strongly non-classical mechanical state and enhancing the purely mechanical entanglement between two elements of the network

Quantum Measurement Theory in Gravitational-Wave Detectors

The fast progress in improving the sensitivity of the gravitational-wave (GW) detectors, we all have witnessed in the recent years, has propelled the scientific community to the point, when quantum behaviour of such immense measurement devices as kilometer-long interferometers starts to matter. The time, when their sensitivity will be mainly limited by the quantum noise of light is round the corner, and finding the ways to reduce it will become a necessity. Therefore, the primary goal we pursued in this review was to familiarize a broad spectrum of readers with the theory of quantum measurements in the very form it finds application in the area of gravitational-wave detection. We focus on how quantum noise arises in gravitational-wave interferometers and what limitations it imposes on the achievable sensitivity. We start from the very basic concepts and gradually advance to the general linear quantum measurement theory and its application to the calculation of quantum noise in the contemporary and planned interferometric detectors of gravitational radiation of the first and second generation. Special attention is paid to the concept of Standard Quantum Limit and the methods of its surmounting.Comment: 147 pages, 46 figures, 1 table. Published in Living Reviews in Relativit

Sensitivity Studies for Third-Generation Gravitational Wave Observatories

Advanced gravitational wave detectors, currently under construction, are expected to directly observe gravitational wave signals of astrophysical origin. The Einstein Telescope, a third-generation gravitational wave detector, has been proposed in order to fully open up the emerging field of gravitational wave astronomy. In this article we describe sensitivity models for the Einstein Telescope and investigate potential limits imposed by fundamental noise sources. A special focus is set on evaluating the frequency band below 10Hz where a complex mixture of seismic, gravity gradient, suspension thermal and radiation pressure noise dominates. We develop the most accurate sensitivity model, referred to as ET-D, for a third-generation detector so far, including the most relevant fundamental noise contributions.Comment: 13 pages, 7 picture

Scientific Potential of Einstein Telescope

Einstein gravitational-wave Telescope (ET) is a design study funded by the European Commission to explore the technological challenges of and scientific benefits from building a third generation gravitational wave detector. The three-year study, which concluded earlier this year, has formulated the conceptual design of an observatory that can support the implementation of new technology for the next two to three decades. The goal of this talk is to introduce the audience to the overall aims and objectives of the project and to enumerate ET's potential to influence our understanding of fundamental physics, astrophysics and cosmology.Comment: Conforms to conference proceedings, several author names correcte

Scientific Objectives of Einstein Telescope

The advanced interferometer network will herald a new era in observational astronomy. There is a very strong science case to go beyond the advanced detector network and build detectors that operate in a frequency range from 1 Hz-10 kHz, with sensitivity a factor ten better in amplitude. Such detectors will be able to probe a range of topics in nuclear physics, astronomy, cosmology and fundamental physics, providing insights into many unsolved problems in these areas.Comment: 18 pages, 4 figures, Plenary talk given at Amaldi Meeting, July 201