2,090 research outputs found
Adrenalin significantly increases intracranial pressure in hypovolemic cardiac arrest model in male piglets
The effects of pre-slaughter selection of reindeer bulls (Rangifer tarandus tarandus L.) on technological and sensory meat quality, blood metabolites and abomasal lesions
Thirty reindeer bulls (age 1 1/2 years) were subjected to different pre-slaughter treatments to study the effects on ultimate pH values, muscle glycogen content, blood metabolites and abomasal lesions. Gathering and herding into a grazing corral were followed by various selection procedures. Before starting these, a control group of 10 reindeer were captured by lasso and slaughtered outside the grazing corral. Ten reindeer were then selected by hand from a small group of animals (100-150 head) in a small selection corral. Another 10 reindeer were selected from a large herd of about 1000-2000 animals, by the traditional technique of using a lasso. During a 6-hour selection, animals were captured and slaughtered after 1.5 hours (n = 2), 3-5 hours (n = 2), 5 hours (n = 3) and 6 hours (n=3) respectively. The results showed the technique of using a lasso to be stressful and glycogen-depleting, as the two lasso captured groups (the control group and the reindeer exposed to the protracted lasso selection) had the highest ultimate pH values and lowest muscle glycogen values measured. By contrast, the selection procedure where reindeer were captured by hand, was not found to be detrimental to glycogen content and ultimate pH values. Nevertheless, both selection techniques expose the reindeer to acute stress during the capture and manual restraint, which in the present study was reflected in high plasma Cortisol values in all treatment groups. The frequency of abomasal lesions was highest in the group of reindeer subjected to the prolonged selection procedure. No connection between technological and sensory meat quality was found in this study. The technique of selecting animals by hand ought to be further developed so that existing practical problems can be solved. The technique could then be recommended for wider use
Remote blood collection in reindeer (Rangifer tarandus tarandus L): a preliminary study
Automatic blood sampling equipment (ABSE) was used successfully to collect blood samples from two reindeer. During blood sampling, two methods of restraint were applied which caused no short term changes in plasma concentrations of urea, aspartate aminotransferase, alanine aminotransferase or total protein. Plasma Cortisol concentrations were significantly elevated by the two restraint techniques. The value of ABSE in studies of stress in reindeer is discussed
Pre-slaughter handling of reindeer bulls {Rangifer tarandus tarandus L.) — effects on technological and sensory meat quality, blood metabolites and muscular and abomasal lesions
Forty-one reindeer bulls (age 1 1/2 years) were subjected to different pre-slaughter treatments: herding for a short distance to a grazing corral, selection by use of a lasso, lorry transport and helicopter herding for 1, 2 and 3 days respectively. As control, 9 reindeer were shot without previous handling (in the mountains). The results indicated the traditional selection technique of using a lasso to be the most stressful and glycogen-depleting handling procedure so far studied. In the lasso-selected reindeer the lowest glycogen values and the highest ultimate pH values in the meat were measured. The values of the measured parameters indicating stress (aspartate aminotransferase (ASAT), urea, Cortisol and abomasal lesions) were also highest in these reindeer. By contrast, the modern method of herding by helicopter was not found to be detrimental to glycogen content, ultimate pH, the measured blood metabolites, or the frequency of abomasal lesions. In all treatment groups degenerative lesions were observed in the skeletal muscles. No relarionship between technological and sensory meat quality characteristics and skeletal muscle lesions in reindeer could, however, be found in this study. The study confirmed an earlier finding that a 'stress-flavour' could develop in reindeer meat after intensive pre-slaughter handling of the animals. Further study of when and how such "stress-flavour" develops ought to be undertaken
Ultimate pH values in reindeer meat with particular regard to animal sex and age, muscle and transport distance
