Modified Taylor Impact Tests with Profiled Copper Cylinders: Experiment and Optimization of Dislocation Plasticity Model

Current progress in numerical simulations and machine learning allows one to apply complex loading conditions for the identification of parameters in plasticity models. This possibility expands the spectrum of examined deformed states and makes the identified model more consistent with engineering practice. A combined experimental-numerical approach to identify the model parameters and study the dynamic plasticity of metals is developed and applied to the case of cold-rolled OFHC copper. In the experimental part, profiled projectiles (reduced cylinders or cones in the head part) are proposed for the Taylor impact problem for the first time for material characterization. These projectiles allow us to reach large plastic deformations with true strains up to 1.3 at strain rates up to 105 s−1 at impact velocities below 130 m/s. The experimental results are used for the optimization of parameters of the dislocation plasticity model implemented in 3D with the numerical scheme of smoothed particle hydrodynamics (SPH). A Bayesian statistical method in combination with a trained artificial neural network as an SPH emulator is applied to optimize the parameters of the dislocation plasticity model. It is shown that classical Taylor cylinders are not enough for a univocal selection of the model parameters, while the profiled cylinders provide better optimization even if used separately. The combination of different shapes and an increase in the number of experiments increase the quality of optimization. The optimized numerical model is successfully validated by the experimental data about the shock wave profiles in flyer plate experiments from the literature. In total, a cheap, simple, but efficient route for optimizing a dynamic plasticity model is proposed. The dislocation plasticity model is extended to estimate grain refinement and volume fractions of weakened areas in comparison with experimental observations

Visualization of magnetostructural transition in Heusler alloys by Magnetic Force Microscopy

Magnetostructural transition was observed in Ni-Mn-In-Cr Heusler alloy with help of Magnetic Force Microscopy (MFM). The crystal structure of a sample and characteristic temperatures of the phase transition were controlled by roentgenostructural phase analysis and magnetometry, respectively. It appeared prominently important to prepare the surface of the sample until the nanometer level of surface roughness. Magnetic study performed with scanning probe microscope revealed existence of magnetic domains, which were spread across the surface evenly. Further studies revealed that intensity of magnetic signal decreases as fading out of the contrast of the MFM images. It was found that location of domains shifted after the heating/cooling cycle above Curie temperature for the studied alloy. Location of new domain walls appeared correlating with surface scrapings and defects, whilst it became independent from those after heating until just 70°C. The mechanism behind the observed transition is proposed

Visualization of magnetostructural transition in Heusler alloys by Magnetic Force Microscopy

Magnetostructural transition was observed in Ni-Mn-In-Cr Heusler alloy with help of Magnetic Force Microscopy (MFM). The crystal structure of a sample and characteristic temperatures of the phase transition were controlled by roentgenostructural phase analysis and magnetometry, respectively. It appeared prominently important to prepare the surface of the sample until the nanometer level of surface roughness. Magnetic study performed with scanning probe microscope revealed existence of magnetic domains, which were spread across the surface evenly. Further studies revealed that intensity of magnetic signal decreases as fading out of the contrast of the MFM images. It was found that location of domains shifted after the heating/cooling cycle above Curie temperature for the studied alloy. Location of new domain walls appeared correlating with surface scrapings and defects, whilst it became independent from those after heating until just 70°C. The mechanism behind the observed transition is proposed