390 research outputs found
Global optical potential for nucleus-nucleus systems from 50 MeV/u to 400 MeV/u
We present a new global optical potential (GOP) for nucleus-nucleus systems,
including neutron-rich and proton-rich isotopes, in the energy range of MeV/u. The GOP is derived from the microscopic folding model with the
complex -matrix interaction CEG07 and the global density presented by S{\~
a}o Paulo group. The folding model well accounts for realistic complex optical
potentials of nucleus-nucleus systems and reproduces the existing elastic
scattering data for stable heavy-ion projectiles at incident energies above 50
MeV/u. We then calculate the folding-model potentials (FMPs) for projectiles of
even-even isotopes, C, O, Ne, Mg,
Si, S, Ar, and Ca, scattered by stable
target nuclei of C, O, Si, Ca Ni, Zr,
Sn, and Pb at the incident energy of 50, 60, 70, 80, 100, 120,
140, 160, 180, 200, 250, 300, 350, and 400 MeV/u. The calculated FMP is
represented, with a sufficient accuracy, by a linear combination of 10-range
Gaussian functions. The expansion coefficients depend on the incident energy,
the projectile and target mass numbers and the projectile atomic number, while
the range parameters are taken to depend only on the projectile and target mass
numbers. The adequate mass region of the present GOP by the global density is
inspected in comparison with FMP by realistic density. The full set of the
range parameters and the coefficients for all the projectile-target
combinations at each incident energy are provided on a permanent open-access
website together with a Fortran program for calculating the microscopic-basis
GOP (MGOP) for a desired projectile nucleus by the spline interpolation over
the incident energy and the target mass number.Comment: 25 pages, 13 figure
Hydrodynamic and Mass Transfer Properties in a Three Phase External Loop Airlift Compared with a Three Phase Internal Loop Airlift and a Slurry Bubble Column
The effects of suspended solid particles on the hydrodynamic and mass transfer properties were experimentally studied in a wide range of the superficial gas velocity, solid particle property and liquid viscosity in an external loop airlift bubble column in comparison with those in an internal loop airlift bubble column as well as a normal bubble column. The circulating liquid velocities UL, gas holdups G and volumetric gas liquid oxygen transfer coefficients kLa in the riser of the external loop airlift were found to be almost unaffected by the completely suspended solid particles. The above three properties obtained could be represented by our previous correlations for the gas-liquid two phase flow within an accuracy of ± 30% for a practical reactor design and operation. The analogous results were obtained on the G and kLa data in the three phase normal and internal loop airlift bubble columns, although a small amount of suspended solid particles was observed to cause a slight decrease in these values in contrast to a lower or negligible decrease in those of the three phase external loop airlift
Gas-Liquid Interfacial Area, Bubble Size and Liquid-Phase Mass Transfer Coefficient in a Three-Phase External Loop Airlift Bubble Column
The interfacial area a was measured by the sulfite oxidation method in a three-phase external loop airlift bubble column suspending completely the different concentrations of ion exchange resin particles in aqueous carboxymethyl cellulose (CMC) solutions with a wide range of viscosity. The column had been previously studied for the circulating liquid velocity UL, gas holdup G and volumetric gas-liquid oxygen transfer coefficient kLa in the two- and three-phase systems. The average bubble size dB and oxygen transfer coefficient kL were obtained as dB = 6 G/a and kL = (the previous kLa)/a, respectively. The similar studies were carried out in the internal loop airlift and normal bubble columns for comparison. The a values in the external loop airlift were found to be little affected by the column height and particles concentrations, and to decrease with increasing viscosity. All the three columns showed a linear dependence of a on G. A simple correlation of a, dB or kL was proposed as a function of G and viscosity for the external loop airlift as well as both internal loop airlift and normal columns. A well-known relationship between kL and dB was confirmed to hold independent of column types and operating conditions for a given two or three phase system
In-beam γ-ray spectroscopy of 136Te at relativistic energies
The reduced transition probability B(E2; 0+ 1 →2+ 1 ) to the first excited 2+ state of the neutron-rich nucleus 136Te, with two protons and two neutrons outside the doubly magic 132Sn core, was measured via Coulomb excitation at relativistic energies at the RIKEN Radioactive Isotope Beam Factory. A value of B(E2)= 0.191(26) e2b2 was extracted from the measured inelastic scattering cross section on an Au target taking into account the contributions from both Coulomb and nuclear excitations. In addition, an upper limit for the transition strength to a 2+ state of mixed-symmetry character in the excitation energy range of 1.5–2.2 MeV was determined and compared to the predictions of various theoretical calculations. Because of the high statistics gathered in the present experiment the error of the deduced B(E2) value is dominated by the systematic uncertainties involved in the analysis of Coulomb excitation experiments at beam energies around 150 MeV/u. Therefore, the latter are for the first time assessed in detail in the present work.Spanish Ministerio de Economía y Competitividad (FPA2014-57196-C5-4-P, FPA2017-84756-C4-2-P, FIS2014-53448-C2-1-P
Quantification of Amyloid β Deposition in Alzheimer\u27s Disease Patients Using PET and [11C]BF-227
- …