The distribution of ultimate pH values and the frequency of high pH values in three reindeer muscles (AL longissimus, M. biceps femoris and M. triceps brachii) from bulls, cows and calves after short and long distance transport were studied. About 3400 reindeer carcasses from 12 different herds were included in this study. The post mortem processes in reindeer meat seemed to develop very rapidly, and therefore an early measurement (approx. 15h post mortem) of ultimate pH can be done without electrical stimulation of the carcasses. In a comparison between muscles, M. triceps brachii had a higher ultimate pH value than M. longissimus and M. biceps femoris. Meat from reindeer calves had higher ultimate pH values than meat from adult animals, indicating that calves are more susceptible to stress than adult animals and hence deplete their energy stores more readily. Road transport by lorry did not cause any increase in ultimate pH values in bulls and calves. Reindeer cows, however, did have an increase in ultimate pH, while more borderline cases of DFD (5.80<pH<6.20) were observed when cows were transported over more than 500 km. The physical condition and energy balance of the animals before transport were suggested to determine their ability to tolerate transport stress
Robotic intracorporeal urinary diversion: practical review of current surgical techniques
In this practical review, we discuss current surgical techniques reported in the literature to perform Intracorporeal Urinary Diversion (ICUD) after Robotic Radical Cystectomy (RARC), emphasizing criticisms of single approaches and making comparisons with Extracorporeal Urinary Diversion (ECUD). Although almost 97% of all RARCs use an ECUD, ICUD is gaining in popularity, in view of its potential benefits (i.e., decreased bowel exposure, etc.), although there are a few studies comparing ICUD and ECUD. Analysing single experiences and the data from recent metanalyses, we emphasize the current critiques to ICUD, stressing particular technical details which could reduce operative time, lowering the postoperative complications rate, and improving functional outcomes. Only analysis of long-term follow-up data from large-scale homogeneous series can ascertain whether robotic intracorporeal urinary diversion is superior to other approaches
Antifouling paints leach copper in excess – study of metal release rates and efficacy along a salinity gradient
Antifouling paints are biocidal products applied to ship and boat hulls in order to prevent the growth and settlement of marine organisms, i.e. fouling. The release of biocides from the surface of the paint film act to repel or poison potential settling organisms. Currently, the most commonly used biocide in antifouling paints is cuprous oxide. In the EU, antifouling products are regulated under the Biocidal Products Regulation (BPR), which states that the recommended dose should be the minimum necessary to achieve the desired effect. For antifouling products, the dose is measured as the release rate of biocide(s) from coating. In this study, the release rates of copper and zinc from eight different coatings for leisure boats were determined through static exposure of coated panels in four different harbors located in Swedish waters along a salinity gradient ranging from 0 to 27 PSU. The results showed the release rate of copper to increase with increasing salinity. Paints with a higher content of cuprous oxide were also found to release larger amounts of copper. The coatings’ ability to prevent biofouling was also evaluated and no significant difference in efficacy between the eight tested products was observed at the brackish and marine sites. Hence, the products with high release rates of copper were equally efficient as those with 4 – 6 times lower releases. These findings suggest that current antifouling paints on the market are leaching copper in excess of the effective dose in brackish and marine waters. Additionally, the results from the freshwater site showed no benefit in applying a copper-containing paint for the purpose of fouling prevention. This indicates that the use of biocidal paints in freshwater bodies potentially results in an unnecessary release of copper. By reducing the release rates of copper from antifouling paints in marine waters and restricting the use of biocidal paints in freshwater, the load of copper to the environment could be substantially reduced
Density Encoding Enables Resource-Efficient Randomly Connected Neural Networks
The deployment of machine learning algorithms on resource-constrained edge
devices is an important challenge from both theoretical and applied points of
view. In this article, we focus on resource-efficient randomly connected neural
networks known as Random Vector Functional Link (RVFL) networks since their
simple design and extremely fast training time make them very attractive for
solving many applied classification tasks. We propose to represent input
features via the density-based encoding known in the area of stochastic
computing and use the operations of binding and bundling from the area of
hyperdimensional computing for obtaining the activations of the hidden neurons.
