Ray optical light trapping in silicon microwires: exceeding the 2n^2 intensity limit

We develop a ray optics model of a silicon wire array geometry in an attempt to understand the very strong absorption previously observed experimentally in these arrays. Our model successfully reproduces the n^2 ergodic limit for wire arrays in free space. Applying this model to a wire array on a Lambertian back reflector, we find an asymptotic increase in light trapping for low filling fractions. In this case, the Lambertian back reflector is acting as a wide acceptance angle concentrator, allowing the array to exceed the ergodic limit in the ray optics regime. While this leads to increased power per volume of silicon, it gives reduced power per unit area of wire array, owing to reduced silicon volume at low filling fractions. Upon comparison with silicon microwire experimental data, our ray optics model gives reasonable agreement with large wire arrays (4 μm radius), but poor agreement with small wire arrays (1 μm radius). This suggests that the very strong absorption observed in small wire arrays, which is not observed in large wire arrays, may be significantly due to wave optical effects

Photoelectrochemical water splitting: silicon photocathodes for hydrogen evolution

The development of low cost, scalable, renewable energy technologies is one of today's most pressing scientific challenges. We report on progress towards the development of a photoelectrochemical water-splitting system that will use sunlight and water as the inputs to produce renewable hydrogen with oxygen as a by-product. This system is based on the design principle of incorporating two separate, photosensitive inorganic semiconductor/liquid junctions to collectively generate the 1.7-1.9 V at open circuit needed to support both the oxidation of H_2O (or OH^-) and the reduction of H^+ (or H_2O). Si microwire arrays are a promising photocathode material because the high aspect-ratio electrode architecture allows for the use of low cost, earth-abundant materials without sacrificing energy-conversion efficiency, due to the orthogonalization of light absorption and charge-carrier collection. Additionally, the high surfacearea design of the rod-based semiconductor array inherently lowers the flux of charge carriers over the rod array surface relative to the projected geometric surface of the photoelectrode, thus lowering the photocurrent density at the solid/liquid junction and thereby relaxing the demands on the activity (and cost) of any electrocatalysts. Arrays of Si microwires grown using the Vapor Liquid Solid (VLS) mechanism have been shown to have desirable electronic light absorption properties. We have demonstrated that these arrays can be coated with earth-abundant metallic catalysts and used for photoelectrochemical production of hydrogen. This development is a step towards the demonstration of a complete artificial photosynthetic system, composed of only inexpensive, earth-abundant materials, that is simultaneously efficient, durable, and scalable

pH-Independent, 520 mV Open-Circuit Voltages of Si/Methyl Viologen^(2+/+) Contacts Through Use of Radial n^+p-Si Junction Microwire Array Photoelectrodes

The effects of introducing an n^+-doped emitter layer have been evaluated for both planar Si photoelectrodes and for radial junction Si microwire-array photoelectrodes. In contact with the pH-independent, one-electron, outer-sphere, methyl viologen redox system (denoted MV^(2+/+)), both planar and wire array p-Si photoelectrodes yielded open-circuit voltages, V_(oc), that varied with the pH of the solution. The highest V_(oc) values were obtained at pH = 2.9, with V_(oc) = 0.53 V for planar p-Si electrodes and V_(oc) = 0.42 V for vapor−liquid−solid catalyzed p-Si microwire array samples, under 60 mW cm^(−2) of 808 nm illumination. Increases in the pH of the electrolyte produced a decrease in V_(oc) by approximately −44 mV/pH unit for planar electrodes, with similar trends observed for the Si microwire array electrodes. In contrast, introduction of a highly doped, n^+ emitter layer produced V_(oc) = 0.56 V for planar Si electrodes and V_(oc) = 0.52 V for Si microwire array electrodes, with the photoelectrode properties in each system being essentially independent of pH over six pH units (3 < pH < 9). Hence, formation of an n^+ emitter layer not only produced nearly identical photovoltages for planar and Si microwire array photoelectrodes, but decoupled the band energetics of the semiconductor (and hence the obtainable photovoltage) from the value of the redox potential of the solution. The formation of radial junctions on Si microwire arrays thus provides an approach to obtaining Si-based photoelectrodes with high-photovoltages that can be used for a variety of photoelectrochemical processes, including potentially the hydrogen evolution reaction, under various pH conditions, regardless of the intrinsic barrier height and flat-band properties of the Si/liquid contact

Comparing external ventricular drains-related ventriculitis surveillance definitions

