7,037 research outputs found
Observation of enhanced optical spring damping in a macroscopic mechanical resonator and application for parametric instability control in advanced gravitational-wave detectors
We show that optical spring damping in an optomechanical resonator can be enhanced by injecting a phase delay in the laser frequency-locking servo to rotate the real and imaginary components of the optical spring constant. This enhances damping at the expense of optical rigidity. We demonstrate enhanced parametric damping which reduces the Q factor of a 0.1-kg-scale resonator from 1.3×10^5 to 6.5×10^3. By using this technique adequate optical spring damping can be obtained to damp parametric instability predicted for advanced laser interferometer gravitational-wave detectors
Electrically detected magnetic resonance using radio-frequency reflectometry
The authors demonstrate readout of electrically detected magnetic resonance
at radio frequencies by means of an LCR tank circuit. Applied to a silicon
field-effect transistor at milli-kelvin temperatures, this method shows a
25-fold increased signal-to-noise ratio of the conduction band electron spin
resonance and a higher operational bandwidth of > 300 kHz compared to the kHz
bandwidth of conventional readout techniques. This increase in temporal
resolution provides a method for future direct observations of spin dynamics in
the electrical device characteristics.Comment: 9 pages, 3 figure
Physiological responses at various lactate markers for running at 4 and 8 minute treadmill increments
We compared physiological responses corresponding to speeds at plasma lactate markers
between incrementa
l treadmill running of 4 and 8
min
stages in fifteen
healthy men (23 ± 4
yrs
, 1.78 ± 0.49 m, 72.7 ± 10.8 kg).Treadmill speed, oxygen uptake (
V
O
2
), heart rate (HR),
rating of perceived exertion (RPE) and plasma lactate were measured for each stage, and
calculated at: fixed blood lactate accumulation (FBLA) 4.0
mmol/L
, an initial 1
mmol/L
rise,
deviation maximum (D
max
), lactate t
hreshold (LT) and log
-
log LT.
There was no effect
(
p
>0.05) of stage duration on speed,
V
O
2
, HR
and RPE at fixed markers. For 8 min
stages,
speed was lower at modelled markers: D
max
(
-
1.1 km/
h;
p=
0.001), LT (
-
0.9
km/
h
;
p=0
.008)
and log
-
log LT (
-
0.8
km/h;
p=0
.006), yet RPE was higher and
V
O
2
lower for LT (1.1,
p=
0.02
;
-
0.27 L/
min,
p=
0.01
) and log
-
log LT (1.4,
p=
0.03
;
-
0.29
L/min
,
p=
0.002). Lactate and
V
O
2
were greater at 8
km/h
for 4 min
(
p=
0.000
1), then similar until 11
km/
h
, with a trend
towards elevated plasma lactate
for 4 min
thereafter.
When applying
lactate
threshold
markers to assess physiological responses to incremental running, protocols using prolonged
stage durations may underestimate
marker running spee
Eccentric double white dwarfs as LISA sources in globular clusters
We consider the formation of double white dwarfs (DWDs) through dynamical
interactions in globular clusters. Such interactions can give rise to eccentric
DWDs, in contrast to the exclusively circular population expected to form in
the Galactic disk. We show that for a 5-year Laser Interferometer Space Antenna
(LISA) mission and distances as far as the Large Magellanic Cloud, multiple
harmonics from eccentric DWDs can be detected at a signal-to-noise ratio higher
than 8 for at least a handful of eccentric DWDs, given their formation rate and
typical lifetimes estimated from current cluster simulations. Consequently the
association of eccentricity with stellar-mass LISA sources does not uniquely
involve neutron stars, as is usually assumed. Due to the difficulty of
detecting (eccentric) DWDs with present and planned electromagnetic
observatories, LISA could provide unique dynamical identifications of these
systems in globular clusters.Comment: Published in ApJ 665, L5
Forming simulation of a thermoplastic commingled woven textile on a double dome
This paper presents thermoforming experiments and FE simulations of a commingled glass-PP woven composite on a double dome geometry, with the aim of assessing the correspondence of predicted and experimental shear angles. Large local deformations - especially in-plane shear, i.e. relative rotation between the two yarn families – occur when draping a textile on a three dimensional part and eventually unwanted phenomena like wrinkling or tearing may occur. The macroscopic drape behaviour of a weave is generally subdivided into: 1) The high tensile resistance along the yarn directions, expressed as non-linear stress-strain curves, and 2) The shear resistance, expressed as non-linear shear force versus shear angle curves. The constitutive model is constituted of a dedicated non-orthogonal hypo-elastic shear resistance model, previously described in [1, 2], combined with truss elements that represent the high tensile resistance along the yarn directions. This model is implemented in a user subroutine of the ABAQUS explicit FE solver. The material parameters have been identified via textile biaxial tensile tests at room temperature and bias extension tests at 200°. Thermoforming experiments are performed on a rectangular blank with the warp direction along the second symmetry plane of the tool, with a preheating temperature of 200°C, a constant mold temperature of about 70°C, and a blankholder ring. It was concluded that the shear angles were fairly well predicted for this particular case study, which could be expected in view of the fact that no wrinkles had formed during the thermoforming experiment
Dynamics of Human Walking
The problem of biped locomotion at steady speeds is discussed through a
Lagrangian formulation developed for velocity-dependent, body driving forces.
Human walking on a level surface is analyzed in terms of the data on the
resultant ground-reaction force and the external work. It is shown that the
trajectory of the center of mass is due to a superposition of its rectilinear
motion with a given speed and a backward rotation along a shortened
hypocycloid. A stiff-to-compliant crossover between walking gaits is described
and the maximum speed for human walking, given by an instability of the
trajectory, is predicted.
Key words: locomotion, integrative biology, muscles, bipedalism, human
walking, biomechanics.Comment: 9 pages, 4 figure
- …