563 research outputs found

    Shock Wave Measurements in Cloud Cavitation

    Get PDF
    One of the most destructive (and noisy) forms of cavitation is that referred to as "cloud cavitation" because it involves a large collection of bubbles which behave as a coherent whole. The present paper presents the results of an experimental study of the processes of collapse of a cavitation bubble cloud, specifically that generated by an oscillating hydrofoil in a water tunnel. Measurements of the far-field noise show that this is comprised of substantial pulses radiated from the cloud at the moment of collapse. Also, transducers within the cavitation zone encounter very large pressure pulses (or shock waves) with amplitudes of the order of tens of atmospheres and typical durations of the order of tenths of a millisecond. These shock waves appear to be responsible for the enhanced noise and damage potential which results from that phenomenon

    Pressure Pulses Generated by Cloud Cavitation

    Get PDF
    This paper describes an experimental investigation of the large unsteady and impulsive pressures which are experienced on the suction surface of both an oscillating and static hydrofoil as a result of cloud cavitation. The present experiments used piezo-electric transducers to measure unsteady pressures at four locations along the chord of the foil and at two locations along the walls of the tunnel test section. These transducers measured very large positive pressure pulses with amplitudes of the order of tens of atmospheres and with durations of the order of tenths of milliseconds. Two distinct types of pressure pulse were identified. "Local" pulses occurred at a single transducer location and were randomly distributed in position and time; several local impulses could be recorded by each transducer during an oscillation cycle. On the other hand, "global" impulses were registered by all the transducers almost simultaneously. Correlation of the transducer output with high speed movies of the cavitation revealed that they were produced by a large scale collapse of the bubble cloud. The location of the global impulses relative to the foil oscillation was quite repeatable and produced substantial far-field noise. The high speed movies also showed that the local impulses were caused both by crescent-shaped regions of low void fraction and by small bubbly structures. These regions appeared to be bounded by bubbly shock waves which were associated with the large pressure pulses. The paper also quantifies the effect of reduced frequency, cavitation number and tunnel velocity on the strength of the pressure pulses by presenting the acoustic impulse for a range of flow conditions. The reduced frequency is an important parameter in the determination of the total impulse level and the local and global pulse distribution. Large impulses are present on the foil surface even at cavitation numbers which do not result in large levels of acoustic radiation or global impulse. The total impulse increases with increasing tunnel velocity

    Observations of Shock Waves in Cloud Cavitation

    Get PDF
    This paper describes an investigation of the dynamics and acoustics of cloud cavitation, the structures which are often formed by the periodic breakup and collapse of a sheet or vortex cavity. This form of cavitation frequently causes severe noise and damage, though the precise mechanism responsible for the enhancement of these adverse effects is not fully understood. In this paper, we investigate the large impulsive surface pressures generated by this type of cavitation and correlate these with the images from high-speed motion pictures. This reveals that several types of propagating structures (shock waves) are formed in a collapsing cloud and dictate the dynamics and acoustics of collapse. One type of shock wave structure is associated with the coherent collapse of a well-defined and separate cloud when it is convected into a region of higher pressure. This type of global structure causes the largest impulsive pressures and radiated noise. But two other types of structure, termed 'crescent-shaped regions' and 'leading-edge structures' occur during the less-coherent collapse of clouds. These local events are smaller and therefore produce less radiated noise but the interior pressure pulse magnitudes are almost as large as those produced by the global events. The ubiquity and severity of these propagating shock wave structures provides a new perspective on the mechanisms reponsible for noise and damage in cavitating flows involving clouds of bubbles. It would appear that shock wave dynamics rather than the collapse dynamics of single bubbles determine the damage and noise in many cavitating flows

    Cloud cavitation on an oscillating hydrofoil

    Get PDF
    Cloud cavitation, often formed by the breakdown of a sheet or vortex cavity, is believed to be responsible for much of the noise and erosion damage that occurs under cavitating conditions. For this paper, cloud cavitation was produced through the periodic forcing of the flow by an oscillating hydrofoil. The present work examines the acoustic signal generated by the collapse of cloud cavitation, and compares the results to those obtained by studies of single travelling bubble cavitation. In addition, preliminary studies involving the use of air injection on the suction surface of the hydrofoil explore its mitigating effects on the cavitation noise

    Entanglement of localized states

    Full text link
    We derive exact expressions for the mean value of Meyer-Wallach entanglement Q for localized random vectors drawn from various ensembles corresponding to different physical situations. For vectors localized on a randomly chosen subset of the basis, tends for large system sizes to a constant which depends on the participation ratio, whereas for vectors localized on adjacent basis states it goes to zero as a constant over the number of qubits. Applications to many-body systems and Anderson localization are discussed.Comment: 6 pages, 4 figure

    Global Entanglement for Multipartite Quantum States

    Full text link
    Based on the residual entanglement [9] (Phys. Rev. A \textbf{71}, 044301 (2005)), we present the global entanglement for a multipartite quantum state. The measure is shown to be also obtained by the bipartite partitions of the multipartite state. The distinct characteristic of the global entanglement is that it consists of the sum of different entanglement contributions. The measure can provide sufficient and necessary condition of fully separability for pure states and be conveniently extended to mixed states by minimizing the convex hull. To test the sufficiency of the measure for mixed states, we evaluate the global entanglement of bound entangled states. The properties of the measure discussed finally show the global entanglement is an entanglement monotone.Comment: 6 page
    corecore