OBJECTIVETo evaluate the agreement between the current National Healthcare Safety Network (NHSN) definition for ventriculitis and others found in the literature among patients with an external ventricular drain (EVD)DESIGNRetrospective cohort study from January 2009 to December 2014SETTINGNeurology and neurosurgery intensive care unit of a large tertiary-care centerPATIENTSPatients with an EVD were included. Patients with an infection prior to EVD placement or a permanent ventricular shunt were excluded.METHODSWe reviewed the charts of patients with positive cerebrospinal fluid (CSF) cultures and/or abnormal CSF results while they had an EVD in place and applied various ventriculitis definitions.RESULTSWe identified 48 patients with a total of 52 cases of ventriculitis (41 CSF culture-positive cases and 11 cases based on abnormal CSF test results) using the NHSN definition. The most common organisms causing ventriculitis were gram-positive commensals (79.2%); however, 45% showed growth of only 1 colony on 1 piece of media. Approximately 60% of the ventriculitis cases by the NHSN definition met the Honda criteria, approximately 56% met the Gozal criteria, and 23% met Citerio’s definition. Cases defined using Honda versus Gozal definitions had a moderate agreement (κ=0.528; P&lt;.05) whereas comparisons of Honda versus Citerio definitions (κ=0.338; P&lt;.05) and Citerio versus Gozal definitions (κ=0.384; P&lt;.05) had only fair agreements.CONCLUSIONSThe agreement between published ventriculostomy-associated infection (VAI) definitions in this cohort was moderate to fair. A VAI surveillance definition that better defines contaminants is needed for more homogenous application of surveillance definitions between institutions and better comparison of rates.Infect Control Hosp Epidemiol 2017;38:574–579</jats:sec

Solar Water Splitting Cells

No abstract

Evaluation of Pt, Ni, and Ni–Mo electrocatalysts for hydrogen evolution on crystalline Si electrodes

The dark electrocatalytic and light photocathodic hydrogen evolution properties of Ni, Ni–Mo alloys, and Pt on Si electrodes have been measured, to assess the viability of earth-abundant electrocatalysts for integrated, semiconductor coupled fuel formation. In the dark, the activities of these catalysts deposited on degenerately doped p^+-Si electrodes increased in the order Ni < Ni–Mo ≤ Pt. Ni–Mo deposited on degenerately doped Si microwires exhibited activity that was very similar to that of Pt deposited by metal evaporation on planar Si electrodes. Under 100 mW cm^(−2) of Air Mass 1.5 solar simulation, the energy conversion efficiencies of p-type Si/catalyst photoelectrodes ranged from 0.2–1%, and increased in the order Ni ≈ Ni–Mo < Pt, due to somewhat lower photovoltages and photocurrents for p-Si/Ni–Mo relative to p-Si/Ni and p-Si/Pt photoelectrodes. Deposition of the catalysts onto microwire arrays resulted in higher apparent catalytic activities and similar photoelectrode efficiencies than were observed on planar p-Si photocathodes, despite lower light absorption by p-Si in the microwire structures

Report on First Activations with the Lead Slowing Down Spectrometer

On Feb. 17 and 18 2011, six items were irradiated with neutrons using the Lead Slowing Down Spectrometer. After irradiation, dose measurements and gamma-spectrometry measurements were completed on all of the samples. No contamination was found on the samples, and all but one provided no dose. Gamma-spectroscopy measurements qualitatively agreed with expectations based on the materials, with the exception of silver. We observed activation in the room in general, mostly due to 56Mn and 24Na. Most of the activation was short lived, with half-lives on the scale of hours, except for 198Au which has a half-life of 2.7 d

Report on Second Activations with the Lead Slowing Down Spectrometer

Summary On August 18 and 19 2011, five items were irradiated with neutrons using the Lead Slowing Down Spectrometer (LSDS). After irradiation, dose measurements and gamma-spectrometry measurements were completed on all of the samples. No contamination was found on the samples, and all but one provided no dose. Gamma-spectroscopy measurements qualitatively agreed with expectations based on the materials. As during the first activation run, we observed activation in the room in general, mostly due to 56Mn and 24Na. Most of the activation of the samples was short lived, with half-lives on the scale of hours to days, except for 60Co which has a half-life of 5.3 y

Hydrogen-evolution characteristics of Ni–Mo-coated, radial junction, n+p-silicon microwire array photocathodes

The photocathodic H_2-evolution performance of Ni–Mo-coated radial n+p junction Si microwire (Si MW) arrays has been evaluated on the basis of thermodynamic energy-conversion efficiency as well as solar cell figures of merit. The Ni–Mo-coated n^(+)p-Si MW electrodes yielded open-circuit photovoltages (V_oc) of 0.46 V, short-circuit photocurrent densities (J_sc) of 9.1 mA cm^(−2), and thermodynamically based energy-conversion efficiencies (η) of 1.9% under simulated 1 Sun illumination. Under nominally the same conditions, the efficiency of the Ni–Mo-coated system was comparable to that of Pt-coated n+p-Si MW array photocathodes (V_oc = 0.44 V, J_sc = 13.2 mA cm^(−2_, η = 2.7%). This demonstrates that, at 1 Sun light intensity on high surface area microwire arrays, earth-abundant electrocatalysts can provide performance comparable to noble-metal catalysts for photoelectrochemical hydrogen evolution. The formation of an emitter layer on the microwires yielded significant improvements in the open-circuit voltage of the microwire-array-based photocathodes relative to Si MW arrays that did not have a buried n^(+)p junction. Analysis of the spectral response and light-intensity dependence of these devices allowed for optimization of the catalyst loading and photocurrent density. The microwire arrays were also removed from the substrate to create flexible, hydrogen-evolving membranes that have potential for use in a solar water-splitting device