Frame dragging with optical vortices

General Relativistic calculations in the linear regime have been made for electromagnetic beams of radiation known as optical vortices. These exotic beams of light carry a physical quantity known as optical orbital angular momentum (OAM). It is found that when a massive spinning neutral particle is placed along the optical axis, a phenomenon known as inertial frame dragging occurs. Our results are compared with those found previously for a ring laser and an order of magnitude estimate of the laser intensity needed for a precession frequency of 1 Hz is given for these "steady" beams of light.Comment: 13 pages, 2 figure

Determination of the characteristic directions of lossless linear optical elements

We show that the problem of finding the primary and secondary characteristic directions of a linear lossless optical element can be reformulated in terms of an eigenvalue problem related to the unimodular factor of the transfer matrix of the optical device. This formulation makes any actual computation of the characteristic directions amenable to pre-implemented numerical routines, thereby facilitating the decomposition of the transfer matrix into equivalent linear retarders and rotators according to the related Poincare equivalence theorem. The method is expected to be useful whenever the inverse problem of reconstruction of the internal state of a transparent medium from optical data obtained by tomographical methods is an issue.Comment: Replaced with extended version as published in JM

SOSORT consensus paper: school screening for scoliosis. Where are we today?

This report is the SOSORT Consensus Paper on School Screening for Scoliosis discussed at the 4th International Conference on Conservative Management of Spinal Deformities, presented by SOSORT, on May 2007. The objectives were numerous, 1) the inclusion of the existing information on the issue, 2) the analysis and discussion of the responses by the meeting attendees to the twenty six questions of the questionnaire, 3) the impact of screening on frequency of surgical treatment and of its discontinuation, 4) the reasons why these programs must be continued, 5) the evolving aim of School Screening for Scoliosis and 6) recommendations for improvement of the procedure

High Pressure Hugoniot Measurements Using Converging Shocks

Plate impact experiments are a powerful tool in equation of state development, but are inherently limited by the range of impact velocities accessible to the gun. In an effort to dramatically increase the range of pressures which can be studied with available impact velocities, a new experimental technique is being developed. The possibility of using converging shock waves to produce a high pressure Mach reflection is examined. The technique proposed uses a composite target simply consisting of two concentric cylinders, with the only requirement being the initial shock speed in the outer cylinder is greater than that in the inner cylinder. Conically converging shocks will be generated at the interface due to the impedance mismatch and axisymmetric geometry of the composite target. Upon convergence, an irregular reflection must occur, at which point the conical analog of a Mach reflection develops. Once the Mach reflection reaches a steady state, the high pressure state in the Mach disk can be measured using velocity interferometry and impedance matching techniques. Experimental results on a copper inner cylinder are in good agreement with numerical simulations and data in the literature