Turbulence measurements using the laser Doppler velocimeter

The photomultiplier signal representing the axial velocity of water within a glass pipe is examined. It is shown that with proper analysis of the photomultiplier signal, the turbulent information that can be obtained in liquid flows is equivalent to recent hot film studies. In shear flows the signal from the laser Doppler velocimeter contains additional information which may be related to the average shear

The electronic structure of pyrazine. Configuration interaction calculations using an extended basis

Extensive ab initio double zeta basis set configuration interaction calculations have been carried out on the nπ^∗ and ππ^∗ states of pyrazine as well as on the low‐lying n and π cations. The calculations corroborate the validity of the valence bond (VB) model for the interaction of lone pair excitations proposed earlier by Wadt and Goddard. Good agreement (errors of ∼0.2 eV) with experiment is obtained (except for the higher‐lying 1ππ∗ states that possess significant ionic character). The calculations indicate that the order of increasing ionization potentials is ^2A_g(n), 2B_(1g)(π), 2B_(1u)(n), and ^2B_(2g)(π). The forbidden 1 ^1B_(2g)(nπ^∗) state is predicted to be 1.30 eV above the allowed 1^ 1B_(3u)(nπ^∗) state. Finally, the calculations indicate that the adiabatic excitation energies to the 1^ 3B_1(nπ^∗) and 1^ 3A_1(ππ^∗) states in pyridine should be nearly degenerate at ∼3.6 eV

Towards Zeptosecond-Scale Pulses from X-Ray Free-Electron Lasers

The short wavelength and high peak power of the present generation of free-electron lasers (FELs) opens the possibility of ultra-short pulses even surpassing the present (tens to hundreds of attoseconds) capabilities of other light sources - but only if x-ray FELs can be made to generate pulses consisting of just a few optical cycles. For hard x-ray operation (~0.1nm), this corresponds to durations of approximately a single attosecond, and below into the zeptosecond scale. This talk will describe a novel method to generate trains of few-cycle pulses, at GW peak powers, from existing x-ray FEL facilities by using a relatively short 'afterburner'. Such pulses would enhance research opportunity in atomic dynamics and push capability towards the investigation of electronic-nuclear and nuclear dynamics. The corresponding multi-colour spectral output, with a bandwidth envelope increased by up to two orders of magnitudes over SASE, also has potential applications.Comment: Submitted to 35th International Free Electron Laser Conference, New York, 201

Advanced composite aileron for L-1011 transport aircraft: Aileron manufacture

The fabrication activities of the Advanced Composite Aileron (ACA) program are discussed. These activities included detail fabrication, manufacturing development, assembly, repair and quality assurance. Five ship sets of ailerons were manufactured. The detail fabrication effort of ribs, spar and covers was accomplished on male tools to a common cure cycle. Graphite epoxy tape and fabric and syntactic epoxy materials were utilized in the fabrication. The ribs and spar were net cured and required no post cure trim. Material inconsistencies resulted in manufacturing development of the front spar during the production effort. The assembly effort was accomplished in subassembly and assembly fixtures. The manual drilling system utilized a dagger type drill in a hydraulic feed control hand drill. Coupon testing for each detail was done

Distribution of E/N and N sub e in a cross-flow electric discharge laser

The spatial distribution of the ratio of electric field to neutral gas density on a flowing gas, multiple pin-to-plane discharge was measured in a high-power, closed loop laser. The laser was operated at a pressure of 140 torr (1:7:20, CO2, N2, He) with typically a 100 meter/second velocity in the 5 x 8 x 135 centimeter discharge volume. E/N ratios ranged from 2.7 x 10 to the minus 16th power to 1.4 x 10 to the minus 16th power volts/cu cm along the discharge while the electron density ranged from 2.8 x 10 to the 10th power to 1.2 x 10 to the 10th power cm/3

Small-signal gain diagnostic measurements in a flowing CO2 pin discharge laser

Small-signal gain diagnostic measurements were conducted on closed loop, high power, carbon dioxide laser to assess the coupling between gas flow velocity and resonator saturation. Parameters investigated included optical cavity and discharge power. Results of gain measurements within and downstream of the excitation volume are presented for a laser gas composition He:N2:CO2 of 10:7:1 at 90 torr. The gain at constant discharge power was observed to be dependent upon discharge power level and time. An important result of this study is that the effects of gain swept downstream of the discharge region must be considered in the resonator design if efficient extraction of stored optical energy is desired