Using a collection of 121 real-world datasets from the UCI Machine Learning
Repository, we empirically show that the proposed approach demonstrates higher
average accuracy than the conventional RVFL. We also demonstrate that it is
possible to represent the readout matrix using only integers in a limited range
with minimal loss in the accuracy. In this case, the proposed approach operates
only on small n-bits integers, which results in a computationally efficient
architecture. Finally, through hardware FPGA implementations, we show that such
an approach consumes approximately eleven times less energy than that of the
conventional RVFL.Comment: 7 pages, 7 figure
Ultimate pH values and bacteriological condition of meat and stress metabolites in blood of transported reindeer bulls
Twenty-three reindeer bulls, aged 2-3 years, fed during two winter months at the Vuolda reindeer research station in Arjeplog, Sweden, were used in the study. The first group of eight reindeer was moved from their feeding corral to a selection corral, captured by lasso and stunned with a captive bolt outside the selection corral. The second group of seven reindeer was moved to the selection corral, captured by lasso and restrained, after which they were loaded onto a lorry- and transported for 1 hour and then slaughtered. The third group of eight reindeer was moved to the selection corral and herded directly onto the lorry, without any manual handling. They were transported for 5 h and then slaughtered. In both transport groups, four reindeer were fitted with pre-programmed automatic blood sampling equipment (ABSE). ABSE sampled blood at predetermined times via a jugular vein catheter. Ultimate pH-values in three muscles (Mm. longissimus, triceps brachii and biceps femoris) were significantly lower in the group carefully handled and transported for 5 h compared with the other two groups. The physiological mechanisms behind these results are discussed. Samples from M. semimembranosus were collected at slaughter and after 2, 6 and 10 days of refrigerated storage (+4 °C). The samples were analysed for total counts of aerobic bacteria (pour-plated in Tryptone Glucose Extract Agar, Difco, incubated at 20 °C and 30 °C, respectively for 72 h), coliform bacteria 37 °C (pour-plated in Violet Red Bile Agar, Oxoid, incubated at 37 °C for 24 h), Enterococci (surface-plated onto Slantez and Bartley Agar, Oxoid, incubated at 44 °C for 48 h) and Bacillus cereus (surface-plated onto Blood Agar Plates (Blood Agar Base, Difco, supplemented with 5% defibrinated horse blood) 30 °C for 24 h). All samples fell in the range 'fit for consumption'. At slaughter, there was no difference in ASAT activity, urea and Cortisol concentrations between the two transported groups. However, the plasma ASAT activity and urea concentrations at slaughter were significantly lower in the non-transported group. In both transport groups, the plasma Cortisol concentrations increased during loading onto and unloading from the lorry. Abomasal lesions were observed in all treatment groups. It was concluded that reindeer showed an acute stress response to manual handling and transport
Environmental risk assessment of using antifouling paints on pleasure crafts in European Union waters
The Authors To ensure sustainable use of antifouling paints, the European Union have developed a new environmental risk assessment tool, which a product must pass prior to its placement on the market. In this new tool, environmental concentrations are predicted based on estimated release rates of biocides to the aquatic environment and risk characterization ratios are calculated in regional spreadsheets. There are currently two methods in use to predict release rates of biocides; a calculation method and a laboratory method. These methods have been believed to overestimate environmental release of biocides and therefore fixed correction factors to reduce the release rate can be applied. An alternative method, known as the XRF method, has recently been developed and used to derive field release rates from antifouling paints. The aim of this study was to review the new environmental risk assessment tool and assess how the choice of release rate method and application of correction factors impact the approval of antifouling paint products. Eight coatings were environmentally risk assessed for usage in four European marine regions; Baltic, Baltic Transition, Atlantic and Mediterranean; by applying release rates of copper and zinc determined with the different methods. The results showed none of the coatings to pass the environmental risk assessment in the Baltic, Baltic Transition and the Mediterranean if field release rates were used. In contrast, most of the coatings passed if the correction factors were applied on the release rates obtained with the calculation or laboratory method. The results demonstrate the importance of release rate method choice on the outcome of antifouling product approval in EU. To reduce the impact of antifouling paints on the marine environment it is recommended that no correction factors should be allowed in the environmental risk assessment or preferably that site-specific field release rates are used. If the regulation in the European Union (and elsewhere) continues to allow correction factors, the pressure of biocides to the environment from leisure boating will result in degradation of marine ecosystems
- …